sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Pendharkar, J. K.

Normalized to: Pendharkar, J.

5 article(s) in total. 13 co-authors, from 1 to 3 common article(s). Median position in authors list is 3,0.

[1]  oai:arXiv.org:1003.0519  [pdf] - 126188
Comparative study of different scattering geometries for the proposed Indian X-ray polarization measurement experiment using Geant4
Comments: 14 pages, 6 figures, accepted for publication in "Nuclear Inst. and Methods in Physics Research, A"
Submitted: 2010-03-02
Polarization measurements in X-rays can provide unique opportunity to study the behavior of matter and radiation under extreme magnetic fields and extreme gravitational fields. Unfortunately, over past two decades, when X-ray astronomy witnessed multiple order of magnitude improvement in temporal, spatial and spectral sensitivities, there is no (or very little) progress in the field of polarization measurements of astrophysical X-rays. Recently, a proposal has been submitted to ISRO for a dedicated small satellite based experiment to carry out X-ray polarization measurement, which aims to provide the first X-ray polarization measurements since 1976. This experiment will be based on the well known principle of polarization measurement by Thomson scattering and employs the baseline design of a central low Z scatterer surrounded by X-ray detectors to measure the angular intensity distribution of the scattered X-rays. The sensitivity of such experiment is determined by the collecting area, scattering and detection efficiency, X-ray detector background, and the modulation factor. Therefore, it is necessary to carefully select the scattering geometry which can provide the highest modulation factor and thus highest sensitivity within the specified experimental constraints. The effective way to determine optimum scattering geometry is by studying various possible scattering geometries by means of Monte Carlo simulations. Here we present results of our detailed comparative study based on Geant4 simulations of five different scattering geometries which can be considered within the weight and size constraints of the proposed small satellite based X-ray polarization measurement experiment.
[2]  oai:arXiv.org:0903.5205  [pdf] - 315771
X-ray variability of AGNs in the soft and the hard X-ray bands
Comments: 17 pages, 15 Postscript figures, 3 tables, accepted for publication in ApJ
Submitted: 2009-03-30
We investigate the X-ray variability characteristics of hard X-ray selected AGNs (based on Swift/BAT data) in the soft X-ray band using the RXTE/ASM data. The uncertainties involved in the individual dwell measurements of ASM are critically examined and a method is developed to combine a large number of dwells with appropriate error propagation to derive long duration flux measurements (greater than 10 days). We also provide a general prescription to estimate the errors in variability derived from rms values from unequally spaced data. Though the derived variability for individual sources are not of very high significance, we find that, in general, the soft X-ray variability is higher than those in hard X-rays and the variability strengths decrease with energy for the diverse classes of AGN. We also examine the strength of variability as a function of the break time scale in the power density spectrum (derived from the estimated mass and bolometric luminosity of the sources) and find that the data are consistent with the idea of higher variability at time scales longer than the break time scale.
[3]  oai:arXiv.org:astro-ph/0703074  [pdf] - 316903
Anti-correlated hard X-ray time lags in Galactic black hole sources
Comments: 14 pages, 7 figures, accepted for publication in ApJ
Submitted: 2007-03-05
We investigate the accretion disk geometry in Galactic black hole sources by measuring the time delay between soft and hard X-ray emissions. Similar to the recent discoveries of anti-correlated hard X-ray time lags in Cyg X-3 and GRS 1915+105, we find that the hard X-rays are anti-correlated with soft X-rays with a significant lag in another source: XTE J1550-564. We also find the existence of pivoting in the model independent X-ray spectrum during these observations. We investigate time-resolved X-ray spectral parameters and find that the variation in these parameters is consistent with the idea of a truncated accretion disk. The QPO frequency, which is a measure of the size of truncated accretion disk, too changes indicating that the geometric size of the hard X-ray emitting region changes along with the spectral pivoting and soft X-ray flux. Similar kind of delay is also noticed in 4U 1630-47.
[4]  oai:arXiv.org:astro-ph/0506325  [pdf] - 73725
Anti-correlated hard X-ray time lag in GRS 1915+105: evidence for a truncated accretion disc
Comments: Accepted in ApJ: (to appear on 1 Oct, 2005 issue)
Submitted: 2005-06-14
Multi-wavelength observations of Galactic black hole candidate sources indicate a close connection between the accretion disk emission and the jet emission. The recent discovery of an anti-correlated time lag between the soft and hard X-rays in Cygnus X-3 (Choudhury & Rao 2004) constrains the geometric picture of the disk-jet connection into a truncated accretion disk, the truncation radius being quite close to the black hole. Here we report the detection of similar anti-correlated time lag in the superluminal jet source GRS 1915+105. We show the existence of the pivoting in the X-ray spectrum during the delayed anti-correlation and we also find that the QPO parameters change along with the spectral pivoting. We explore theoretical models to understand this phenomenon.
[5]  oai:arXiv.org:astro-ph/0301189  [pdf] - 1468479
Multi-transonic Black Hole Accretion Discs with Isothermal Standing Shocks
Comments: Final version accepted for publication in Astrophysical Journal (ApJ). 6 black and white encapsulated post-script figures. For high resolution Fig. 5 & Fig. 6, please write to <tapas@astro.ucla.edu>. aastex.cls, emulateapj5.sty and apjfonts.sty used
Submitted: 2003-01-10, last modified: 2003-04-02
In this work we would like to address the issue of shock formation in black hole accretion discs. We provide a {\it generalized two parameter solution scheme} for multi-transonic, accretion and wind around Schwarzschild black holes, by mainly concentrating on accretion solutions which may contain steady, standing isothermal shocks. Such shocks conserve flow temperature by the dissipation of energy at the shock location.Unlike previous works in this field, our calculation is {\it not} restricted to any particular kind of post-Newtonian gravitational potentials, rather we use {\it all} available pseudo-Schwarzschild potentials to formulate and solve the equations governing the accretion and wind only in terms of flow temperature $T$ and specific angular momentum $\lambda$ of the flow. Our generalized formalism assures that the shock formation is not just an artifact of a particular type of gravitational potential, rather inclusion of all available black-hole potentials demonstrates a substantially extended zone of parameter space allowing for the possibility of shock formation. We thus arrive at the conclusion that the standing shocks are essential ingredients in rotating, advective accretion flows of isothermal fluid around a non-spinning astrophysical black hole. Types of shocks discussed in this paper may appear to be `bright' because of the huge amount of energy dissipation at shock, and the quick removal of such energy to maintain the isothermality may power the strong X-ray flares recently observed to be emerged from our Galactic centre. The results are discussed in connection to other astrophysical phenomena of related interest, such as the QPO behaviour of galactic black hole candidates. (Abridged).