Low energy ground-based cosmic ray air shower experiments generally have energy threshold in the range of a few tens to a few hundreds of TeV. The shower observables are measured indirectly with an array of detectors. The atmospheric absorption of low energy secondaries limits their detection frequencies at the Earth's surface. However, due to selection effects, a tiny fraction of low energy showers, which are produced in the lower atmosphere can reach the observational level. But, due to less information of shower observables, the reconstruction of these showers are arduous. Hence, it is believed that direct measurements by experiments aboard on satellites and balloon flights are more reliable at low energies. Despite having very small efficiency ($\sim$0.1%) at low energies, the large acceptance ($\sim$5 m$^2$sr) of GRAPES-3 experiment allows observing primary cosmic rays down below to $\sim$1 TeV and opens up the possibility to measure primary energy spectrum spanning from a few TeV to beyond cosmic ray knee (up to 10$^{16}$ eV), covering five orders of magnitude. The GRAPES-3 energy threshold for primary protons through Monte Carlo simulations are calculated, which gives reasonably good agreement with data. Furthermore, the total efficiencies and acceptance are also calculated for protons primaries. The ability of GRAPES-3 experiment to cover such a broader energy range may provide a unique handle to bridge the energy spectrum between direct measurements at low energies and indirect measurements at ultra-high energies.

The angular resolution of an extensive air shower (EAS) array plays a critical role in determining its sensitivity for the detection of point $\gamma$-ray sources in the multi-TeV energy range. The GRAPES-3 an EAS array located at Ooty in India (11.4$^{\circ}$N, 76.7$^{\circ}$E, 2200 m altitude) is designed to study $\gamma$-rays in the TeV-PeV energy range. It comprises of a dense array of 400 plastic scintillators deployed over an area of 25000 m$^2$ and a large area (560 m$^2$) muon telescope. A new statistical method allowed real time determination of the propagation delay of each detector in the GRAPES-3 array. The shape of shower front is known to be curved and here the details of a new method developed for accurate measurement of the shower front curvature is presented. These two developments have led to a sizable improvement in the angular resolution of GRAPES-3 array. It is shown that the curvature depends on the size and age of an EAS. By employing two different techniques, namely, the odd-even and the left-right methods, independent estimates of the angular resolution are obtained. The odd-even method estimates the best achievable resolution of the array. For obtaining the angular resolution, the left-right method is used after implementing the size and age dependent curvature corrections. A comparison of the angular resolution as a function of EAS energy by these two methods shows them be virtually indistinguishable. The angular resolution of GRAPES-3 array is 47$^{\prime}$ for energies E$>$5 TeV and improves to 17$^{\prime}$ at E$>$100 TeV and finally approaching 10$^{\prime}$ at E$>$500 TeV.

Chromospheric magnetic fields are of paramount importance in understanding the dynamics of energetic events in the solar atmosphere. At the Kodaikanal Solar Observatory, several polarimeters were developed in the past to study the active region magnetic fields. A new polarimeter has been developed and installed at Kodaikanal Tower-tunnel Telescope to study the active regions at Chromospheric level, in Ca II $8542~\AA$ spectral line. Design aspects of the instrument and polarimetry strategy are discussed. Telescope instrumental polarization has been revisited and possible ways to reduce it have been proposed. Telescope polarization model developed in Zemax to examine the analytical instrumental polarization model is discussed. The polarimeter control unit, and the software developed to operate the polarimeter are briefly described. Polarimetric calibration of the instrument, observations, corrections for instrumental polarization and the sample Stokes profiles are presented. Polarimetric accuracy and sensitivity are estimated to be better than $3\times10^{-2}$ and $3\times 10^{-3}$ respectively.

