We describe GBTrans, a real-time search system designed to find fast radio bursts (FRBs) using the 20-m radio telescope at the Green Bank Observatory. The telescope has been part of the Skynet educational program since 2015. We give details of the observing system and report on the non-detection of FRBs from a total observing time of 503 days. Single pulses from four known pulsars were detected as part of the commensal observing. The system is sensitive enough to detect approximately half of all currently known FRBs and we estimate that our survey probed redshifts out to about 0.3 corresponding to an effective survey volume of around 124,000~Mpc$^3$. Modeling the FRB rate as a function of fluence, $F$, as a power law with $F^{-\alpha}$, we constrain the index $\alpha < 2.5$ at the 90% confidence level. We discuss the implications of this result in the context of constraints from other FRB surveys.

This paper presents a survey of microwave front-end receivers installed at radio telescopes throughout the World. This unprecedented analysis was conducted as part of a review of front-end developments for Italian radio telescopes, initiated by the Italian National Institute for Astrophysics in 2016. Fifteen international radio telescopes have been selected to be representative of the instrumentation used for radio astronomical observations in the frequency domain from 300 MHz to 116 GHz. A comprehensive description of the existing receivers is presented and their characteristics are compared and discussed. The observing performances of the complete receiving chains are also presented. An overview of on-going developments illustrates and anticipates future trends in front-end projects to meet the most ambitious scientific research goals.

A new 1.4 GHz 19-element, dual-polarization, cryogenic phased array feed (PAF) radio astronomy receiver has been developed for the Robert C. Byrd Green Bank Telescope (GBT) as part of FLAG (Focal L-band Array for the GBT) project. Commissioning observations of calibrator radio sources show that this receiver has the lowest reported beamformed system temperature ($T_{\rm sys}$) normalized by aperture efficiency ($\eta$) of any phased array receiver to date. The measured $T_{\rm sys}/\eta$ is $25.4 \pm 2.5$ K near 1350 MHz for the boresight beam, which is comparable to the performance of the current 1.4 GHz cryogenic single feed receiver on the GBT. The degradation in $T_{\rm sys}/\eta$ at $\sim$ 4 arcmin (required for Nyquist sampling) and $\sim$ 8 arcmin offsets from the boresight is, respectively, $\sim$ 1\% and $\sim$ 20\% of the boresight value. The survey speed of the PAF with seven formed beams is larger by a factor between 2.1 and 7 compared to a single beam system depending on the observing application. The measured performance, both in frequency and offset from boresight, qualitatively agree with predictions from a rigorous electromagnetic model of the PAF. The astronomical utility of the receiver is demonstrated by observations of the pulsar B0329+54 and an extended HII region, the Rosette Nebula. The enhanced survey speed with the new PAF receiver will enable the GBT to carry out exciting new science, such as more efficient observations of diffuse, extended neutral hydrogen emission from galactic in-flows and searches for Fast Radio Bursts.

In this paper, we describe the development of a new L-band (1.4 GHz) Cryogenic Phased Array Feed (PAF) system, referred to as the GBT2 array. Results from initial measurements made with the GBT2 array are also presented. The PAF was developed for the Green Bank Telescope (GBT) as part of the Focal L-band Array for the GBT (FLAG) project. During the first stage of the development work (Phase I), a prototype cryogenic 19 element dual-polarized array with "Kite" dipole elements was developed and tested on the GBT. The measured system temperature over efficiency ($T_{sys}/\eta$) ratio for the bore sight beam of the Kite array was 45.5 K at 1.55 GHz. The off-boresight $T_{sys}/\eta$ shows an increase by 13 K at an offset equal to the half power beam width (7$^{'}$.2 at 1.7 GHz). Our measurements indicate that the off-boresight degradation and field-of-view (FoV) limitation of the Kite array is simply due to the fixed array size. To increase the FoV, a new 19-element GBT2 array with larger array spacing was developed during FLAG Phase II. The frequency response of the array was optimized from 1.2 to 1.6 GHz. A system with larger cryostat, new low noise amplifiers (LNAs), down-conversion and digitization close to the front end, unformatted digital transmission over fiber, ROACH II based polyphase filter banks (PFBs) with bandwidth 150 MHz and a data acquisition system that records voltage samples from one of the PFB channels were all developed. The data presented here is processed off-line. The receiver temperature measured with the new system is 17 K at 1.4 GHz, an improvement $>$ 8 K over the previous Kite array. Measurements with the GBT2 array on the telescope are in progress. A real time 150 MHz beamformer is also being developed as part of an NSF-funded collaboration between NRAO/GBO/BYU \& West Virginia University (Beamformer Project) to support science observations.

