sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Plunkett, S. P.

Normalized to: Plunkett, S.

5 article(s) in total. 23 co-authors, from 1 to 2 common article(s). Median position in authors list is 3,0.

[1]  oai:arXiv.org:1810.01755  [pdf] - 1760667
Modeling Inner Boundary Values at 18 Solar Radii During Solar Quiet time for Global Three-dimensional Time-Dependent Magnetohydrodynamic Numerical Simulation
Comments:
Submitted: 2018-10-02
The solar wind speed plays a key role in the transport of CME out of the Sun and ultimately determines the arrival time of CME-driven shocks in the heliosphere. Here, we develop an empirical model of the solar wind parameters at the inner boundary (18 solar radii, Rs) used in our global, 3D MHD model (G3DMHD) or other equivalent ones. The model takes solar magnetic field maps at 2.5 Rs (which is based on the Potential Field Source Surface, PFSS model) and interpolates the solar wind plasma and field out to 18 Rs using the algorithm of Wang and Sheeley [1990a]. A formula V_{18Rs} = V1 + V2 fs^{\alpha} is used to calculate the solar wind speed at 18 Rs, where V1 is in a range of 150-350 km/s, V2 is in the range of 250-500 km/s, and fs is an expansion factor, which was derived from the Wang and Sheeley (WS) algorithm at 2.5 Rs. To estimate the solar wind density and temperature at 18 Rs, we assume an incompressible solar wind and a constant total pressure. The three free parameters are obtained by adjusting simulation results to match in-situ observations (Wind) for more than 54 combination of V1, V2 and {\alpha} during a quiet solar wind interval, CR2082. We found V18Rs = (150 +/- 50) + (500 +/- 100) fs^-0.4 km/s performs reasonably well in predicting solar wind parameters at 1 AU not just for CR 2082 but other quiet solar period. Comparing results from the present study with those from WSA [Arge et al. 2000; 2004] we conclude that i) Results of using V_{18Rs} with the full rotation data (FR) as input to drive G3DMHD model is better than the results of WSA using FR, or daily updated. ii) When using a modified daily updated 4-day-advanced solar wind speed predictions WSA performs slightly better than our G3DMHD. iii) When using V_{18Rs} as input, G3DMHD model performs much better than the WSA formula. We argue the necessity of the extra angular width ({\theta}b) parameter used in WSA.
[2]  oai:arXiv.org:0908.2365  [pdf] - 27361
Stereoscopic Polar Plume Reconstructions from Stereo/Secchi Images
Comments: 25 pages, 13 figures
Submitted: 2009-08-17
We present stereoscopic reconstructions of the location and inclination of polar plumes of two data sets based on the two simultaneously recorded images taken by the EUVI telescopes in the SECCHI instrument package onboard the \emph{STEREO (Solar TErrestrial RElations Observatory)} spacecraft. The ten plumes investigated show a superradial expansion in the coronal hole in 3D which is consistent with the 2D results. Their deviations from the local meridian planes are rather small with an average of $6.47^{\circ}$. By comparing the reconstructed plumes with a dipole field with its axis along the solar rotation axis, it is found that plumes are inclined more horizontally than the dipole field. The lower the latitude is, the larger is the deviation from the dipole field. The relationship between plumes and bright points has been investigated and they are not always associated. For the first data set, based on the 3D height of plumes and the electron density derived from SUMER/\emph{SOHO} Si {\sc viii} line pair, we found that electron densities along the plumes decrease with height above the solar surface. The temperature obtained from the density scale height is 1.6 to 1.8 times larger than the temperature obtained from Mg {\sc ix} line ratios. We attribute this discrepancy to a deviation of the electron and the ion temperatures. Finally, we have found that the outflow speeds studied in the O {\sc vi} line in the plumes corrected by the angle between the line of sight and the plume orientation are quite small with a maximum of 10 $\mathrm{km s^{-1}}$. It is unlikely that plumes are a dominant contributor to the fast solar wind.
[3]  oai:arXiv.org:0903.4039  [pdf] - 22668
3D Coronal Slow Modes: Towards 3D Seismology
Comments: In press, ApJ June 2009 - 1 v697 issue
Submitted: 2009-03-24
On 2008 January 10, the twin Solar Terrestrial Relations Observatory (STEREO) A and B spacecraft conducted a high time cadence study of the solar corona with the Extreme UltraViolet Imager (EUVI) instruments with the aim of investigating coronal dynamics. Observations of the three-dimensional propagation of waves within active region coronal loops and a measurement of the true coronal slow mode speed are obtained. Intensity oscillations with a period of approximately 12 minutes are observed to propagate outwards from the base of a loop system, consistent with the slow magnetoacoustic mode. A novel analysis technique is applied to measure the wave phase velocity in the observations of the A and B spacecraft. These stereoscopic observations are used to infer the three-dimensional velocity vector of the wave propagation, with an inclination of 37 +- 6 deg to the local normal and a magnitude of 132 +- 9 and 132 +- 11 km s-1, giving the first measurement of the true coronal longitudinal slow mode speed, and an inferred temperature of 0.84 +- 12 MK and 0.84 +- 15 MK.
[4]  oai:arXiv.org:0811.3226  [pdf] - 315337
Comprehensive Observations of a Solar Minimum CME with STEREO
Comments: 27 pages, 10 figures, AASTEX v5.2, accepted by ApJ
Submitted: 2008-11-19
We perform the first kinematic analysis of a CME observed by both imaging and in situ instruments on board STEREO, namely the SECCHI, PLASTIC, and IMPACT experiments. Launched on 2008 February 4, the CME is tracked continuously from initiation to 1 AU using the SECCHI imagers on both STEREO spacecraft, and is then detected by the PLASTIC and IMPACT particle and field detectors on board STEREO-B. The CME is also detected in situ by ACE and SOHO/CELIAS at Earth's L1 Lagrangian point. The CME hits STEREO-B, ACE, and SOHO on 2008 February 7, but misses STEREO-A entirely. This event provides a good example of just how different the same event can look when viewed from different perspectives. We also demonstrate many ways in which the comprehensive and continuous coverage of this CME by STEREO improves confidence in our assessment of its kinematic behavior, with potential ramifications for space weather forecasting. The observations provide several lines of evidence in favor of the observable part of the CME being narrow in angular extent, a determination crucial for deciding how best to convert observed CME elongation angles from Sun-center to actual Sun-center distances.
[5]  oai:arXiv.org:astro-ph/9508083  [pdf] - 93139
A Search for Ultra-High Energy Counterparts to Gamma-Ray Bursts
Comments: 4 pages LaTeX with one postscript figure. This version does not use kluwer.sty and will allow automatic postscript generation
Submitted: 1995-08-18, last modified: 1995-08-24
A small air shower array operating over many years has been used to search for ultra-high energy (UHE) gamma radiation ($\geq 50$ TeV) associated with gamma-ray bursts (GRBs) detected by the BATSE instrument on the Compton Gamma-Ray Observatory (CGRO). Upper limits for a one minute interval after each burst are presented for seven GRBs located with zenith angles $\theta < 20^{\circ}$. A $4.3\sigma$ excess over background was observed between 10 and 20 minutes following the onset of a GRB on 11 May 1991. The confidence level that this is due to a real effect and not a background fluctuation is 99.8\%. If this effect is real then cosmological models are excluded for this burst because of absorption of UHE gamma rays by the intergalactic radiation fields.