We report on the detection of extreme giant pulses (GPs) from one of the oldest-known pulsars, the highly variable PSR B0950+08, with the Amsterdam-ASTRON Radio Transient Facility And Analysis Centre (AARTFAAC), a parallel transient detection instrument operating as a subsystem of the LOw Frequency ARray (LOFAR). During processing of our Northern Hemisphere survey for low-frequency radio transients, a sample of 275 pulses with fluences ranging from 42 to 177 kJy ms were detected in one-second snapshot images. The brightest pulses are an order of magnitude brighter than those previously reported at 42 and 74 MHz, on par with the levels observed in a previous long-term study at 103 MHz. Both their rate and fluence distribution differ between and within the various studies done to date. The GP rate is highly variable, from 0 to 30 per hour, with only two three-hour observations accounting for nearly half of the pulses detected in the 96 h surveyed. It does not vary significantly within a few-hour observation, but can vary strongly one from day to the next. The spectra appear strongly and variably structured, with emission sometimes confined to a single 195.3 kHz subband, and the pulse spectra changing on a timescale of order 10 min.

We report the experimental setup and overall results of the AARTFAAC wide-field radio survey, which consists of observing the sky within 50 deg of Zenith with a bandwidth of 3.2 MHz at a cadence of 1 s, for 545 h. This yielded nearly 4 million snapshots, two per second, of on average 4800 square degrees and a sensitivity of around 60 Jy. We find two populations of transient events, one originating from PSR B0950+08 and one from strong ionospheric lensing events, as well as a possible single extragalactic transient. We also set a strong upper limit of 1.1 all-sky per day to the rate of any other populations of fast, bright transients. Lastly, we constrain some previously detected types of transient source by comparing our detections and limits with other low-frequency radio transient surveys.

We present a method for calibrating the flux density scale for images generated by the Amsterdam ASTRON Radio Transient Facility And Analysis Centre (AARTFAAC). AARTFAAC produces a stream of all-sky images at a rate of one second in order to survey the Northern Hemisphere for short duration, low frequency transients, such as the prompt EM counterpart to gravitational wave events, magnetar flares, blazars, and other as of yet unobserved phenomena. Therefore, an independent flux density scaling solution per image is calculated via bootstrapping, comparing the measured apparent brightness of sources in the field to a reference catalogue. However, the lack of accurate flux density measurements of bright sources below 74 MHz necessitated the creation of the AARTFAAC source catalogue, at 60 MHz, which contains 167 sources across the Northern Hemisphere. Using this as a reference results in a sufficiently high number of detected sources in each image to calculate a stable and accurate flux scale per one second snapshot, in real-time.

With their wide fields of view and often relatively long coverage of any position in the sky in imaging survey mode, modern radio telescopes provide a data stream that is naturally suited to searching for rare transients. However, Radio Frequency Interference (RFI) can show up in the data stream in similar ways to such transients, and thus the normal pre-treatment of filtering RFI (flagging) may also remove astrophysical transients from the data stream before imaging. In this paper we investigate how standard flagging affects the detectability of such transients by examining the case of transient detection in an observing mode used for Low Frequency Array (LOFAR; \citep{LOFAR}) surveys. We quantify the fluence range of transients that would be detected, and the reduction of their SNR due to partial flagging. We find that transients with a duration close to the integration sampling time, as well as bright transients with durations on the order of tens of seconds, are completely flagged. For longer transients on the order of several tens of seconds to minutes, the flagging effects are not as severe, although part of the signal is lost. For these transients, we present a modified flagging strategy which mitigates the effect of flagging on transient signals. We also present a script which uses the differences between the two strategies, and known differences between transient RFI and astrophysical transients, to notify the observer when a potential transient is in the data stream.

The legacy Ooty Radio Telescope (ORT) is being reconfigured as a 264-element synthesis telescope, called the Ooty Wide Field Array (OWFA). Its antenna elements are the contiguous 1.92 m sections of the parabolic cylinder. It will operate in a 38-MHz frequency band centred at 326.5 MHz and will be equipped with a digital receiver including a 264-element spectral correlator with a spectral resolution of 48 kHz. OWFA is designed to retain the benefits of equatorial mount, continuous 9-hour tracking ability and large collecting area of the legacy telescope and use modern digital techniques to enhance the instantaneous field of view by more than an order of magnitude. OWFA has unique advantages for contemporary investigations related to large scale structure, transient events and space weather watch. In this paper, we describe the RF subsystems, digitizers and fibre optic communication of OWFA and highlight some specific aspects of the system relevant for the observations planned during the initial operation.