Phased Array Feed (PAF) technology is the next major advancement in radio astronomy in terms of combining high sensitivity and large field of view. The Focal L-band Array for the Green Bank Telescope (FLAG) is one of the most sensitive PAFs developed so far. It consists of 19 dual-polarization elements mounted on a prime focus dewar resulting in seven beams on the sky. Its unprecedented system temperature of$\sim$17 K will lead to a 3 fold increase in pulsar survey speeds as compared to contemporary single pixel feeds. Early science observations were conducted in a recently concluded commissioning phase of the FLAG where we clearly demonstrated its science capabilities. We observed a selection of normal and millisecond pulsars and detected giant pulses from PSR B1937+21.

The General Single-Dish Data format (GSDD) was developed in the mid-1980s as a data model to support centimeter, millimeter and submillimeter instrumentation at NRAO, JCMT, the University of Arizona and IRAM. We provide an overview of the GSDD requirements and associated data model, discuss the implementation of the resultant file formats, describe its usage in the observatories and provide a retrospective on the format.

The Graphics Processing Unit (GPU) has become an integral part of astronomical instrumentation, enabling high-performance online data reduction and accelerated online signal processing. In this paper, we describe a wide-band reconfigurable spectrometer built using an off-the-shelf GPU card. This spectrometer, when configured as a polyphase filter bank (PFB), supports a dual-polarization bandwidth of up to 1.1 GHz (or a single-polarization bandwidth of up to 2.2 GHz) on the latest generation of GPUs. On the other hand, when configured as a direct FFT, the spectrometer supports a dual-polarization bandwidth of up to 1.4 GHz (or a single-polarization bandwidth of up to 2.8 GHz).

We describe the successful design, implementation, and operation of a 12 GHz holography system installed on the Robert C. Byrd Green Bank Telescope (GBT). We have used a geostationary satellite beacon to construct high-resolution holographic images of the telescope mirror surface irregularities. These images have allowed us to infer and apply improved position offsets for the 2209 actuators which control the active surface of the primary mirror, thereby achieving a dramatic reduction in the total surface error (from 390 microns to ~240 microns, rms). We have also performed manual adjustments of the corner offsets for a few panels. The expected improvement in the radiometric aperture efficiency has been rigorously modeled and confirmed at 43 GHz and 90 GHz. The improvement in the telescope beam pattern has also been measured at 11.7 GHz with greater than 60 dB of dynamic range. Symmetric features in the beam pattern have emerged which are consistent with a repetitive pattern in the aperture due to systematic panel distortions. By computing average images for each tier of panels from the holography images, we confirm that the magnitude and direction of the panel distortions, in response to the combination of gravity and thermal gradients, are in general agreement with finite-element model predictions. The holography system is now fully integrated into the GBT control system, and by enabling the telescope staff to monitor the health of the individual actuators, it continues to be an essential tool to support high-frequency observations.

Wind-induced pointing errors are a serious concern for large-aperture high-frequency radio telescopes. In this paper, we describe the implementation of an optical quadrant detector instrument that can detect and provide a correction signal for wind-induced pointing errors on the 100m diameter Green Bank Telescope (GBT). The instrument was calibrated using a combination of astronomical measurements and metrology. We find that the main wind-induced pointing errors on time scales of minutes are caused by the feedarm being blown along the direction of the wind vector. We also find that wind-induced structural excitation is virtually non-existent. We have implemented offline software to apply pointing corrections to the data from imaging instruments such as the MUSTANG 3.3 mm bolometer array, which can recover ~70% of sensitivity lost due to wind-induced pointing errors. We have also performed preliminary tests that show great promise for correcting these pointing errors in real-time using the telescope's subreflector servo system in combination with the quadrant detector signal.

We describe phase-retrieval holography measurements of the 100-m diameter Green Bank Telescope using astronomical sources and an astronomical receiver operating at a wavelength of 7 mm. We use the technique with parameterization of the aperture in terms of Zernike polynomials and employing a large defocus, as described by Nikolic, Hills & Richer (2006). Individual measurements take around 25 minutes and from the resulting beam maps (which have peak signal to noise ratios of 200:1) we show that it is possible to produce low-resolution maps of the wavefront errors with accuracy around a hundredth of a wavelength. Using such measurements over a wide range of elevations, we have calculated a model for the wavefront-errors due to the uncompensated gravitational deformation of the telescope. This model produces a significant improvement at low elevations, where these errors are expected to be the largest; after applying the model, the aperture efficiency is largely independent of elevation. We have also demonstrated that the technique can be used to measure and largely correct for thermal deformations of the antenna, which often exceed the uncompensated gravitational deformations during daytime observing. We conclude that the aberrations induced by gravity and thermal effects are large-scale and the technique used here is particularly suitable for measuring such deformations in large millimetre wave radio telescopes.