A new 1.4 GHz 19-element, dual-polarization, cryogenic phased array feed (PAF) radio astronomy receiver has been developed for the Robert C. Byrd Green Bank Telescope (GBT) as part of FLAG (Focal L-band Array for the GBT) project. Commissioning observations of calibrator radio sources show that this receiver has the lowest reported beamformed system temperature ($T_{\rm sys}$) normalized by aperture efficiency ($\eta$) of any phased array receiver to date. The measured $T_{\rm sys}/\eta$ is $25.4 \pm 2.5$ K near 1350 MHz for the boresight beam, which is comparable to the performance of the current 1.4 GHz cryogenic single feed receiver on the GBT. The degradation in $T_{\rm sys}/\eta$ at $\sim$ 4 arcmin (required for Nyquist sampling) and $\sim$ 8 arcmin offsets from the boresight is, respectively, $\sim$ 1\% and $\sim$ 20\% of the boresight value. The survey speed of the PAF with seven formed beams is larger by a factor between 2.1 and 7 compared to a single beam system depending on the observing application. The measured performance, both in frequency and offset from boresight, qualitatively agree with predictions from a rigorous electromagnetic model of the PAF. The astronomical utility of the receiver is demonstrated by observations of the pulsar B0329+54 and an extended HII region, the Rosette Nebula. The enhanced survey speed with the new PAF receiver will enable the GBT to carry out exciting new science, such as more efficient observations of diffuse, extended neutral hydrogen emission from galactic in-flows and searches for Fast Radio Bursts.

In this paper, we describe the development of a new L-band (1.4 GHz) Cryogenic Phased Array Feed (PAF) system, referred to as the GBT2 array. Results from initial measurements made with the GBT2 array are also presented. The PAF was developed for the Green Bank Telescope (GBT) as part of the Focal L-band Array for the GBT (FLAG) project. During the first stage of the development work (Phase I), a prototype cryogenic 19 element dual-polarized array with "Kite" dipole elements was developed and tested on the GBT. The measured system temperature over efficiency ($T_{sys}/\eta$) ratio for the bore sight beam of the Kite array was 45.5 K at 1.55 GHz. The off-boresight $T_{sys}/\eta$ shows an increase by 13 K at an offset equal to the half power beam width (7$^{'}$.2 at 1.7 GHz). Our measurements indicate that the off-boresight degradation and field-of-view (FoV) limitation of the Kite array is simply due to the fixed array size. To increase the FoV, a new 19-element GBT2 array with larger array spacing was developed during FLAG Phase II. The frequency response of the array was optimized from 1.2 to 1.6 GHz. A system with larger cryostat, new low noise amplifiers (LNAs), down-conversion and digitization close to the front end, unformatted digital transmission over fiber, ROACH II based polyphase filter banks (PFBs) with bandwidth 150 MHz and a data acquisition system that records voltage samples from one of the PFB channels were all developed. The data presented here is processed off-line. The receiver temperature measured with the new system is 17 K at 1.4 GHz, an improvement $>$ 8 K over the previous Kite array. Measurements with the GBT2 array on the telescope are in progress. A real time 150 MHz beamformer is also being developed as part of an NSF-funded collaboration between NRAO/GBO/BYU \& West Virginia University (Beamformer Project) to support science observations.

Phased Array Feed (PAF) technology is the next major advancement in radio astronomy in terms of combining high sensitivity and large field of view. The Focal L-band Array for the Green Bank Telescope (FLAG) is one of the most sensitive PAFs developed so far. It consists of 19 dual-polarization elements mounted on a prime focus dewar resulting in seven beams on the sky. Its unprecedented system temperature of$\sim$17 K will lead to a 3 fold increase in pulsar survey speeds as compared to contemporary single pixel feeds. Early science observations were conducted in a recently concluded commissioning phase of the FLAG where we clearly demonstrated its science capabilities. We observed a selection of normal and millisecond pulsars and detected giant pulses from PSR B1937+21.

