Normalized to: Papa, D.
[1]
oai:arXiv.org:astro-ph/0509467 [pdf] - 76049
Dual frequency 230/690 GHz interferometry at the Submillimeter Array
Hunter, Todd R.;
Barrett, John W.;
Blundell, Raymond;
Christensen, Robert D.;
Kimberk, Robert S.;
Leiker, Steven P.;
Marrone, Daniel P.;
Paine, Scott N.;
Papa, D. Cosmo;
Patel, Nimesh;
Riddle, Patricia;
Smith, Michael J.;
Sridharan, T. K.;
Tong, C. Y. Edward;
Young, Ken H.;
Zhao, Jun-Hui
Submitted: 2005-09-15
The Submillimeter Array (SMA), a collaboration between the Smithsonian
Astrophysical Observatory and the Academica Sinica Institute for Astronomy and
Astrophysics of Taiwan, is an eight-element radio-interferometer designed to
operate throughout the major atmospheric windows from about 180 to 900 GHz. In
an effort to mitigate the effects of atmospheric instabilities which limit the
phase coherence of the array especially in the higher frequency bands, the
array was designed to allow simultaneous operation of a low frequency receiver
(<350 GHz) with a high frequency receiver (>330 GHz). The overlap region of
330-350 GHz was included to facilitate dual polarization measurements in the
frequency range considered to offer the highest sensitivity for continuum
observations with the array.
So far, the array is equipped with working SIS receivers covering the
frequency ranges 176-256 GHz, 260-350 GHz, and 600-700 GHz, and single
frequency operation has been routine in the lower two frequency bands for the
past year. More recently, with the completion of IF hardware required to make
full use of the SMA cross-correlator, dual receiver operation became possible.
We have since made a number of Galactic and extra-galactic astronomical
observations in dual-band mode with the hopes of using the 230 GHz receiver as
a phase reference to enable improved interferometry in the 650 GHz band. We
will present the current antenna and receiver performance, some of the first
interferometric images in the 650 GHz receiver band, and our initial attempts
at phase transfer.
[2]
oai:arXiv.org:astro-ph/0405530 [pdf] - 65050
A map of OMC-1 in CO 9-8
Marrone, D. P.;
Battat, J.;
Bensch, F.;
Blundell, R.;
Diaz, M.;
Gibson, H.;
Hunter, T.;
Meledin, D.;
Paine, S.;
Papa, D. C.;
Radford, S. J. E.;
Smith, M.;
Tong, E.
Submitted: 2004-05-26, last modified: 2004-09-06
The distribution of 12C16O J=9-8 (1.037 THz) emission has been mapped in
OMC-1 at 35 points with 84" resolution. This is the first map of this source in
this transition and only the second velocity-resolved ground-based observation
of a line in the terahertz frequency band. There is emission present at all
points in the map, a region roughly 4' by 6' in size, with peak antenna
temperature dropping only near the edges. Away from the Orion KL outflow, the
velocity structure suggests that most of the emission comes from the OMC-1
photon-dominated region, with a typical linewidthof 3-6 km/s. Large velocity
gradient modeling of the emission in J=9-8 and six lower transitions suggests
that the lines originate in regions with temperatures around 120 K and
densities of at least 10^(3.5) cm^(-3) near theta^(1) C Ori and at the Orion
Bar, and from 70 K gas at around 10^(4) cm^(-3) southeast and west of the bar.
These observations are among the first made with the 0.8 m Smithsonian
Astrophysical Observatory Receiver Lab Telescope, a new instrument designed to
observe at frequencies above 1 THz from an extremely high and dry site in
northern Chile.
[3]
oai:arXiv.org:astro-ph/0406290 [pdf] - 65447
Characterization and Status of a Terahertz Telescope
Submitted: 2004-06-11
The Receiver Lab Telescope (RLT) is a ground-based terahertz observatory,
located at an altitude of 5525 m on Cerro Sairecabur, Chile. The RLT has been
in operation since late 2002, producing the first well-calibrated astronomical
data from the ground at frequencies above 1 THz. We discuss the status of this
telescope after 18 months of operation and plans for the upcoming observing
season.
There are many practical challenges to operating a telescope at these
frequencies, including difficulties in determining the pointing, measuring the
telescope beam and efficiency, and calibrating data, resulting from high
receiver noise, receiver gain instabilities, and low atmospheric transmission.
We present some of the techniques we have employed for the RLT, including the
use of atmospheric absorption lines in the place of continuum measurements for
efficiency and beam measurements, and the utility of a Fourier-transform
spectrometer for producing reliable data calibration.