Based on the experience gained during the four and a half years of the mission, the Fermi -LAT collaboration has undertaken a comprehensive revision of the event-level analysis going under the name of Pass 8. Although it is not yet finalized, we can test the improvements in the new event reconstruction with the special case of the prompt phase of bright Gamma-Ray Bursts (GRBs), where the signal to noise ratio is large enough that loose selection cuts are sufficient to identify gamma- rays associated with the source. Using the new event reconstruction, we have re-analyzed ten GRBs previously detected by the LAT for which an x-ray/optical follow-up was possible and found four new gamma rays with energies greater than 10 GeV in addition to the seven previously known. Among these four is a 27.4 GeV gamma-ray from GRB 080916C, which has a redshift of 4.35, thus making it the gamma ray with the highest intrinsic energy (147 GeV) detected from a GRB. We present here the salient aspects of the new event reconstruction and discuss the scientific implications of these new high-energy gamma rays, such as constraining extragalactic background light models, Lorentz invariance violation (LIV) tests, the prompt emission mechanism and the bulk Lorentz factor of the emitting region.

The event selection developed for the Fermi Large Area Telescope before launch has been periodically updated to reflect the constantly improving knowledge of the detector and the environment in which it operates. Pass 7, released to the public in August 2011, represents the most recent major iteration of this incremental process. In parallel, the LAT team has undertaken a coherent long-term effort aimed at a radical revision of the entire event-level analysis, based on the experience gained in the prime phase of the mission. This includes virtually every aspect of the data reduction process, from the simulation of the detector to the event reconstruction and the background rejection. The potential improvements include (but are not limited to) a significant reduction in background contamination coupled with an increased effective area, a better point-spread function, a better understanding of the systematic uncertainties and an extension of the energy reach for the photon analysis below 100 MeV and above a few hundred GeV. We present an overview of the work that has been done or is ongoing and the prospects for the near future.

The Fermi Large Area Telescope (LAT) consists of 16 towers, each incorporating a tracker made up of a stack of 18 pairs of orthogonal silicon strip detectors (SSDs), interspersed with tungsten converter foils. The strip numbers of the struck strips in each SSD plane are collected by two read controllers (RCs), one at each end, and nine RCs are connected by one of eight cables to a cable controller (CC). The tracker readout electronics limit the number of strips that can be read out. Although each RC can store up to 64 hits, a CC can store maximum of only 128 hits. To insure that the photon shower development and backsplash in the lower layers of the tracker don't compromise the readout of the upper layers, we artificially limit the number of strips read out into each RC to 14, so that no CC can ever can see more than 126 hit strips. In this contribution, we explore other configurations that will allow for a more complete readout of large events, and investigate some of the consequences of using these configurations.

The pre-launch event simulation and reconstruction performed beyond our expectations for real data, essentially without modification, and made possible the immediate start of science analysis. But the on-orbit data exhibit unanticipated features that necessitate upgrades to both the simulation (essentially complete) and the reconstruction (ongoing). The major new effect encountered on orbit is the presence of "ghosts," that is, remnant detector response to particles passing through the detector before the particle that triggered the event. These ghosts appear primarily in the form of extra tracks and/or energy deposits. As part of this upgrade, we plan to enhance our ability to discriminate against background particles by introducing additional analysis during the reconstruction phase. We present a description of the effect of ghosts, and of the work needed to deal with them, done and planned, as well as some other ideas for improving the reconstruction.

This paper presents the simulation of the GLAST high energy gamma-ray telescope. The simulation package, written in C++, is based on the Geant4 toolkit, and it is integrated into a general framework used to process events. A detailed simulation of the electronic signals inside Silicon detectors has been provided and it is used for the particle tracking, which is handled by a dedicated software. A unique repository for the geometrical description of the detector has been realized using the XML language and a C++ library to access this information has been designed and implemented.

The GLAST Balloon Flight Engineering Model (BFEM) represents one of 16 towers that constitute the Large Area Telescope (LAT), a high-energy (>20 MeV) gamma-ray pair-production telescope being built by an international partnership of astrophysicists and particle physicists for a satellite launch in 2006. The prototype tower consists of a Pb/Si pair-conversion tracker (TKR), a CsI hodoscopic calorimeter (CAL), an anti-coincidence detector (ACD) and an autonomous data acquisition system (DAQ). The self-triggering capabilities and performance of the detector elements have been previously characterized using positron, photon and hadron beams. External target scintillators were placed above the instrument to act as sources of hadronic showers. This paper provides a comprehensive description of the BFEM data-reduction process, from receipt of the flight data from telemetry through event reconstruction and background rejection cuts. The goals of the ground analysis presented here are to verify the functioning of the instrument and to validate the reconstruction software and the background-rejection scheme.