The nanoflare-heating theory predicts steady hot plasma emission in the non-flaring active regions. It is hard to find this emission with conventional non-monochromatic imagers (such as Atmospheric Imaging Assembly or X-Ray Telescope), because their images contain a cool temperature background. In this work, we search for hot plasma in non-flaring active regions using the Mg XII spectroheliograph onboard Complex Orbital Observations Near-Earth of Activity on the Sun (CORONAS)-F/SPectroheliographIc X-ray Imaging Telescope (SPIRIT). This instrument acquired monochromatic images of the solar corona in the Mg XII 8.42 \AA line, which emits only at temperatures higher than 4 MK. The Mg XII images contain the signal only from hot plasma without any low-temperature background. We studied the hot plasma in active regions using the SPIRIT data from 18-28 February 2002. During this period, the Mg XII spectroheliograph worked with a 105-second cadence almost without data gaps. The hot plasma was observed only in the flaring active regions. We do not observe any hot plasma in non-flaring active regions. The hot plasma column emission measure in the non-flaring active region should not exceed $3 \times 10^{24}$ cm$^{-5}$. The hot Differential Emission Measure (DEM) is less than 0.01 % of the DEM of the main temperature component. Absence of Mg XII emission in the non-flaring active regions can be explained by weak and frequent nanoflares (delay less than 500 seconds) or by very short and intense nanoflares that lead to non-equilibrium ionization.

We study the coronal mass ejection (CME) with a complex acceleration profile. The event occurred on April 23, 2009. It had an impulsive acceleration phase, an impulsive deceleration phase, and a second impulsive acceleration phase. During its evolution, the CME showed signatures of different acceleration mechanisms: kink instability, prominence drainage, flare reconnection, and a CME-CME collision. The special feature of the observations is the usage of the TESIS EUV telescope. The instrument could image the solar corona in the Fe 171 \AA\ line up to a distance of 2 $R_\odot$ from the center of the Sun. This allows us to trace the CME up to the LASCO/C2 field of view without losing the CME from sight. The onset of the CME was caused by kink instability. The mass drainage occurred after the kink instability. The mass drainage played only an auxiliary role: it decreased the CME mass, which helped to accelerate the CME. The first impulsive acceleration phase was caused by the flare reconnection. We observed the two ribbon flare and an increase of the soft X-ray flux during the first impulsive acceleration phase. The impulsive deceleration and the second impulsive acceleration phases were caused by the CME-CME collision. The studied event shows that CMEs are complex phenomena that cannot be explained with only one acceleration mechanism. We should seek a combination of different mechanisms that accelerate CMEs at different stages of their evolution.

We analyse nonlinear evolution of torsional Alfv\'en waves in a straight magnetic flux tube filled in with a low-$\beta$ plasma, and surrounded with a plasma of lower density. Such magnetic tubes model, in particular, a segment of a coronal loop or a polar plume. The wavelength is taken comparable to the tube radius. We perform numerical simulation of the wave propagation using ideal magnetohydrodynamics. We find that a torsional wave nonlinearly induces three kinds of compressive flows: the parallel flow at the Alfv\'en speed, that constitutes a bulk plasma motion along the magnetic field, the tube wave, and also transverse flows in the radial direction, associated with sausage fast magnetoacoustic modes. In addition, nonlinear torsional wave steepens and its propagation speed increases. The latter effect leads to the progressive distortion of torsional wave front, i.e. nonlinear phase mixing. Because of the intrinsic non-uniformity of the torsional wave amplitude across the tube radius, the nonlinear effects are more pronounced in regions with higher wave amplitude. They are always absent at the axes of the flux tube. In the case of a linear radial profile of the wave amplitude, the nonlinear effects are localised in an annulus region near the tube boundary. Thus, the parallel compressive flows driven by torsional Alfv\'en waves in the solar and stellar coronae, are essentially non-uniform in the perpendicular direction. The presence of additional sinks for the wave energy reduces the efficiency of the nonlinear parallel cascade in torsional Alfv\'en waves.

We use the TESIS EUV telescope to study the current sheet signatures observed during flux rope eruption. The special feature of the TESIS telescope was its ability to image the solar corona up to a distance of 2 $R_\odot$ from the Sun's center in the Fe 171 \AA\ line. The Fe 171 \AA\ line emission illuminates the magnetic field lines, and the TESIS images reveal the coronal magnetic structure at high altitudes. The analyzed CME had a core with a spiral-flux rope-structure. The spiral shape indicates that the flux rope radius varied along its length. The flux rope had a complex temperature structure: cold legs (70 000 K, observed in He 304 \AA\ line) and a hotter core (0.7 MK, observed in Fe 171 \AA\ line). Such structure contradicts the common assumption that the CME core is a cold prominence. When the CME impulsively accelerated, a dark double Y-structure appeared below the flux rope. The Y-structure timing, location, and morphology agree with the previously performed MHD simulations of the current sheet. We interpreted the Y-structure as a hot envelope of the current sheet and hot reconnection outflows. The Y-structure had a thickness 6.0 Mm. Its length increased over time from 79 Mm to more than 411 Mm.

