We analyze data from the Solar and Heliospheric Observatory to produce global maps of coronal outflow velocities and densities in the regions where the solar wind is undergoing acceleration. The maps use UV and white light coronal data obtained from the Ultraviolet Coronagraph Spectrometer and the Large Angle Spectroscopic Coronagraph, respectively, and a Doppler dimming analysis to determine the mean outflow velocities. The outflow velocities are defined on a sphere at 2.3 Rs from Sun-center and are organized by Carrington Rotations during the solar minimum period at the start of solar cycle 23. We use the outflow velocity and density maps to show that while the solar minimum corona is relatively stable during its early stages, the shrinkage of the north polar hole in the later stages leads to changes in both the global areal expansion of the coronal hole and the derived internal flux tube expansion factors of the solar wind. The polar hole areal expansion factor and the flux tube expansion factors (between the coronal base and 2.3 Rs) start out as super-radial but then they become more nearly radial as the corona progresses away from solar minimum. The results also support the idea that the largest flux tube expansion factors are located near the coronal hole/streamer interface, at least during the deepest part of the solar minimum period.

In February 2011 we proposed a NASA Explorer Mission of Opportunity program to develop and operate a large-aperture ultraviolet coronagraph spectrometer called the Coronal Physics Investigator (CPI) as an attached International Space Station (ISS) payload. The primary goal of this program is to identify and characterize the physical processes that heat and accelerate the primary and secondary components of the fast and slow solar wind. In addition, CPI can make key measurements needed to understand CMEs. UVCS/SOHO allowed us to identify what additional measurements need to be made to answer the fundamental questions about how solar wind streams are produced, and CPI's next-generation capabilities were designed specifically to make those measurements. Compared to previous instruments, CPI provides unprecedented sensitivity, a wavelength range extending from 25.7 to 126 nm, higher temporal resolution, and the capability to measure line profiles of He II, N V, Ne VII, Ne VIII, Si VIII, S IX, Ar VIII, Ca IX, and Fe X, never before seen in coronal holes above 1.3 solar radii. CPI will constrain the properties and effects of coronal MHD waves by (1) observing many ions over a large range of charge and mass, (2) providing simultaneous measurements of proton and electron temperatures to probe turbulent dissipation mechanisms, and (3) measuring amplitudes of low-frequency compressive fluctuations. CPI is an internally occulted ultraviolet coronagraph that provides the required high sensitivity without the need for a deployable boom, and with all technically mature hardware including an ICCD detector. A highly experienced Explorer and ISS contractor, L-3 Com Integrated Optical Systems and Com Systems East, will provide the tracking and pointing system as well as the instrument, and the integration to the ISS.

We have measured the physical properties of polar coronal holes from the minimum activity phase of solar cycle 23 (1996-1997) to the present minimum of solar cycle 24 (2007-2009) using the UVCS instrument on SOHO. Observations in H I Lyman alpha (121.6 nm) and O VI (103.2, 103.7 nm) provide spectroscopic diagnostics of proton and O5+ bulk outflow velocities and velocity distributions as a function of heliocentric distance above the poles of the Sun. These observations have allowed us to follow the changes in the physical properties of the polar coronal holes during solar cycle 23 and its approach to the current minimum. Recent ground- and space-based observations have reported a variety of phenomena associated with the current minimum. We present the comparison of observed oxygen line intensities, line ratios, and profiles for polar coronal holes at both minima and during solar cycle 23 and show how this new minimum manifests itself in the ultraviolet corona. The comparison of the physical properties of these two minima as seen by UVCS in the extended corona, now possible for the first time, may provide crucial empirical constraints on models of extended coronal heating and acceleration for the fast solar wind.

We present a detailed analysis of oxygen ion velocity distributions in the extended solar corona, based on observations made with the Ultraviolet Coronagraph Spectrometer (UVCS) on the SOHO spacecraft. Polar coronal holes at solar minimum are known to exhibit broad line widths and unusual intensity ratios of the O VI 1032, 1037 emission line doublet. The traditional interpretation of these features has been that oxygen ions have a strong temperature anisotropy, with the temperature perpendicular to the magnetic field being much larger than the temperature parallel to the field. However, recent work by Raouafi and Solanki suggested that it may be possible to model the observations using an isotropic velocity distribution. In this paper we analyze an expanded data set to show that the original interpretation of an anisotropic distribution is the only one that is fully consistent with the observations. It is necessary to search the full range of ion plasma parameters to determine the values with the highest probability of agreement with the UVCS data. The derived ion outflow speeds and perpendicular kinetic temperatures are consistent with earlier results, and there continues to be strong evidence for preferential ion heating and acceleration with respect to hydrogen. At heliocentric heights above 2.1 solar radii, every UVCS data point is more consistent with an anisotropic distribution than with an isotropic distribution. At heights above 3 solar radii, the exact probability of isotropy depends on the electron density chosen to simulate the line-of-sight distribution of O VI emissivity. (abridged abstract)

The energy released in a solar flare is partitioned between thermal and non-thermal particle energy and lost to thermal conduction and radiation over a broad range of wavelengths. It is difficult to determine the conductive losses and the energy radiated at transition region temperatures during the impulsive phases of flares. We use UVCS measurements of O VI photons produced by 5 flares and subsequently scattered by O VI ions in the corona to determine the 5.0 < log T < 6.0 transition region luminosities. We compare them with the rates of increase of thermal energy and the conductive losses deduced from RHESSI and GOES X-ray data using areas from RHESSI images to estimate the loop volumes, cross-sectional areas and scale lengths. The transition region luminosities during the impulsive phase exceed the X-ray luminosities for the first few minutes, but they are smaller than the rates of increase of thermal energy unless the filling factor of the X-ray emitting gas is ~ 0.01. The estimated conductive losses from the hot gas are too large to be balanced by radiative losses or heating of evaporated plasma, and we conclude that the area of the flare magnetic flux tubes is much smaller than the effective area measured by RHESSI during this phase of the flares. For the 2002 July 23 flare, the energy deposited by non-thermal particles exceeds the X-ray and UV energy losses and the rate of increase of the thermal energy.