Here we report a comparison between reflectance spectroscopy of meteorites under asteroidal environment (high vacuum and temperature) and Main Belt and Near Earth Asteroids spectra. Focusing on the OH absorption feature around 3{\mu}m, we show that the asteroidal environment induces a reduction of depth and width of the band, as well as a shift of the reflectance minimum. We then decompose the OH feature into several components with a new model using Exponentially Modified Gaussians. Unlike previous studies, we confirme the link between these components, the aqueous alteration history and the amount of water molecules inside of the sample, using the shape of this spectral feature only. We then apply this deconvolution model to asteroids spectra which were obtained with a space-borne telescope and two space probes, and find a strong similarity with the components detected on meteorites, and among asteroids from a same type. Based on the conclusions drawn from our meteorites experiment, we suggest to use the 3-{\mu}m band as a tracer of the alteration history of the small bodies. Using the 3-{\mu}m band only, we show that Ryugu has been heavily altered by water, which is consistent with its parent body being covered with water ice, then went through a high temperature sequence, over 400{\deg}C. We also point out that the 3-{\mu}m band of Bennu shows signs of its newly discovered surface activity.

The measured nitrogen-to-carbon ratio in comets is lower than for the Sun, a discrepancy which could be alleviated if there is an unknown reservoir of nitrogen in comets. The nucleus of comet 67P/Churyumov-Gerasimenko exhibits an unidentified broad spectral reflectance feature around 3.2 micrometers, which is ubiquitous across its surface. On the basis of laboratory experiments, we attribute this absorption band to ammonium salts mixed with dust on the surface. The depth of the band indicates that semivolatile ammonium salts are a substantial reservoir of nitrogen in the comet, potentially dominating over refractory organic matter and more volatile species. Similar absorption features appear in the spectra of some asteroids, implying a compositional link between asteroids, comets, and the parent interstellar cloud.

We have developed a new spectro-gonio radiometer, SHADOWS, to study in the laboratory the bidirectional reflectance distribution function of dark and precious samples. The instrument operates over a wide spectral range from the visible to the near-infrared and is installed in a cold room. This paper presents the scientific and technical constraints of the spectro-gonio radiometer, its design and additional capabilities, as well as the performances and limitations of the instrument.

We present here a new method to model the shape of the 3-{\mu}m absorption band in the reflectance spectra of meteorites and small bodies. The band is decomposed into several OH/H2O components using Exponentially Modified Gaussian (EMG) profiles, as well as possible organic components using Gaussian profiles when present. We compare this model to polynomial and multiple Gaussian profile fits and show that the EMGs model returns the best rendering of the shape of the band, with significantly lower residuals. We also propose as an example an algorithm to estimate the error on the band parameters using a bootstrap method. We then present an application of the model to two spectral analyses of smectites subjected to different H2O vapor pressures, and present the variations of the components with decreasing humidity. This example emphasizes the ability of this model to coherently retrieve weak bands that are hidden within much stronger ones.

Here were report on a laboratory study aiming to reproduce specificities of near-Earth Asteroid. We study how the elevated surface temperature, their surface roughness (rock or regolith), as well as observation geometry can affect the absorption features detected on asteroids. For that purpose, we selected a recent carbonaceous chondrite fall, the Mukundpura CM2 chondrite which fell in India in June 2017. Bidirectional reflectance spectroscopy was performed to analyze the effect of the geometrical configuration (incidence, emergence and azimuth angle) on the measurement. Our results show that reflectance spectra obtained under warm environment (NEA-like) tends to show shallower absorption bands compared to low-temperature conditions (MBA-like), but still detectable in our experiments under laboratory timescales. Irreversible alteration of the sample because of the warm environment (from room temperature to 250{\deg}C) has been detected as an increase of the spectral slope and a decrease of the band depths (at 0.7{\mu}m, 0.9{\mu}m and 2.7{\mu}m). Comparing the meteoritic chip and the powdered sample, we found that surface texture strongly affects the shape of the reflectance spectra of meteorites and thus of asteroids, where a dust-covered surface presents deeper absorption features. We found that all spectral parameters, such as the reflectance value, spectral slope and possible absorption bands are affected by the geometry of measurement. We observed the disappearance of the 0.7 {\mu}m absorption feature at phase angle larger than 120{\deg}, but the 3{\mu}m band remains detectable on all measured spectra.

