Herschel observations of nearby molecular clouds suggest that interstellar filaments and prestellar cores represent two fundamental steps in the star formation process. The observations support a picture of low-mass star formation according to which ~ 0.1 pc-wide filaments form first in the cold interstellar medium, probably as a result of large-scale compression of interstellar matter by supersonic turbulent flows, and then prestellar cores arise from gravitational fragmentation of the densest filaments. Whether this scenario also applies to regions of high-mass star formation is an open question, in part because Herschel data cannot resolve the inner width of filaments in the nearest regions of massive star formation. We used the bolometer camera ArTeMiS on the APEX telescope to map the central part of the NGC6334 complex at a factor of > 3 higher resolution than Herschel at 350 microns. Combining ArTeMiS data with Herschel data allowed us to study the structure of the main filament of the complex with a resolution of 8" or < 0.07 pc at d ~ 1.7 kpc. Our study confirms that this filament is a very dense, massive linear structure with a line mass ranging from ~ 500 Msun/pc to ~ 2000 Msun/pc over nearly 10 pc. It also demonstrates that its inner width remains as narrow as W ~ 0.15 +- 0.05 pc all along the filament length, within a factor of < 2 of the characteristic 0.1 pc value found with Herschel for lower-mass filaments in the Gould Belt. While it is not completely clear whether the NGC 6334 filament will form massive stars or not in the future, it is two to three orders of magnitude denser than the majority of filaments observed in Gould Belt clouds, and yet has a very similar inner width. This points to a common physical mechanism for setting the filament width and suggests that some important structural properties of nearby clouds also hold in high-mass star forming regions.

ArTeMiS is a wide-field submillimeter camera operating at three wavelengths simultaneously (200, 350 and 450 microns). A preliminary version of the instrument equipped with the 350 microns focal plane, has been successfully installed and tested on APEX telescope in Chile during the 2013 and 2014 austral winters. This instrument is developed by CEA (Saclay and Grenoble, France), IAS (France) and University of Manchester (UK) in collaboration with ESO. We introduce the mechanical and optical design, as well as the cryogenics and electronics of the ArTeMiS camera. ArTeMiS detectors are similar to the ones developed for the Herschel PACS photometer but they are adapted to the high optical load encountered at APEX site. Ultimately, ArTeMiS will contain 4 sub-arrays at 200 microns and 2x8 sub-arrays at 350 and 450 microns. We show preliminary lab measurements like the responsivity of the instrument to hot and cold loads illumination and NEP calculation. Details on the on-sky commissioning runs made in 2013 and 2014 at APEX are shown. We used planets (Mars, Saturn, Uranus) to determine the flat-field and to get the flux calibration. A pointing model was established in the first days of the runs. The average relative pointing accuracy is 3 arcsec. The beam at 350 microns has been estimated to be 8.5 arcsec, which is in good agreement with the beam of the 12 m APEX dish. Several observing modes have been tested, like On-The-Fly for beam-maps or large maps, spirals or raster of spirals for compact sources. With this preliminary version of ArTeMiS, we concluded that the mapping speed is already more than 5 times better than the previous 350 microns instrument at APEX. The median NEFD at 350 microns is 600 mJy.s1/2, with best values at 300 mJy.s1/2. The complete instrument with 5760 pixels and optimized settings will be installed during the first half of 2015.

We present APEX/P-ArT\'eMiS 450\mu m continuum observations of RCW 36 and the adjacent ridge, a high-mass high-column density filamentary structure at the centre of the Vela C molecular cloud. These observations, at higher resolution than Herschel's SPIRE camera, reveal clear fragmentation of the central star-forming ridge. Combined with PACS far-infrared and SPIRE sub-millimetre observations from the Herschel HOBYS project we build a high resolution column density map of the region mapped with P-ArT\'eMiS. We extract the radial density profile of the Vela C ridge which with a ~ 0.1pc central width is consistent with that measured for low-mass star-forming filaments in the Herschel Gould Belt survey. Direct comparison with Serpens South, of the Gould Belt Aquila complex, reveals many similarities between the two regions. Despite likely different formation mechanisms and histories, the Vela C ridge and Serpens South filament share common characteristics, including their filament central widths.

We present a search for Herschel-PACS counterparts of dust-obscured, high-redshift objects previously selected at submillimeter and millimeter wavelengths in the Great Observatories Origins Deep Survey North field. We detect 22 of 56 submillimeter galaxies (39%) with a SNR of >=3 at 100 micron down to 3.0 mJy, and/or at 160 micron down to 5.7 mJy. The fraction of SMGs seen at 160 micron is higher than that at 100 micron. About 50% of radio-identified SMGs are associated with PACS sources. We find a trend between the SCUBA/PACS flux ratio and redshift, suggesting that these flux ratios could be used as a coarse redshift indicator. PACS undetected submm/mm selected sources tend to lie at higher redshifts than the PACS detected ones. A total of 12 sources (21% of our SMG sample) remain unidentified and the fact that they are blank fields at Herschel-PACS and VLA 20 cm wavelength may imply higher redshifts for them than for the average SMG population (e.g., z>3-4). The Herschel-PACS imaging of these dust-obscured starbursts at high-redshifts suggests that their far-infrared spectral energy distributions have significantly different shapes than template libraries of local infrared galaxies.

