Heavy-metal hot subdwarfs (sdB and sdO) represent a small group of stars with unusually high concentrations of trans-iron elements in their atmospheres, having abundances ~ 10000 times solar. One example is LS IV-14$^{\circ}$ 116, where a number of heavy-metal absorption lines of Sr II, Y III and Zr IV have been observed in the optical band 4000 - 5000 A. We use a fully relativistic Dirac atomic R-Matrix (DARC) to calculate photoionization cross sections of Sr$^{0}$, Y$^{+}$ and Zr$^{2+}$ from their ground state to the twentieth excited level. We use the cross sections and the oscillator strengths to simulate the spectrum of a hot subdwarf. We obtain complete sets of photoionization cross sections for the three ions under study. We use these data to calculate the opacity of the stellar atmospheres of hot subdwarf stars, and show that for overabundances observed in some heavy-metal subdwarves, photo-excitation from zirconium, in particular, does contribute some back warming in the model.

We extend the range of validity of the ARTIS 3D radiative transfer code up to hundreds of days after explosion, when Type Ia supernovae are in their nebular phase. To achieve this, we add a non-local thermodynamic equilibrium (non-LTE) population and ionisation solver, a new multi-frequency radiation field model, and a new atomic dataset with forbidden transitions. We treat collisions with non-thermal leptons resulting from nuclear decays to account for their contribution to excitation, ionisation, and heating. We validate our method with a variety of tests including comparing our synthetic nebular spectra for the well-known one-dimensional W7 model with the results of other studies. As an illustrative application of the code, we present synthetic nebular spectra for the detonation of a sub-Chandrasekhar white dwarf in which the possible effects of gravitational settling of Ne22 prior to explosion have been explored. Specifically, we compare synthetic nebular spectra for a 1.06 M$_\odot$ white dwarf model obtained when 5.5 Gyr of very-efficient settling is assumed to a similar model without settling. We find that this degree of Ne22 settling has only a modest effect on the resulting nebular spectra due to increased Ni58 abundance. Due to the high ionisation in sub-Chandrasekhar models, the nebular [Ni II] emission remains negligible, while the [Ni III] line strengths are increased and the overall ionisation balance is slightly lowered in the model with Ne22 settling. In common with previous studies of sub-Chandrasekhar models at nebular epochs, these models overproduce [Fe III] emission relative to [Fe II] in comparison to observations of normal Type Ia supernovae.

The spectra from Fe-peak elements may be used to determine the temperature and density of various astrophysical objects. Determination of these quantities is underpinned by the accuracy and the comprehensiveness of the underlying atomic structure and collisional calculations. In the following paper, we shall focus specifically on Ni IV lines associated with transitions amongst several low-lying levels. We shall employ modified versions of the parallel Dirac R-matrix codes, considering both electron-impact excitation of Ni$^{3+}$ and the photoionisation of both the ground and excited states of Ni$^{2+}$. We produce high-quality data sets for both processes, and using these data, we calculate line ratios relevant for plasma diagnostics of temperature and density.

The present debate on the reliability of astrophysical opacities has reached a new climax with the recent measurements of Fe opacities on the Z-machine at the Sandia National Laboratory \citep{Bailey2015}. To understand the differences between theoretical results, on the one hand, and experiments on the other, as well as the differences among the various theoretical results, detailed comparisons are needed. Many ingredients are involved in the calculation of opacities; deconstructing the whole process and comparing the differences at each step are necessary to quantify their importance and impact on the final results. We present here such a comparison using the two main approaches to calculate the required atomic data, the $R$-Matrix and distorted-wave methods, as well as sets of configurations and coupling schemes to quantify the effects on the opacities for the $Fe\ XVII$ and $Ni\ XIV$ ions.