The Breakthrough Listen Initiative is undertaking a comprehensive search for radio and optical signatures from extraterrestrial civilizations. An integral component of the project is the design and implementation of wide-bandwidth data recorder and signal processing systems. The capabilities of these systems, particularly at radio frequencies, directly determine survey speed; further, given a fixed observing time and spectral coverage, they determine sensitivity as well. Here, we detail the Breakthrough Listen wide-bandwidth data recording system deployed at the 100-m aperture Robert C. Byrd Green Bank Telescope. The system digitizes up to 6 GHz of bandwidth at 8 bits for both polarizations, storing the resultant 24 GB/s of data to disk. This system is among the highest data rate baseband recording systems in use in radio astronomy. A future system expansion will double recording capacity, to achieve a total Nyquist bandwidth of 12 GHz in two polarizations. In this paper, we present details of the system architecture, along with salient configuration and disk-write optimizations used to achieve high-throughput data capture on commodity compute servers and consumer-class hard disk drives.

The Collaboration for Astronomy Signal Processing and Electronics Research (CASPER) has been working for a decade to reduce the time and cost of designing, building and deploying new digital radio-astronomy instruments. Today, CASPER open-source technology powers over 45 scientific instruments worldwide, and is used by scientists and engineers at dozens of academic institutions. In this paper we catalog the current offerings of the CASPER collaboration, and instruments past and present built by CASPER users and developers. We describe the ongoing state of software development, as CASPER looks to support a broader range of programming environments and hardware and ensure compatibility with the latest vendor tools.

A new spectrometer for the Green Bank Telescope (GBT) is being built jointly by the NRAO and the CASPER, University of California, Berkeley. The spectrometer uses 8 bit ADCs and will be capable of processing up to 1.25 GHz bandwidth from 8 dual polarized beams. This mode will be used to process data from focal plane arrays. The spectrometer supports observing mode with 8 tunable digital sub-bands within the 1.25 GHz bandwidth. The spectrometer can also be configured to process a bandwidth of up to 10 GHz with 64 tunable sub-bands from a dual polarized beam. The vastly enhanced backend capabilities will support several new science projects with the GBT.

We describe the successful design, implementation, and operation of a 12 GHz holography system installed on the Robert C. Byrd Green Bank Telescope (GBT). We have used a geostationary satellite beacon to construct high-resolution holographic images of the telescope mirror surface irregularities. These images have allowed us to infer and apply improved position offsets for the 2209 actuators which control the active surface of the primary mirror, thereby achieving a dramatic reduction in the total surface error (from 390 microns to ~240 microns, rms). We have also performed manual adjustments of the corner offsets for a few panels. The expected improvement in the radiometric aperture efficiency has been rigorously modeled and confirmed at 43 GHz and 90 GHz. The improvement in the telescope beam pattern has also been measured at 11.7 GHz with greater than 60 dB of dynamic range. Symmetric features in the beam pattern have emerged which are consistent with a repetitive pattern in the aperture due to systematic panel distortions. By computing average images for each tier of panels from the holography images, we confirm that the magnitude and direction of the panel distortions, in response to the combination of gravity and thermal gradients, are in general agreement with finite-element model predictions. The holography system is now fully integrated into the GBT control system, and by enabling the telescope staff to monitor the health of the individual actuators, it continues to be an essential tool to support high-frequency observations.

Wind-induced pointing errors are a serious concern for large-aperture high-frequency radio telescopes. In this paper, we describe the implementation of an optical quadrant detector instrument that can detect and provide a correction signal for wind-induced pointing errors on the 100m diameter Green Bank Telescope (GBT). The instrument was calibrated using a combination of astronomical measurements and metrology. We find that the main wind-induced pointing errors on time scales of minutes are caused by the feedarm being blown along the direction of the wind vector. We also find that wind-induced structural excitation is virtually non-existent. We have implemented offline software to apply pointing corrections to the data from imaging instruments such as the MUSTANG 3.3 mm bolometer array, which can recover ~70% of sensitivity lost due to wind-induced pointing errors. We have also performed preliminary tests that show great promise for correcting these pointing errors in real-time using the telescope's subreflector servo system in combination with the quadrant detector signal.

We reconsider the description of a solar eclipse in the Coptic ostracon in the Egyptian museum, Turin, confirming its identification with the solar eclipse of 10 march 601. This provides one of very few fixed dates in Coptic chronology. We comment on the rarity of such descriptions.