Chemical extraction using a molecular recognition resin named "Empore Radium Rad Disk" was developed to improve sensitivity for the low concentration of radium (Ra). Compared with the previous method, the extraction process speed was improved by a factor of three and the recovery rate for $^{226}$Ra was also improved from 81$\pm$4% to $>$99.9%. The sensitivity on the 10$^{-1}$ mBq level was achieved using a high purity germanium detector. This improved method was applied to determine $^{226}$Ra in Gd$_2$(SO$_4$)$_3{\cdot}$8H$_2$O which will be used in the Super-Kamiokande Gadolinium project. The improvement and measurement results are reported in this paper.

We established a production method of a good millimeter-wave absorber by using a 3D-printed mold. The mold has a periodic pyramid shape, and an absorptive material is filled into the mold. This shape reduces the surface reflection. The 3D-printed mold is made from a transparent material in the millimeter-wave range. Therefore, unmolding is not necessary. A significant benefit of this production method is easy prototyping with various shapes and various absorptive materials. We produced a test model and used a two-component epoxy encapsulant as the absorptive material. The test model achieved a low reflectance: $\sim 1\%$ at 100 GHz. The absorber is sometimes maintained at a low temperature condition for cases in which superconducting detectors are used. Therefore, cryogenic performance is required in terms of a mechanical strength for the thermal cycles, an adhesive strength, and a sufficient thermal conductivity. We confirmed the test-model strength by immersing the model into a liquid-nitrogen bath.

We report a search for astronomical neutrinos in the energy region from several GeV to TeV in the direction of the blazar TXS0506+056 using the Super-Kamiokande detector following the detection of a 100 TeV neutrino from the same location by the IceCube collaboration. Using Super-Kamiokande neutrino data across several data samples observed from April 1996 to February 2018 we have searched for both a total excess above known backgrounds across the entire period as well as localized excesses on smaller time scales in that interval. No significant excess nor significant variation in the observed event rate are found in the blazar direction. Upper limits are placed on the electron and muon neutrino fluxes at 90\% confidence level as $6.03 \times 10^{-7}$ and $4.52 \times 10^{-7}$ to $9.26 \times 10^{-10}$ [${\rm erg}/{\rm cm}^2/{\rm s}$], respectively.

Supernova detection is a major objective of the Super-Kamiokande (SK) experiment. In the next stage of SK (SK-Gd), gadolinium (Gd) sulfate will be added to the detector, which will improve the ability of the detector to identify neutrons. A core-collapse supernova will be preceded by an increasing flux of neutrinos and anti-neutrinos, from thermal and weak nuclear processes in the star, over a timescale of hours; some of which may be detected at SK-Gd. This could provide an early warning of an imminent core-collapse supernova, hours earlier than the detection of the neutrinos from core collapse. Electron anti-neutrino detection will rely on inverse beta decay events below the usual analysis energy threshold of SK, so Gd loading is vital to reduce backgrounds while maximising detection efficiency. Assuming normal neutrino mass ordering, more than 200 events could be detected in the final 12 hours before core collapse for a 15-25 solar mass star at around 200 pc, which is representative of the nearest red supergiant to Earth, $\mathrm{\alpha}$Ori (Betelgeuse). At a statistical false alarm rate of 1 per century, detection could be up to 10 hours before core collapse, and a pre-supernova star could be detected by SK-Gd up to 600 pc away. A pre-supernova alert could be provided to the astrophysics community following gadolinium loading.

Asteroid (162173) Ryugu is the target object of Hayabusa2, an asteroid exploration and sample return mission led by Japan Aerospace Exploration Agency (JAXA). Ground-based observations indicate that Ryugu is a C-type near-Earth asteroid with a diameter of less than 1 km, but the knowledge of its detailed properties is still very limited. This paper summarizes our best understanding of the physical and dynamical properties of Ryugu based on remote sensing and theoretical modeling. This information is used to construct a design reference model of the asteroid that is used for formulation of mission operations plans in advance of asteroid arrival. Particular attention is given to the surface properties of Ryugu that are relevant to sample acquisition. This reference model helps readers to appropriately interpret the data that will be directly obtained by Hayabusa2 and promotes scientific studies not only for Ryugu itself and other small bodies but also for the Solar System evolution that small bodies shed light on.

Development of MITSuME is reported. Two 50-cm optical telescopes have been built at Akeno in Yamanashi prefecture and at Okayama Astrophysical Observatory (OAO) in Okayama prefecture. Three CCD cameras for simultaneous g'RcIc photometry are to be mounted on each focal plane, covering a wide FOV of about 30" x 30". The limiting magnitude at V is fainter than 18. In addition to these two optical telescopes, a 91-cm IR telescope with a 1 deg x 1 deg field of view is being built at OAO, which performs photometry in YJHK bands. These robotic telescopes can start the observation of counterparts of a GRB within a minute from an alert. We aim to obtain photometric redshifts exceeding 10 with these telescopes. The performance and the current construction status of the telescopes are presented.

By using the high-dispersion spectra of 14 bright planet-harboring stars (along with 4 reference stars) observed with the new coude echelle spectrograph at Okayama Astrophysical Observatory, we investigated the abundances of volatile elements (C, N, O, S, Zn; low condensation temperature Tc) in order to examine whether these show any significant difference compared to the abundances of other refractory elements (Si, Ti, V, Fe, Co, Ni; high Tc) which are known to be generally overabundant in those stars with planets, since a Tc-dependence is expected if the cause of such a metal-richness is due to the accretion of solid planetesimals onto the host star. We found, however, that all elements we studied behave themselves quite similarly to Fe (i.e., [X/Fe]~0) even for the case of volatile elements, which may suggest that the enhanced metallicity in those planet-bearing stars is not so much an acquired character (by accretion of rocky material) as rather primordial.