Recent state-of-the-art calculations of A-values and electron impact excitation rates for Fe III are used in conjunction with the Cloudy modeling code to derive emission line intensity ratios for optical transitions among the fine-structure levels of the 3d$^6$ configuration. A comparison of these with high resolution, high signal-to-noise spectra of gaseous nebulae reveals that previous discrepancies found between theory and observation are not fully resolved by the latest atomic data. Blending is ruled out as a likely cause of the discrepancies, because temperature- and density-independent ratios (arising from lines with common upper levels) match well with those predicted by theory. For a typical nebular plasma with electron temperature $T_{\rm e} = 9000$ K and electron density $\rm N_{e}=10^4 \, cm^{-3}$, cascading of electrons from the levels $\rm ^3G_5$, $\rm ^3G_4$ and $\rm ^3G_3$ plays an important role in determining the populations of lower levels, such as $\rm ^3F_4$, which provide the density diagnostic emission lines of Fe III, such as $\rm ^5D_4$ - $\rm ^3F_4$ at 4658 \AA. Hence further work on the A-values for these transitions is recommended, ideally including measurements if possible. However, some Fe III ratios do provide reliable $N_{\rm e}$-diagnostics, such as 4986/4658. The Fe III cooling function calculated with Cloudy using the most recent atomic data is found to be significantly greater at $T_e$ $\simeq$ 30000 K than predicted with the existing Cloudy model. This is due to the presence of additional emission lines with the new data, particularly in the 1000--4000 \AA\ wavelength region.

The observed line intensity ratios of the Si II 1263 and 1307 \AA\ multiplets to that of Si II 1814\,\AA\ in the broad line region of quasars are both an order of magnitude larger than the theoretical values. This was first pointed out by Baldwin et al. (1996), who termed it the "Si II disaster", and it has remained unresolved. We investigate the problem in the light of newly-published atomic data for Si II. Specifically, we perform broad line region calculations using several different atomic datasets within the CLOUDY modeling code under optically thick quasar cloud conditions. In addition, we test for selective pumping by the source photons or intrinsic galactic reddening as possible causes for the discrepancy, and also consider blending with other species. However, we find that none of the options investigated resolves the Si II disaster, with the potential exception of microturbulent velocity broadening and line blending. We find that a larger microturbulent velocity ($\sim 500 \rm \, kms^{-1}$) may solve the Si II disaster through continuum pumping and other effects. The CLOUDY models indicate strong blending of the Si II 1307 \AA\ multiplet with emission lines of O I, although the predicted degree of blending is incompatible with the observed 1263/1307 intensity ratios. Clearly, more work is required on the quasar modelling of not just the Si II lines but also nearby transitions (in particular those of O I) to fully investigate if blending may be responsible for the Si II disaster.

Recent atomic physics calculations for Si II are employed within the Cloudy modelling code to analyse Hubble Space Telescope (HST) STIS ultraviolet spectra of three cool stars, Beta-Geminorum, Alpha-Centauri A and B, as well as previously published HST/GHRS observations of Alpha-Tau, plus solar quiet Sun data from the High Resolution Telescope and Spectrograph. Discrepancies found previously between theory and observation for line intensity ratios involving the 3s$^{2}$3p $^{2}$P$_{J}$--3s3p$^{2}$ $^{4}$P$_{J^{\prime}}$ intercombination multiplet of Si II at 2335 Angs are significantly reduced, as are those for ratios containing the 3s$^{2}$3p $^{2}$P$_{J}$--3s3p$^{2}$ $^{2}$D$_{J^{\prime}}$ transitions at 1816 Angs. This is primarily due to the effect of the new Si II transition probabilities. However, these atomic data are not only very different from previous calculations, but also show large disagreements with measurements, specifically those of Calamai et. al. (1993) for the intercombination lines. New measurements of transition probabilities for Si II are hence urgently required to confirm (or otherwise) the accuracy of the recently calculated values. If the new calculations are confirmed, then a long-standing discrepancy between theory and observation will have finally been resolved. However, if the older measurements are found to be correct, then the agreement between theory and observation is simply a coincidence and the existing discrepancies remain.

We present Maxwellian-averaged effective collision strengths for the electron-impact excitation of S III over a wide range of electron temperatures of astrophysical importance, log T(K) = 3.0-6.0. The calculation incorporates 53 fine-structure levels arising from the six lowest configurations, giving rise to 1378 individual lines, and is undertaken using the recently developed RMATRX II plus FINE95 suite of codes. A detailed comparison is made with a previous R-matrix calculation and significant differences are found for some transitions. The atomic data are subsequently incorporated into the modeling code CLOUDY to generate line intensities for a range of plasma parameters, with emphasis on allowed UV and EUV emission lines detected from the Io plasma torus. Electron density-sensitive line ratios are calculated with the present atomic data and compared with those from CHIANTI v7.1, as well as with Io plasma torus spectra obtained by FUSE and EUVE. The present line intensities are found to agree well with the observational results and provide a noticeable improvement upon the values predicted by CHIANTI.