We report in this paper spectroscopic and photometric analysis of eight massive stars observed during Campaign 8 of the Kepler/K2 mission from January to March 2016. Spectroscopic data were obtained on these stars at OPD/LNA, Brazil, and their stellar parameters determined using SME. Periodic analyses of the light curves were performed through CLEANEST and PERIOD04 algorithms. Mass, luminosity, and radius of our stars were estimated employing CESAM+POSC grids. Three of our stars show significant periodicity. K2 ID 220679442 and K2 ID 220532854 have periods linked to the stellar rotation. K2 ID 220532854 has prominent silicon lines (Si II 4128-4131), a characteristic presented in the peculiar class of Ap magnetic main sequence stars. However, in our spectral analysis, this object was found to be an evolved, luminous giant star. K2 ID 220466722 was revealed to be a $\delta$ Scuti variable, and 40 individual frequencies were determined for this star. No significant periodicity was found in the light curves for the remaining stars analyzed in this work, besides the instrumental one.

We analyze the effect of a sunspot in its quiet surroundings applying a helioseismic technique on almost three years of Helioseismic and Magnetic Imager (HMI) observations obtained during solar cycle 24 to further study the sunspot structure below the solar surface. The attenuation of acoustic waves with frequencies lower than 4.2 mHz depends more strongly on the wave direction at a distance of $6^o-7^o$ from the sunspot center. The amplification of higher frequency waves is highest 6$^o$ away from the active region and it is largely independent of the wave's direction. We observe a mean clockwise flow around active regions, which angular speed decreases exponentially with distance and has a coefficient close to $-0.7$ degree$^{-1}$. The observed horizontal flow in the direction of the nearby active region agrees with a large-scale circulation around the sunspot in the shape of cylindrical shell. The center of the shell seems to be centered around 7$^o$ from the sunspot center, where we observe an inflow close to the surface down to $\sim$2 Mm, followed by an outflow at deeper layers until at least 7 Mm.

The ring-diagram technique was developed by Frank Hill 25 years ago and developed quickly during the late 1990s. It is nowadays one of the most commonly used techniques in local helioseismology. The method consists in the power spectral analysis of solar acoustic oscillations on small regions (2 to 30 degrees) of the solar surface. The power spectrum resembles a set of trumpets nested inside each other and, for a given frequency, it looks like a ring, hence the technique's name. It provides information on the horizontal flow field and thermodynamic structure in the layers immediately below the photosphere. With data regularly provided by MDI (on board SOHO), GONG+ network and more recently HMI (on SDO), many important results have been achieved. In recently years, these results include estimations of the meridional circulation and its evolution with solar cycle; flows associated with active regions, as well as, flow divergence and vorticity; and thermal structure beneath and around active regions. Much progress is expected with data now provided by HMI's high spatial resolution observations and high duty cycle. There are two data processing pipelines (GONG and HMI) providing free access to the data and the results of the ring-diagram analysis. Here we will discuss the most recent results and improvements in the technique, as well as, the many challenges that still remain.

We study temporal variations in the amplitudes and widths of high-degree acoustic modes by applying the ring-diagram technique to the GONG+, MDI and HMI Dopplergrams during the declining phase of cycle 23 and rising phase of cycle 24. The mode parameters from all three instruments respond similarly to the varying magnetic activity. The mode amplitudes and widths show consistently lower variation due to smaller magnetic activity in cycle 24 as compared to the previous solar cycle.

We present the first accurate characterization of high-degree modes, derived using the best MDI full-disk full-resolution data set available. A ninety day long time series of full-disk two arc-second per pixel resolution dopplergrams was acquired in 2001. These dopplergrams were spatially decomposed using our best estimate of the image scale and the known components of MDI's image distortion. A multi-taper power spectrum estimator was used to generate power spectra up to l = 1000, with a large number of tapers to reduce the realization noise, while the blending at high degrees negates the need for high spectral resolution. These power spectra were fitted for all degrees and all azimuthal orders, between l = 100 and l = 1000. This fitting generated in excess of 6x10^6 individual estimates of ridge frequencies, line-widths, amplitudes and asymmetries (singlets: l,n,m), corresponding to some 6,000 multiplets (l,n). Fitting at high degrees generates ridge characteristics, characteristics that do not correspond to the underlying mode characteristics. We used a sophisticated forward modeling to recover the best possible estimate of the underlying mode characteristics (mode frequencies, as well as line-widths, amplitudes and asymmetries). We describe in detail this modeling and its validation. The modeling has been extensively reviewed and refined, by including an iterative process to improve its input parameters to better match the observations. Also, the contribution of the leakage matrix on the accuracy of the procedure has been carefully assessed. We present the derived set of corrected mode characteristics, discuss their uncertainties and the precision of the ridge to mode correction schemes. In our conclusions, we address how to further improve these estimates, and the implications for other data sets, like GONG+ and HMI.

