On 13 March 2010 an unusually long duration event was observed by radio spectrographs onboard the STEREO-B and Wind spacecraft. The event started at about 13:00 UT and ended at approximately 06:00 UT on 14 March. The event presents itself as slow drifting, quasi-continuous emission in a very narrow frequency interval, with an apparent frequency drift from about 625 kHz to approximately 425 kHz. Using the Leblanc, Dulk, and Bougeret (1998) interplanetary density model we determined that the drift velocities of the radio source are $\approx$33km s$^{-1}$ and $\approx$52km s$^{-1}$ for 0.2 and 0.5 times the densities of Leblanc model, respectively with a normalization density of 7.2cm$^{-3}$ at 1AU and assuming harmonic emission. A joint analysis of the radio direction finding data, coronograph white-light observations and modeling revealed that the radio sources appear to be localized in regions of interaction with relatively high density and slow solar wind speed.

This thesis strives to improve our understanding of solar activity, specifically the behaviour of solar flares and coronal mass ejections. An investigation into the hydrodynamic evolution of a confined solar flare was carried out using RHESSI, CDS, GOES and TRACE. Evidence for pre-flare heating, explosive and gentle chromospheric evaporation and loop draining were observed in the data. The observations were compared to a 0-D hydrodynamic model, EBTEL, to aid interpretation. This led to the conclusion that the flare was not heated purely by non-thermal beam heating as previously believed, but also required direct heating of the plasma. An observational investigation in to the initiation mechanism of a coronal mass ejection and eruptive flare was then carried out, again utilising observations from a wide range of spacecraft: MESSENGER/SAX, RHESSI, EUVI, Cor1 and Cor2. Observations provided evidence of CME triggering by internal tether-cutting and not by breakout reconnection. A comparison of the confined and eruptive flares suggests that while they have different characteristics, timescales and topologies, these two phenomena are the result of the same fundamental processes. Finally, an investigation into the sensitivity of EUV imaging telescopes was carried out. This study established a new technique for calculating the sensitivity of EUV imagers to plasmas of different temperatures for four different types of plasma: coronal hole, quiet sun, active region and solar flare. This was carried out for six instruments: Proba-2/SWAP, TRACE, SOHO/EIT, STEREO A/EUVI, STEREO B/EUVI and SDO/AIA. The importance of considering the multi-thermal nature of these instruments was then put into the context of investigating explosive solar activity.

The Sun Watcher with Active Pixels and Image Processing (SWAP) is an EUV solar telescope on board ESA's Project for Onboard Autonomy 2 (PROBA2) mission launched on 2 November 2009. SWAP has a spectral bandpass centered on 17.4 nm and provides images of the low solar corona over a 54x54 arcmin field-of-view with 3.2 arcsec pixels and an imaging cadence of about two minutes. SWAP is designed to monitor all space-weather-relevant events and features in the low solar corona. Given the limited resources of the PROBA2 microsatellite, the SWAP telescope is designed with various innovative technologies, including an off-axis optical design and a CMOS-APS detector. This article provides reference documentation for users of the SWAP image data.

Solar flares are large-scale releases of energy in the solar atmosphere, which are characterised by rapid changes in the hydrodynamic properties of plasma from the photosphere to the corona. Solar physicists have typically attempted to understand these complex events using a combination of theoretical models and observational data. From a statistical perspective, there are many challenges associated with making accurate and statistically significant comparisons between theory and observations, due primarily to the large number of free parameters associated with physical models. This class of ill-posed statistical problem is ideally suited to Bayesian methods. In this paper, the solar flare studied by Raftery et al. (2009) is reanalysed using a Bayesian framework. This enables us to study the evolution of the flare's temperature, emission measure and energy loss in a statistically self-consistent manner. The Bayesian-based model selection techniques imply that no decision can be made regarding which of the conductive or non-thermal beam heating play the most important role in heating the flare plasma during the impulsive phase of this event.

We present observational results of a type II burst associated with a CME-CME interaction observed in the radio and white-light wavelength range. We applied radio direction-finding techniques to observations from the STEREO and Wind spacecraft, the results of which were interpreted using white-light coronagraphic measurements for context. The results of the multiple radio-direction finding techniques applied were found to be consistent both with each other and with those derived from the white-light observations of coronal mass ejections (CMEs). The results suggest that the Type II burst radio emission is causally related to the CMEs interaction.

The objective of this investigation was to first examine the kinematics of coronal mass ejections (CMEs) using EUV and coronagraph images, and then to make a comparison with theoretical models in the hope to identify the driving mechanisms of the CMEs. We have studied two CMEs which occurred on 2006 Dec. 17 (CME06) and 2007 Dec. 31 (CME07). The models studied in this work were catastrophe, breakout, and toroidal instability models. We found that after the eruption, the accelerations of both events exhibited a drop before increasing again. Our comparisons with the theories suggested that CME06 can be best described by a hybrid of the catastrophe and breakout models while CME07 is most consistent with the breakout model.

This paper investigates the temporal evolution of temperature, emission measure, energy loss and velocity in a C-class solar flare from both an observational and theoretical perspective. The properties of the flare were derived by following the systematic cooling of the plasma through the response functions of a number of instruments -- RHESSI (>5 MK), GOES-12 (5-30 MK), TRACE 171 A (1 MK) and SOHO/CDS (~0.03-8 MK). These measurements were studied in combination with simulations from the 0-D EBTEL model. At the flare on-set, upflows of ~90 km s-1 and low level emission were observed in Fe XIX, consistent with pre-flare heating and gentle chromospheric evaporation. During the impulsive phase, upflows of ~80 km s-1 in Fe XIX and simultaneous downflows of 20 km s-1 in He I and O V were observed, indicating explosive chromospheric evaporation. The plasma was subsequently found to reach a peak temperature of ~13 MK in approximately 10 minutes. Using EBTEL, conduction was found to be the dominant loss mechanism during the initial ~300s of the decay phase. It was also found to be responsible for driving gentle chromospheric evaporation during this period. As the temperature fell below ~8 MK, and for the next ~4,000s, radiative losses were determined to dominate over conductive losses. The radiative loss phase was accompanied by significant downflows of <40 km s-1 in O V. This is the first extensive study of the evolution of a canonical solar flare using both spectroscopic and broad-band instruments in conjunction with a hydrodynamic model. While our results are in broad agreement with the standard flare model, the simulations suggest that both conductive and non-thermal beam heating play important roles in heating the flare plasma during the impulsive phase of at least this event.

We used star density maps obtained from 2MASS to obtain a sample of star clusters in the entire Galactic Plane with |b|<20deg. A total of 1788 star cluster candidates are identified in this survey. Among those are 681 previously known open clusters and 86 globular clusters. A statistical analysis indicates that our sample of 1021 new cluster candidates has a contamination of about 50%. Star cluster parameters are obtained by fitting a King profile to the star density. These parameters are used to statistically identify probable new globular cluster candidates in our sample. A detailed investigation of the projected distribution of star clusters in the Galaxy demonstrates that they show a clear tendency to cluster on spatial scales in the order of 12-25pc, a typical size for molecular clouds.