After launching and deploying a sparse space telescope, fine tuning is required to correct for inaccurate initial placement of its elements. We selected unique shapes and locations of these telescope aperture segments, to be able to distinguish between their diffraction patterns, while at the same time having a proper spatial frequency coverage. Then we improved the combined wave front, without measuring it directly: First we correlated each segment's focal image with its distinctive template, to correct its tilt. Next we interfered them with the other segments, pair by pair, using their limited coherence, to locate their mutual optical path differences. Finally, we optimized the combined focal image for fine alignment.

Evidence of exoplanets with orbits that are misaligned with the spin of the host star may suggest that not all bound planets were born in the protoplanetary disk of their current planetary system. Observations have shown that free-floating Jupiter-mass objects can exceed the number of stars in our galaxy, implying that capture scenarios may not be so rare. To address this issue, we construct a three-dimensional simulation of a three-body scattering between a free-floating planet and a star accompanied by a Jupiter-mass bound planet. We distinguish between three different possible scattering outcomes, where the free-floating planet may get captured after the interaction with the binary, remain unbound, or "kick-out" the bound planet and replace it. The simulation was performed for different masses of the free-floating planets and stars, as well as different impact parameters, inclination angles and approach velocities. The outcome statistics are used to construct an analytical approximation of the cross section for capturing a free-floating planet by fitting their dependence on the tested variables. The analytically approximated cross section is used to predict the capture rate for these kinds of objects, and to estimate that about 1\% of all stars are expected to experience a temporary capture of a free-floating planet during their lifetime. Finally, we propose additional physical processes that may increase the capture statistics and whose contribution should be considered in future simulations.

In a previous article we suggested a method to overcome the diffraction limit behind a telescope. We refer to theory and recent numerical simulations, and test whether it is indeed possible to use photon amplification to enhance the angular resolution of a telescope or a microscope beyond the diffraction limit. An essential addition is the proposal to select events with above-average ratio of stimulated to spontaneous photons. We find that the diffraction limit of a telescope is surpassed by a factor ten for an amplifier gain of 200, if the analysis is restricted to a tenth of the incoming astronomical photons. A gain of 70 is sufficient with a hundredth of the photons.

An Earth-like extra-solar planet emits light which is many orders of magnitude fainter than that of the parent star. We propose a method of identifying bio-signature spectral lines in light from known extra-solar planets based on Fourier spectroscopy in the infra-red, using an off-center part of a Fourier interferogram only. This results in superior sensitivity to narrower molecular-type spectral bands, which are expected in the planet spectrum but are absent in the parent star. We support this idea by numerical simulations which include photon and thermal noise, and show it to be feasible at a luminosity ratio of 10^-6 for a Sun-like parent star in the infra-red. We also carried out a laboratory experiment to illustrate the method. The results suggest that this method should be applicable to real planet searches.

Exoplanets whose orbit is misaligned with the spin of their host star could have originated from high-speed gas blobs, which are observed in multitudes in nearby supernova remnants and planetary nebulae. These blobs grow in mass and slow down in the interstellar medium (ISM) by mass accretion and cool by radiation. If their mass exceeds the Jeans mass, they collapse into hot giant gas planets. Most of the 'missing baryons' in galaxies could have been swept into such free-floating objects, which could perturb stellar planetary systems, kick bound planets into misaligned orbits or be captured themselves into misaligned orbits. The uncollapsed ones can then collapse or be tidally disrupted into a tilted gas disk where formation of misaligned planets can take place. Giant gas planets free floating in the Galactic ISM may be detected by their microlensing effects or by deep photometry if they are hot. The uncollapsed gas blobs may produce the observed radio scintillations of comact extragalactic radio sources such as quasars and gamma ray bursts.

Experiments are in progress to prepare for intensity interferometry with arrays of air Cherenkov telescopes. At the Bonneville Seabase site, near Salt Lake City, a testbed observatory has been set up with two 3-m air Cherenkov telescopes on a 23-m baseline. Cameras are being constructed, with control electronics for either off- or online analysis of the data. At the Lund Observatory (Sweden), in Technion (Israel) and at the University of Utah (USA), laboratory intensity interferometers simulating stellar observations have been set up and experiments are in progress, using various analog and digital correlators, reaching 1.4 ns time resolution, to analyze signals from pairs of laboratory telescopes.

