Normalized to: Ranchon, S.
[1]
oai:arXiv.org:0810.1137 [pdf] - 17161
Ionization Quenching Factor Measurement of Helium 4
Submitted: 2008-10-07
The ionization quenching factor (IQF) is defined as the fraction of energy
released by a recoil in a medium through ionization compared with its total
kinetic energy. At low energies, in the range of a few keV, the ionization
produced in a medium falls rapidly and systematic measurements are needed. We
report measurements carried out at such low energies as a function of the
pressure in He4 at 350, 700, 1000 and 1300 mbar. In order to produce a nucleus
moving with a controlled energy in the detection volume, we have developed an
Electron Cyclotron Resonance Ion Source (ECRIS) coupled to an ionization
chamber by a differential pumping. The quenching factor of He4 has been
measured for the first time down to 1 keV recoil energies. An important
deviation with respect to the phenomenological calculations has been found
allowing an estimation of the scintillation produced in He4 as a function of
pressure. The variation of the IQF as a function of the percentage of
isobutane, used as quencher, is also presented.
[2]
oai:arXiv.org:astro-ph/0509238 [pdf] - 1938940
Observing muon decays in water Cherenkov detectors at the Pierre Auger
Observatory
Allison, P.;
Arneodo, F.;
Bertou, X.;
Busca, N. G.;
Ghia, P. L.;
Medina, C.;
Navarra, G.;
Nellen, L.;
Ibarguen, H. Salazar;
Ranchon, S.;
Urban, M.;
Villasenor, L.
Submitted: 2005-09-08
Muons decaying in the water volume of a Cherenkov detector of the Pierre
Auger Observatory provide a useful calibration point at low energy. Using the
digitized waveform continuously recorded by the electronics of each tank, we
have devised a simple method to extract the charge spectrum of the Michel
electrons, whose typical signal is about 1/8 of a crossing vertical muon. This
procedure, moreover, allows continuous monitoring of the detector operation and
of its water level. We have checked the procedure with high statistics on a
test tank at the Observatory base and applied with success on the whole array.