We describe the design and performance of the digital servo and motion control system for the 6-meter diameter parabolic antennas of the Submillimeter Array (SMA) on Mauna Kea, Hawaii. The system is divided into three nested layers operating at a different, appropriate bandwidth. (1) A rack-mounted, real-time Unix system runs the position loop which reads the high resolution azimuth and elevation encoders and sends velocity and acceleration commands at 100 Hz to a custom-designed servo control board (SCB). (2) The microcontroller-based SCB reads the motor axis tachometers and implements the velocity loop by sending torque commands to the motor amplifiers at 558 Hz. (3) The motor amplifiers implement the torque loop by monitoring and sending current to the three-phase brushless drive motors at 20 kHz. The velocity loop uses a traditional proportional-integral-derivative (PID) control algorithm, while the position loop uses only a proportional term and implements a command shaper based on the Gauss error function. Calibration factors and software filters are applied to the tachometer feedback prior to the application of the servo gains in the torque computations. All of these parameters are remotely adjustable in software. The three layers of the control system monitor each other and are capable of shutting down the system safely if a failure or anomaly occurs. The Unix system continuously relays antenna status to the central observatory computer via reflective memory. In each antenna, a Palm Vx hand controller displays system status and allows full local control of the drives in an intuitive touchscreen user interface. It can also be connected outside the cabin for convenience during antenna reconfigurations. Excellent tracking performance (0.3 arcsec rms) is achieved with this system. It has been in reliable operation on 8 antennas for over 10 years and has required minimal maintenance.

The Submillimeter Array (SMA), a collaboration between the Smithsonian Astrophysical Observatory and the Academica Sinica Institute for Astronomy and Astrophysics of Taiwan, is an eight-element radio-interferometer designed to operate throughout the major atmospheric windows from about 180 to 900 GHz. In an effort to mitigate the effects of atmospheric instabilities which limit the phase coherence of the array especially in the higher frequency bands, the array was designed to allow simultaneous operation of a low frequency receiver (<350 GHz) with a high frequency receiver (>330 GHz). The overlap region of 330-350 GHz was included to facilitate dual polarization measurements in the frequency range considered to offer the highest sensitivity for continuum observations with the array. So far, the array is equipped with working SIS receivers covering the frequency ranges 176-256 GHz, 260-350 GHz, and 600-700 GHz, and single frequency operation has been routine in the lower two frequency bands for the past year. More recently, with the completion of IF hardware required to make full use of the SMA cross-correlator, dual receiver operation became possible. We have since made a number of Galactic and extra-galactic astronomical observations in dual-band mode with the hopes of using the 230 GHz receiver as a phase reference to enable improved interferometry in the 650 GHz band. We will present the current antenna and receiver performance, some of the first interferometric images in the 650 GHz receiver band, and our initial attempts at phase transfer.