The imminent availability of large arrays of large light collectors deployed to exploit atmospheric Cherenkov radiation for gamma-ray astronomy at more than 100GeV, motivates the growing interest in application of intensity interferometry in astronomy. Indeed, planned arrays numbering up to one hundred telescopes will offer close to 5,000 baselines, ranging from less than 50m to more than 1000m. Recent and continuing signal processing technology developments reinforce this interest. Revisiting Stellar Intensity Interferometry for imaging is well motivated scientifically. It will fill the short wavelength (B/V bands) and high angular resolution (< 0.1mas) gap left open by amplitude interferometers. It would also constitute a first and important step toward exploiting quantum optics for astronomical observations, thus leading the way for future observatories. In this paper we outline science cases, technical approaches and schedule for an intensity interferometer to be constructed and operated in the visible using gamma-ray astronomy Air Cherenkov Telescopes as receivers.

The space-time correlations of streams of photons can provide fundamentally new channels of information about the Universe. Today's astronomical observations essentially measure certain amplitude coherence functions produced by a source. The spatial correlations of wave fields has traditionally been exploited in Michelson-style amplitude interferometry. However the technology of the past was largely incapable of fine timing resolution and recording multiple beams. When time and space correlations are combined it is possible to achieve spectacular measurements that are impossible by any other means. Stellar intensity interferometry is ripe for development and is one of the few unexploited mechanisms to obtain potentially revolutionary new information in astronomy. As we discuss below, the modern use of stellar intensity interferometry can yield unprecedented measures of stellar diameters, binary stars, distance measures including Cepheids, rapidly rotating stars, pulsating stars, and short-time scale fluctuations that have never been measured before.

Imaging of planets is very difficult, due to the glare from their nearby, much brighter suns. Static and slowly-evolving aberrations are the limiting factors, even after application of adaptive optics. The residual speckle pattern is highly symmetrical due to diffraction from the telescope's aperture. We suggest to break this symmetry and thus to locate planets hidden beneath it. An eccentric pupil mask is rotated to modulate the residual light pattern not removed by other means. This modulation is then exploited to reveal the planet's constant signal. In well-corrected ground-based observations we can reach planets six stellar magnitudes fainter than their sun, and only 2-3 times the diffraction limit from it. At ten times the diffraction limit, we detect planets 16 magnitudes fainter. The stellar background drops by five magnitudes.

In stellar interferometry, image quality improves significantly with the inclusion of more telescopes and the use of phase closure. We demonstrate, using first coherent and then partially coherent white light, a compact and efficient pair-wise combination of twelve or more beams. The input beams are lined up and spread through a cylindrical lens into a comb of parallel ellipses, which interferes with a perpendicular copy of itself to form a matrix of interferograms between all pairs. The diagonal elements show interference of each beam with itself, for in-tensity calibration. The measured white-light visibilities were high and stable.

Intensity interferometry removes the stringent requirements on mechanical precision and atmospheric corrections that plague all amplitude interferometry techniques at the cost of severely limited sensitivity. A new idea we recently introduced, very high redundancy, alleviates this problem. It enables the relatively simple construction (~1cm mechanical precision) of a ground-based astronomical facility able to transform a two-dimensional field of point-like sources to a three-dimensional distribution of micro-arcsec resolved systems, each imaged in several optical bands. Each system will also have its high resolution residual timing, high quality (inside each band) spectra and light curve, emergent flux, effective temperature, polarization effects and perhaps some thermodynamic properties, all directly measured. All the above attributes can be measured in a single observation run of such a dedicated facility. We conclude that after three decades of abandonment optical intensity interferometry deserves another review, also as a ground-based alternative to the science goals of space interferometers.

Stellar amplitude interferometry is limited by the need to have optical distances fixed and known to a fraction of the wavelength. We suggest reviving intensity interferometry, which requires hardware which is many orders of magnitude less accurate, at the cost of more limited sensitivity. We present an algorithm to use the very high redundancy of a uniform linear array to increase the sensitivity of the instrument by more than a hundredfold. When using an array of 100 elements, each almost 100m in diameter, and conservative technological improvements, we can achieve a limiting magnitude of about mb=14.4. Digitization, storage, and off-line processing of all the data will also enable interferometric image reconstruction from a single observation run, and application of various algorithms at any later time. Coronagraphy, selectively suppressing only the large scale structure of the source, can be achieved by specific aperture shapes. We conclude that after three decades of abandonment optical intensity interferometry deserves another review.

The World Space Observatory is an unconventional space project proceeding via distributed studies. The present design, verified for feasibilty, consists of a 1.7-meter telescope operating at the second Largangian point of the Earth-Sun system. The focal plane instruments consist of three UV spectrometers covering the spectral band from Lyman alpha to the atmospheric cutoff with R~55,000 and offering long-slit capability over the same band with R~1,000. In addition, a number of UV and optical imagers view adjacent fields to that sampled by the spectrometers. Their performance compares well with that of HST/ACS and the spectral capabilities of WSO rival those of HST/COS.