A new concept of bolometer arrays is used for the imager of PACS, one of the three instruments aboard the future Herschel space observatory. Within the framework of PACS photometer characterization, irradiation tests were performed on a dedicated bolometer array in order to study long-term and short-term radiation effects. The main objective was to study particles impacts on the detectors applicable to future observations in orbit and possible hard and/or soft curing to restore its performances. Cobalt-60 gamma ray irradiations did not show significant degradation, so we mainly focused on single events effects (SEE). Protons and alphas irradiations were then performed at the Van de Graaf tandem accelerator at the Institut de Physique Nucleaire (IPN, Orsay, France), respectively at 20MeV and 30MeV. Observation showed that the shape of signal perturbations clearly depends on the location of the impacts either on the detector itself or the read-out circuit. Software curing has then to be anticipated in order to deglitch the signal. This test gives also a unique opportunity to measure some parameters of the detector: electrical crosstalk and thermo- electrical time constant. However a detailed bolometer model is necessary to understand the contribution of the thermal response in relation with the electrical response. It will be the second step of our study. Finally the complete radiation evaluation proved that this detector can be used in spatial experiments.

We summarize the first results from the Gould Belt survey, obtained toward the Aquila Rift and Polaris Flare regions during the 'science demonstration phase' of Herschel. Our 70-500 micron images taken in parallel mode with the SPIRE and PACS cameras reveal a wealth of filamentary structure, as well as numerous dense cores embedded in the filaments. Between ~ 350 and 500 prestellar cores and ~ 45-60 Class 0 protostars can be identified in the Aquila field, while ~ unbound starless cores and no protostars are observed in the Polaris field. The prestellar core mass function (CMF) derived for the Aquila region bears a strong resemblance to the stellar initial mass function (IMF), already confirming the close connection between the CMF and the IMF with much better statistics than earlier studies. Comparing and contrasting our Herschel results in Aquila and Polaris, we propose an observationally-driven scenario for core formation according to which complex networks of long, thin filaments form first within molecular clouds, and then the densest filaments fragment into a number of prestellar cores via gravitational instability.

Aims. Expanding HII regions and propagating shocks are common in the environment of young high-mass star-forming complexes. They can compress a pre-existing molecular cloud and trigger the formation of dense cores. We investigate whether these phenomena can explain the formation of high-mass protostars within an infrared dark cloud located at the position of G327.3-0.6 in the Galactic plane, in between two large infrared bubbles and two HII regions. Methods: The region of G327.3-0.6 was imaged at 450 ? m with the CEA P-ArT\'eMiS bolometer array on the Atacama Pathfinder EXperiment telescope in Chile. APEX/LABOCA and APEX-2A, and Spitzer/IRAC and MIPS archives data were used in this study. Results: Ten massive cores were detected in the P-ArT\'eMiS image, embedded within the infrared dark cloud seen in absorption at both 8 and 24 ?m. Their luminosities and masses indicate that they form high-mass stars. The kinematical study of the region suggests that the infrared bubbles expand toward the infrared dark cloud. Conclusions: Under the influence of expanding bubbles, star formation occurs in the infrared dark areas at the border of HII regions and infrared bubbles.

Context: The earliest phases of massive star formation are currently much debated. Aims. In an effort to make progress, we took a census of Class0-like protostellar dense cores in the NGC 3576 region, one of the nearest and most luminous embedded sites of high-mass star formation in the Galaxy. Methods: We used the P-ArTeMiS bolometer camera on the APEX telescope to produce the first 450-micron dust continuum map of the filamentary dense clump associated with NGC 3576. Results: Combining our 450-micron observations with existing data at other wavelengths, we have identified seven massive protostellar sources along the NGC 3576 filament and placed them in the M_env - L_bol evolutionary diagram for protostars. Conclusions: Comparison with theoretical evolutionary tracks suggests that these seven protostellar sources will evolve into massive stars with masses M* ~ 15-50 Msun. Four sources are classified as candidate high-mass Class 0 objects, two sources as massive Class I objects, and one source appears to be at an intermediate stage.

The development program of the flight model imaging camera for the PACS instrument on-board the Herschel spacecraft is nearing completion. This camera has two channels covering the 60 to 210 microns wavelength range. The focal plane of the short wavelength channel is made of a mosaic of 2x4 3-sides buttable bolometer arrays (16x16 pixels each) for a total of 2048 pixels, while the long wavelength channel has a mosaic of 2 of the same bolometer arrays for a total of 512 pixels. The 10 arrays have been fabricated, individually tested and integrated in the photometer. They represent the first filled arrays of fully collectively built bolometers with a cold multiplexed readout, allowing for a properly sampled coverage of the full instrument field of view. The camera has been fully characterized and the ground calibration campaign will take place after its delivery to the PACS consortium in mid 2006. The bolometers, working at a temperature of 300 mK, have a NEP close to the BLIP limit and an optical bandwidth of 4 to 5 Hz that will permit the mapping of large sky areas. This paper briefly presents the concept and technology of the detectors as well as the cryocooler and the warm electronics. Then we focus on the performances of the integrated focal planes (responsivity, NEP, low frequency noise, bandwidth).

A new kind of bolometric architecture has been successfully developed for the PACS photometer onboard the Herschel submillimeter observatory. These new generation CCD-like arrays are buttable and enable the conception of large fully sampled focal planes. We present a feasibility study of the adaptation of these bolometer arrays to ground-based submillimeter telescopes. We have developed an electro-thermal numerical model to simulate the performances of the bolometers under specific ground-based conditions (different wavelengths and background powers for example). This simulation permits to determine the optimal parameters for each condition and shows that the bolometers can be background limited in each transmission window between 200 and 450 microns. We also present a new optical system that enables to have a maximum absorption of the bolometer in each atmospheric windows. The description of this system and measurements are showed.