We describe the objectives, design and predicted performance of Clover, which is a ground-based experiment to measure the faint ``B-mode'' polarisation pattern in the cosmic microwave background (CMB). To achieve this goal, clover will make polarimetric observations of approximately 1000 deg^2 of the sky in spectral bands centred on 97, 150 and 225 GHz. The observations will be made with a two-mirror compact range antenna fed by profiled corrugated horns. The telescope beam sizes for each band are 7.5, 5.5 and 5.5 arcmin, respectively. The polarisation of the sky will be measured with a rotating half-wave plate and stationary analyser, which will be an orthomode transducer. The sky coverage combined with the angular resolution will allow us to measure the angular power spectra between 20 < l < 1000. Each frequency band will employ 192 single polarisation, photon noise limited TES bolometers cooled to 100 mK. The background-limited sensitivity of these detector arrays will allow us to constrain the tensor-to-scalar ratio to 0.026 at 3sigma, assuming any polarised foreground signals can be subtracted with minimal degradation to the 150 GHz sensitivity. Systematic errors will be mitigated by modulating the polarisation of the sky signals with the rotating half-wave plate, fast azimuth scans and periodic telescope rotations about its boresight. The three spectral bands will be divided into two separate but nearly identical instruments - one for 97 GHz and another for 150 and 225 GHz. The two instruments will be sited on identical three-axis mounts in the Atacama Desert in Chile near Pampa la Bola. Observations are expected to begin in late 2009.

Studying transient phenomena with the Very Long Baseline Interferometry (VLBI) technique faces severe difficulties because the turnaround time of the experiments from the observations to the scientific result is rather long. The e-VLBI technique has made it possible to transfer the data from a number of European VLBI Network (EVN) telescopes to the central data processor at JIVE through optical fibres, and correlate them in real time. The main goal of this paper is to introduce this rapidly developing new technique, by presenting observational results from a recent experiment. We observed SN2001em, a Type Ib/c supernova with an e-VLBI array and the Multi-Element Radio Linked Interferometer Network (MERLIN) in the UK. The source is marginally detected in our observations. We cannot make definite conclusions whether it is resolved at 1.6 GHz or not. Our data show that SN2001em either started fading in the last couple of months, or its radio spectrum is inverted at low frequencies,indicating free-free or synchrotron self-absorption. This is quite unusual, but not unprecedented in radio SNe.

Spurred by the advent of disk-based recording systems and the nearly explosive increase of internet bandwidth, eVLBI (Parsley et al. 2004) has undergone a remarkable development over the past two years. From ftp-based transfers of small amounts of astronomical data, through near real-time correlation (disk-buffered at the correlator), it has culminated this spring in the first three telescope real-time correlation at JIVE (Onsala, Westerbork and Jodrell Bank). In this paper we will give a review of this development and the current state of affairs. We will also address the current limitations and the way we may improve both bandwidth and reliability and finally we will discuss the opportunities a true high-bandwidth real-time VLBI correlator will provide.

The EVN MkIV data processor is being equipped with a high data output capability, called PCInt. In its next phase it will allow very high data output rates, up to 160 Mb/s. This functionality is required for the high spectral resolution that will be offered with recirculation. Moreover, VLBI observations traditionally focus on a small patch of sky and image typically a few 100 mas around a bright source. High spectral and time resolution is needed to image a larger area of the sky, up to the primary beam of the individual telescopes. After the upgrade such high resolution data will become the standard product. From the archive of high resolution data it will be possible to image many sources in each field of view around the original targets.

Traditionally VLBI observations focus on a small patch of sky and image typically a few 100 mas around a bright source, which is often used to self-calibrate the data. High spectral and time resolution is needed to image a larger area, in principle up to the primary beam of the individual telescopes. The EVN MkIV data processor at JIVE is being upgraded to make such high resolution data its standard product. From the archive of high resolution data it will be possible to image many sources in each field of view around the original targets.