We present experimental evidence of the coronal mass ejection (CME) breakout reconnection, observed by the TESIS EUV telescope. The telescope could observe solar corona up to 2 $R_\odot$ from the Sun center in the Fe 171 \AA\ line. Starting from 2009 April 8 TESIS, observed an active region (AR) that had a quadrupolar structure with an X-point 0.5 $R_\odot$ above photosphere. A reconstructed from the MDI data magnetic field also has a multipolar structure with an X-point above the AR. At 21:45 UT on April 9, the loops near the X-point started to move away from each other with a velocity of $\approx$ 7 km s$^{-1}$. At 01:15 UT on April 10, a bright stripe appeared between the loops, and the flux in the GOES 0.5-4 \AA\ channel increased. We interpret the loops' sideways motion and the bright stripe as evidence of the breakout reconnection. At 01:45 UT, the loops below the X-point started to slowly move up. At 15:10 UT, the CME started to accelerate impulsively, while at the same time a flare arcade formed below the CME. After 15:50 UT, the CME moved with constant velocity. The CME evolution precisely followed the breakout model scenario.

We present detailed EUV spectra of 4 large solar flares: M5.6, X1.3, X3.4, and X17 classes in the spectral ranges 176-207 \AA\ and 280-330 \AA. These spectra were obtained {by the slitless} spectroheliograph SPIRIT aboard the CORONAS-F satellite. To our knowledge these are the first detailed EUV spectra of large flares obtained with spectral resolution of $\sim 0.1$ \AA. We performed a comprehensive analysis of the obtained spectra and provide identification of the observed spectral lines. The identification was performed based {on the calculation} of synthetic spectra (CHIANTI database was used), with simultaneous {calculations of DEM} and density of the emitting plasma. More than 50 intense lines are present in the spectra that correspond to a temperature range of $T=0.5-16$ MK; most of the lines belong to Fe, Ni, Ca, Mg, Si ions. In all the considered flares intense hot lines from Ca XVII, Ca XVIII, Fe XX, Fe XXII, and Fe XXIV are observed. The calculated DEMs have a peak at $T \sim 10$ MK. The densities were determined using Fe XI - Fe XIII lines and averaged $6.5 \times 10^9$ cm$^{-3}$. We also discuss the identification, accuracy and major discrepancies of the spectral line intensity prediction.

We present observations of hot arcades made with the Mg XII spectroheliograph onboard the CORONAS-F mission, which provides monochromatic images of hot plasma in the Mg XII 8.42 A resonance line. The arcades were observed to form above the polarity inversion line between Active Regions NOAA 09847 and 09848 at four successive episodes: at 09:18, 14:13, and 22:28 UT on 28 February 2002, and at 00:40 UT on 1 March 2002. The arcades all evolved in the same way: a) a small flare (precursor) appeared near the edge of the still invisible arcade, b) the arcade brightened in a wave-like manner - closer loops brightened earlier, and c) the arcade intensity gradually decreased in $\approx$ 1 h. The estimated wave speed was $\approx$ 700 km s$^{-1}$, and the distance between the hot loops was $\approx$ 50 Mm. The arcades formed without visible changes in their magnetic structure. The arcades were probably heated up by the instabilities of the current sheet above the arcade, which were caused by an MHD wave excited by the precursor.

We present the results of the observations of a coronal mass ejection (CME), which occurred on May 13, 2009. The most important feature of these observations is that the CME was observed from the very early stage (the solar surface) up to a distance of 15 solar radii ($R_\odot$). Below 2 $R_\odot$, we used the data from the TESIS EUV telescopes obtained in the Fe 171 A and He 304 A lines, and above 2 $R_\odot$, we used the observations of the LASCO C2 and C3 coronagraphs. The CME was formed at a distance of 0.2-0.5 $R_\odot$from the Sun's surface as a U-shaped structure, which was observed both in the 171 A images and in white-light. Observations in the He 304 A line showed that the CME was associated with an erupting prominence, which was located not above-as predicts the standard model-but in the lowest part of the U-shaped structure close to the magnetic X-point. The prominence location can be explained with the CME breakout model. Estimates showed that CME mass increased with time. The CME trajectory was curved-its helio-latitude decreased with time. The CME started at latitude of 50$^{\circ}$ and reached the ecliptic plane at distances of 2.5 $R_\odot$. The CME kinematics can be divided into three phases: initial acceleration, main acceleration, and propagation with constant velocity. After the CME onset GOES registered a sub-A-class flare.

Observations in the Mg XII 8.42 AA line onboard the CORONAS-F satellite have revealed compact high temperature objects-hot X-ray points (HXP)-and their major physical parameters were investigated. Time dependencies of temperature, emission measure, intensity, and electron density were measured for 169 HXPs. HXP can be divided into two groups by their temperature variations: those with gradually decreasing temperature and those with rapidly decreasing temperature. HXPs plasma temperatures lie in the range of 5-40 MK, the emission measure is $10^{45}$- $10^{48}$ cm$^{-3}$, and the electron density is above $10^{10}$ cm$^{-3}$, which exceeds the electron density in the quiet Sun ($10^8$-$10^9$ cm$^{-3}$). HXPs lifetimes vary between 5-100 minutes, significantly longer than the conductive cooling time. This means that throughout a HXP's lifetime, the energy release process continues, which helps to maintain its high temperature. A HXP's thermal energy is not greater than $10^{28}$ erg, and the total energy, which is released in HXPs, does not exceed $10^{30}$ erg. HXPs differ in their physical properties from other flare-like microevents, such as microflares, X-ray bright points, and nanoflares.