Context: Exoplanet science has made staggering progress in the last two decades, due to the relentless exploration of new detection methods and refinement of existing ones. Yet astrometry offers a unique and untapped potential of discovery of habitable-zone low-mass planets around all the solar-like stars of the solar neighborhood. To fulfill this goal, astrometry must be paired with high precision calibration of the detector. Aims: We present a way to calibrate a detector for high accuracy astrometry. An experimental testbed combining an astrometric simulator and an interferometric calibration system is used to validate both the hardware needed for the calibration and the signal processing methods. The objective is an accuracy of 5e-6 pixel on the location of a Nyquist sampled polychromatic point spread function. Methods: The interferometric calibration system produced modulated Young fringes on the detector. The Young fringes were parametrized as products of time and space dependent functions, based on various pixel parameters. The minimization of func- tion parameters was done iteratively, until convergence was obtained, revealing the pixel information needed for the calibration of astrometric measurements. Results: The calibration system yielded the pixel positions to an accuracy estimated at 4e-4 pixel. After including the pixel position information, an astrometric accuracy of 6e-5 pixel was obtained, for a PSF motion over more than five pixels. In the static mode (small jitter motion of less than 1e-3 pixel), a photon noise limited precision of 3e-5 pixel was reached.

Theia is an astrometric mission proposed to ESA in 2014 for which one of the scientific objectives is detecting Earth-like exoplanets in the habitable zone of nearby solar-type stars. This objective requires the capability to measure stellar centroids at the precision of 1e-5 pixel. Current state-of-the-art methods for centroid estimation have reached a precision of about 3e-5 pixel at two times Nyquist sampling, this was shown at the JPL by the VESTA experiment. A metrology system was used to calibrate intra and inter pixel quantum efficiency variations in order to correct pixelation errors. The Theia consortium is operating a testbed in vacuum in order to achieve 1e-5 pixel precision for the centroid estimation. The goal is to provide a proof of concept for the precision requirement of the Theia spacecraft. The testbed consists of two main sub-systems. The first one produces pseudo stars: a blackbody source is fed into a large core fiber and lights-up a pinhole mask in the object plane, which is imaged by a mirror on the CCD. The second sub-system is the metrology, it projects young fringes on the CCD. The fringes are created by two single mode fibers facing the CCD and fixed on the mirror. In this paper we present the latest experiments conducted and the results obtained after a series of upgrades on the testbed was completed. The calibration system yielded the pixel positions to an accuracy estimated at 4e-4 pixel. After including the pixel position information, an astrometric accuracy of 6e-5 pixel was obtained, for a PSF motion over more than 5 pixels. In the static mode (small jitter motion of less than 1e-3 pixel), a photon noise limited precision of 3e-5 pixel was reached.

NEAT is an astrometric mission proposed to ESA with the objectives of detecting Earth-like exoplanets in the habitable zone of nearby solar-type stars. NEAT requires the capability to measure stellar centroids at the precision of 5e-6 pixel. Current state-of-the-art methods for centroid estimation have reached a precision of about 2e-5 pixel at two times Nyquist sampling, this was shown at the JPL by the VESTA experiment. A metrology system was used to calibrate intra and inter pixel quantum efficiency variations in order to correct pixelation errors. The European part of the NEAT consortium is building a testbed in vacuum in order to achieve 5e-6 pixel precision for the centroid estimation. The goal is to provide a proof of concept for the precision requirement of the NEAT spacecraft. The testbed consists of two main sub-systems. The first one produces pseudo stars: a blackbody source is fed into a large core fiber and lights-up a pinhole mask in the object plane, which is imaged by a mirror on the CCD. The second sub-system is the metrology, it projects young fringes on the CCD. The fringes are created by two single mode fibers facing the CCD and fixed on the mirror. In this paper we present the experiments conducted and the results obtained since July 2013 when we had the first light on both the metrology and pseudo stars. We explain the data reduction procedures we used.

NEAT is an astrometric mission proposed to ESA with the objectives of detecting Earth-like exoplanets in the habitable zone of nearby solar-type stars. NEAT requires the capability to measure stellar centroids at the precision of 5e-6 pixel. Current state-of-the-art methods for centroid estimation have reached a precision of about 2e-5 pixel at two times Nyquist sampling, this was shown at the JPL by the VESTA experiment. A metrology system was used to calibrate intra and inter pixel quantum efficiency variations in order to correct pixelation errors. The European part of the NEAT consortium is building a testbed in vacuum in order to achieve 5e-6 pixel precision for the centroid estimation. The goal is to provide a proof of concept for the precision requirement of the NEAT spacecraft. In this paper we present the metrology and the pseudo stellar sources sub-systems, we present a performance model and an error budget of the experiment and we report the present status of the demonstration. Finally we also present our first results: the experiment had its first light in July 2013 and a first set of data was taken in air. The analysis of this first set of data showed that we can already measure the pixel positions with an accuracy of about 1e-4 pixel.