We present evidence that the sound-speed variation with solar activity has a two-layer configuration, similar to the one observed below an active region, which consists of a negative layer near the solar surface and a positive one in the layer immediately below the first one. Frequency differences between the activity minimum and maximum of solar cycle 23, obtained applying global helioseismology to the Michelson Doppler Imager (MDI) on board SOHO, is used to determine the sound-speed variation from below the base of the convection zone to a few Mm below the solar surface. We find that the sound speed at solar maximum is smaller than at solar minimum at the limit of our determination (5.5 Mm). The min-to-max difference decreases in absolute values until ~7 Mm. At larger depths, the sound speed at solar maximum is larger than at solar minimum and their difference increases with depth until ~10 Mm. At this depth, the relative difference is less than half of the value observed at the lowest depth determination. At deeper layers, it slowly decreases with depth until there is no difference between maximum and minimum activity.

Although it is well known that the solar acoustic mode frequency increases as the solar activity increases, the mechanism behind it is still unknown. Mode frequencies with 20 < l < 900 obtained by applying spherical harmonic decomposition to MDI full-disk observations were used. First, the dependence of solar acoustic mode frequency with solar activity was examined and evidence of a quadratic relation was found indicating a saturation effect at high solar activity. Then, the frequency dependence of frequency differences between the activity minimum and maximum was analyzed. The frequency shift scaled by the normalized mode inertia follows a simple power law where the exponent for the p modes decreases by 37% for modes with frequency larger than 2.5 mHz.

We study temporal variations in the amplitudes and widths of high-degree acoustic modes in the quiet and active Sun by applying ring-diagram technique to the GONG+ and MDI Dopplergrams during the declining phase of cycle 23. The increase in amplitudes and decrease in line-widths in the declining phase of the solar activity is in agreement with previous studies. A similar solar cycle trend in the mode parameters is also seen in the quiet-Sun regions but with a reduced magnitude. Moreover, the amplitudes obtained from GONG+ data show long-term variations on top of the solar cycle trend.

Here we present a detailed analysis of solar acoustic mode frequencies and their rotational splittings for modes with degree up to 900. They were obtained by applying spherical harmonic decomposition to full-disk solar images observed by the Michelson Doppler Imager onboard the Solar and Heliospheric Observatory spacecraft. Global helioseismology analysis of high-degree modes is complicated by the fact that the individual modes cannot be isolated, which has limited so far the use of high-degree data for structure inversion of the near-surface layers (r > 0.97 R). In this work, we took great care to recover the actual mode characteristics using a physically motivated model which included a complete leakage matrix. We included in our analysis the following instrumental characteristics: the correct instantaneous image scale, the radial and non-radial image distortions, the effective position angle of the solar rotation axis and a correction to the Carrington elements. We also present variations of the mode frequencies caused by the solar activity cycle. We have analyzed seven observational periods from 1999 to 2005 and correlated their frequency shift with four different solar indices. The frequency shift scaled by the relative mode inertia is a function of frequency alone and follows a simple power law, where the exponent obtained for the p modes is twice the value obtained for the f modes. The different solar indices present the same result.

Using full-disk observations obtained with the Michelson Doppler Imager (MDI) on board the Solar and Heliospheric Observatory (SOHO) spacecraft, we present variations of the solar acoustic mode frequencies caused by the solar activity cycle. High-degree (100 < l < 900) solar acoustic modes were analyzed using global helioseismology analysis techniques over most of solar cycle 23. We followed the methodology described in details in Korzennik, Rabello-Soares and Schou (2004) to infer unbiased estimates of high-degree mode parameters (see also Rabello-Soares, Korzennik and Schou, 2006). We have removed most of the known instrumental and observational effects that affect specifically high-degree modes. We show that the high-degree changes are in good agreement with the medium-degree results, except for years when the instrument was highly defocused. We analyzed and discuss the effect of defocusing on high degree estimation. Our results for high-degree modes confirm that the frequency shift scaled by the relative mode inertia is a function of frequency and it is independent of degree.