The Amsterdam-ASTRON Radio Transients Facility And Analysis Center (AARTFAAC) all sky monitor is a sensitive, real time transient detector based on the Low Frequency Array (LOFAR). It generates images of the low frequency radio sky with spatial resolution of 10s of arcmin, MHz bandwidths, and a time cadence of a few seconds, while simultaneously but independently observing with LOFAR. The image timeseries is then monitored for short and bright radio transients. On detection of a transient, a low latency trigger will be generated for LOFAR, which can interrupt its schedule to carry out follow-up observations of the trigger location at high sensitivity and resolutions. In this paper, we describe our heterogeneous, hierarchical design to manage the 240 Gbps raw data rate, and large scale computing to produce real-time images with minimum latency. We discuss the implementation of the instrumentation, its performance, and scalability.

The AARTFAAC project aims to implement an All-Sky Monitor (ASM), using the Low Frequency Array (LOFAR) telescope. It will enable real-time, 24x7 monitoring for low frequency radio transients over most of the sky locally visible to the LOFAR at timescales ranging from milliseconds to several days, and rapid triggering of follow-up observations with the full LOFAR on detection of potential transient candidates. These requirements pose several implementation challenges: imaging of an all-sky field of view, low latencies of processing, continuous availability and autonomous operation of the ASM. The first of these has already resulted in the correlator for the ASM being the largest in the world in terms of its number of input channels. It will generate $\sim 1.5 \cdot 10^5$ correlations per second per spectral channel when built. Test observations using existing LOFAR infrastructure were carried out to quantify and constrain crucial instrumental design criteria for the ASM. In this paper, we present an overview of the AARTFAAC data processing pipeline and illustrate some of the aforementioned challenges by showing all-sky images obtained from one of the test observations. These results provide quantitative estimates of the capabilities of the instrument.

Power-spectrum analysis is an important tool providing critical information about a signal. The range of applications includes communication-systems to DNA-sequencing. If there is interference present on a transmitted signal, it could be due to a natural cause or superimposed forcefully. In the latter case, its early detection and analysis becomes important. In such situations having a small observation window, a quick look at power-spectrum can reveal a great deal of information, including frequency and source of interference. In this paper, we present our design of a FPGA based reconfigurable platform for high performance power-spectrum analysis. This allows for the real-time data-acquisition and processing of samples of the incoming signal in a small time frame. The processing consists of computation of power, its average and peak, over a set of input values. This platform sustains simultaneous data streams on each of the four input channels.

This paper outlines some new observational and data processing techniques for enhancing the dynamic range of low frequency images obtained with the Giant Metrewave Radio Telescope. We illustrate new software tools developed to facilitate visibility editing and calibration as well as other preprocessing required to enhance the dynamic range of images from a planned survey.

A Spectral Correlator is the main component of the real time signal processing for a Radio Telescope array. The correlation of signals received at each element with every other element of the array is a classic case of an application requiring a complete graph connectivity between its data sources, as well as a very large number of simple operations to carry out the correlation. Datarates can be extremely large in order to achieve high sensitivities required for the detection of weak celestial signals. Hence, correlators are prime targets for HPC implementations. In this paper, we present the design and implementation of a massively parallel software spectral Correlator for a 44 element array. The correlator handles ~735 MB/s of incoming data from the 44 spatially distributed sources, and concurrently sustains a computational load of ~100 Gflops. We first describe how we partition the large incoming data stream into grouped datasets suited for transport over high speed serial networks, as well as ideal for processing on commodity multicore processors. An OpenMP based software correlator optimized for operation on multicore SMP systems and implemented on a set of Harpertown class dual processor machines is then presented.

A new architecture is presented for a Networked Signal Processing System (NSPS) suitable for handling the real-time signal processing of multi-element radio telescopes. In this system, a multi-element radio telescope is viewed as an application of a multi-sensor, data fusion problem which can be decomposed into a general set of computing and network components for which a practical and scalable architecture is enabled by current technology. The need for such a system arose in the context of an ongoing program for reconfiguring the Ooty Radio Telescope (ORT) as a programmable 264-element array, which will enable several new observing capabilities for large scale surveys on this mature telescope. For this application, it is necessary to manage, route and combine large volumes of data whose real-time collation requires large I/O bandwidths to be sustained. Since these are general requirements of many multi-sensor fusion applications, we first describe the basic architecture of the NSPS in terms of a Fusion Tree before elaborating on its application for the ORT. The paper addresses issues relating to high speed distributed data acquisition, Field Programmable Gate Array (FPGA) based peer-to-peer networks supporting significant on-the fly processing while routing, and providing a last mile interface to a typical commodity network like Gigabit Ethernet. The system is fundamentally a pair of two co-operative networks, among which one is part of a commodity high performance computer cluster and the other is based on Commercial-Off The-Shelf (COTS) technology with support from software/firmware components in the public domain.