The GRAPES-3 muon telescope in Ooty, India had claimed detection of a 2 hour (h) high-energy ($\sim$20 GeV) burst of galactic cosmic-rays (GCRs) through a $>$50$\sigma$ surge in GeV muons, was caused by reconnection of the interplanetary magnetic field (IMF) in the magnetosphere that led to transient weakening of Earth's magnetic shield. This burst had occurred during a G4-class geomagnetic storm (storm) with a delay of $\frac{1}{2}$h relative to the coronal mass ejection (CME) of 22 June 2015 (Mohanty et al., 2016). However, recently a group interpreted the occurrence of the same burst in a subset of 31 neutron monitors (NMs) to have been the result of an anisotropy in interplanetary space (Evenson et al., 2017) in contrast to the claim in (Mohanty et al., 2016). A new analysis of the GRAPES-3 data with a fine 10.6$^{\circ}$ angular segmentation shows the speculation of interplanetary anisotropy to be incorrect, and offers a possible explanation of the NM observations. The observed 28 minutes (min) delay of the burst relative to the CME can be explained by the movement of the reconnection front from the bow shock to the surface of Earth at an average speed of 35 km/s, much lower than the CME speed of 700 km/s. This measurement may provide a more accurate estimate of the start of the storm.

The distributions of size and chemical composition in the regolith on airless bodies provides clues to the evolution of the solar system. Recently, the regolith on asteroid (25143) Itokawa, visited by the JAXA Hayabusa spacecraft, was observed to contain millimeter to centimeter sized particles. Itokawa boulders commonly display well-rounded profiles and surface textures that appear inconsistent with mechanical fragmentation during meteorite impact; the rounded profiles have been hypothesized to arise from rolling and movement on the surface as a consequence of seismic shaking. We provide a possible explanation of these observations by exploring the primary crack propagation mechanisms during thermal fatigue of a chondrite. We present the in situ evolution of the full-field strains on the surface as a function of temperature and microstructure, and observe and quantify the crack growth during thermal cycling. We observe that the primary fatigue crack path preferentially follows the interfaces between monominerals, leaving them intact after fragmentation. These observations are explained through a microstructure-based finite element model that is quantitatively compared with our experimental results. These results on the interactions of thermal fatigue cracking with the microstructure may ultimately allow us to distinguish between thermally induced fragments and impact products.

Temporal offsets between the time series of solar activity indicators provide important clues regarding the physical processes responsible for the cyclic variability in the solar atmosphere. Hysteresis patterns generated between any two indicators were popularly used to study their morphological features and further to understand their inter relationships. We use time series of different solar indicators to understand the possible cause-and-effect criteria between their respective source regions. Sensitivity of the upper atmosphere to the activity underneath might play an important role in introducing different evolutionary patterns in the profiles of solar indicators and in turn cause temporal offsets between them. Limitations in the observations may also cause relative shifts in the time series.

The linear relationship between the maximum amplitudes (R$_{max}$) of sunspot cycles and preceding minima (R$_{min}$) is one of the precursor methods used to predict the amplitude of the upcoming solar cycle. In the recent past this method has been subjected to severe criticism. In this communication we show that this simple method is reliable and can profitably be used for prediction purposes. With the 13-month smoothed R$_{min}$ of 1.8 at the beginning, it is predicted that the R$_{max}$ of the ongoing cycle will be around 85$\pm$17, suggesting that Cycle 24 may be of moderate strength. Based on a second order polynomial dependence between the rise time (T$_R$) and R$_{max}$, it is predicted that Cycle 24 will reach its smoothed maximum amplitude during the third quarter of the year 2013. An important finding of this paper is that the rise time cycle amplitude relation reaches a minimum at about 3 to 3.5 years corresponding to a cycle amplitude of about 160. The Waldmeier effect breaks at this point and T$_{R}$ increases further with increase in R$_{max}$. This feature, we believe, may put a constraint on the flux transport dynamo models and lead to more accurate physical principles based predictions.

An eight stage balanced modulation scheme for dual beam polarimetry is presented in this paper. The four Stokes parameters are weighted equally in all the eight stages of modulation resulting in total polarimetric efficiency of unity. The gain table error inherent in dual beam system is reduced by using the well known beam swapping technique. The wavelength dependent polarimetric efficiencies of Stokes parameters due to the chromatic nature of the waveplates are presented. The proposed modulation scheme produces better Stokes $Q$ and $V$ efficiencies for wavelengths larger than the design wavelength whereas Stokes $U$ has better efficiency in the shorter wavelength region. Calibration of the polarimeter installed as a backend instrument of the Kodaikanal Tower Telescope is presented. It is found through computer simulation that a 14% sky transparency variation during calibration of the polarimeter can introduce $\approx 1.8%$ uncertainty in the determination of its response matrix.