The characteristic of the solar acoustic spectrum is such that mode lifetimes get shorter and spatial leaks get closer in frequency as the degree of a mode increases for a given order. A direct consequence of this property is that individual p-modes are only resolved at low and intermediate degrees, and that at high degrees, individual modes blend into ridges. Once modes have blended into ridges, the power distribution of the ridge defines the ridge central frequency and it will mask the true underlying mode frequency. An accurate model of the amplitude of the peaks that contribute to the ridge power distribution is needed to recover the underlying mode frequency from fitting the ridge. We present the results of fitting high degree power ridges (up to l = 900) computed from several two to three-month-long time-series of full-disk observations taken with the Michelson Doppler Imager (MDI) on-board the Solar and Heliospheric Observatory between 1996 and 1999. We also present a detailed discussion of the modeling of the ridge power distribution, and the contribution of the various observational and instrumental effects on the spatial leakage, in the context of the MDI instrument. We have constructed a physically motivated model (rather than some ad hoc correction scheme) resulting in a methodology that can produce an unbiased determination of high-degree modes, once the instrumental characteristics are well understood. Finally, we present changes in high degree mode parameters with epoch and thus solar activity level and discuss their significance.

Despite the strong evidence that the peaks in the spectrum of solar oscillations are asymmetric, most determinations of mode frequencies have been based on fits of symmetric Lorentzian profiles to the Fourier or power spectra of oscillation time strings. The systematic errors resulting from neglecting the line asymmetry could have serious effects on inversions for the solar internal structure and rotation. Here we analyse artificial data based on simple models of the intrinsic line asymmetry, using GONG mode parameters with asymmetries found by one of us (Rosenthal \cite{rosenthal2}). By fitting Lorentzians to the resulting spectra, we estimate the likely properties of the errors introduced in the frequencies. We discuss whether these frequency shifts have a form similar to the near-surface layers uncertainties and are therefore suppressed in the solar structure inversion. We also estimate directly their contribution, if any, in the solar sound-speed and density determinations using the SOLA technique.

The observed solar p-mode frequencies provide a powerful diagnostic of the internal structure of the Sun and permit us to test in considerable detail the physics used in the theory of stellar structure. Amongst the most commonly used techniques for inverting such helioseismic data are two implementations of the optimally localized averages (OLA) method, namely the Subtractive Optimally Localized Averages (SOLA) and Multiplicative Optimally Localized Averages (MOLA). Both are controlled by a number of parameters, the proper choice of which is very important for a reliable inference of the solar internal structure. Here we make a detailed analysis of the influence of each parameter on the solution and indicate how to arrive at an optimal set of parameters for a given data set.

In Part I we have developed a theory for fitting p-mode Fourier spectra assuming that these spectra have a multi-normal distribution. We showed, using Monte-Carlo simulations, how one can obtain p-mode parameters using 'Maximum Likelihood Estimators'. In this article, hereafter Part II, we show how to use the theory developed in Part I for fitting real data. We introduce 4 new diagnostics in helioseismology: the $(m,\nu)$ echelle diagramme, the cross echelle diagramme, the inter echelle diagramme, and the ratio cross spectrum. These diagnostics are extremely powerful to visualize and understand the covariance matrices of the Fourier spectra, and also to find bugs in the data analysis code. These diagrammes can also be used to derive quantitative information on the mode leakage and noise covariance matrices. Numerous examples using the LOI/SOHO and GONG data are given.

In this article we present our state of the art of fitting helioseismic p-mode spectra. We give a step by step recipe for fitting the spectra: statistics of the spectra both for spatially unresolved and resolved data, the use of Maximum Likelihood estimates, the statistics of the p-mode parameters, the use of Monte-Carlo simulation and the significance of fitted parameters. The recipe is applied to synthetic low-resolution data, similar to those of the LOI, using Monte-Carlo simulations. For such spatially resolved data, the statistics of the Fourier spectrum is assumed to be a multi-normal distribution; the statistics of the power spectrum is \emph{not} a $\chi^{2}$ with 2 degrees of freedom. Results for $l=1$ shows that all parameters describing the p modes can be obtained without bias and with minimum variance provided that the leakage matrix is known. Systematic errors due to an imperfect knowledge of the leakage matrix are derived for all the p-mode parameters.