The LOng Range Reconnaissance Imager (LORRI) is a panchromatic (360--910 nm), narrow-angle (field of view = 0.29 deg), high spatial resolution (pixel scale = 1.02 arcsec) visible light imager used on NASA's New Horizons (NH) mission for both science observations and optical navigation. Calibration observations began several months after the NH launch on 2006 January 19 and have been repeated annually throughout the course of the mission, which is ongoing. This paper describes the in-flight LORRI calibration measurements, and the results derived from our analysis of the calibration data. LORRI has been remarkably stable over time with no detectable changes (at the 1% level) in sensitivity or optical performance since launch. By employing 4 by 4 re-binning of the CCD pixels during read out, a special spacecraft tracking mode, exposure times of 30 sec, and co-addition of approximately 100 images, LORRI can detect unresolved targets down to V = 22 (SNR=5). LORRI images have an instantaneous dynamic range of 3500, which combined with exposure time control ranging from 0ms to 64,967 ms in 1ms steps supports high resolution, high sensitivity imaging of planetary targets spanning heliocentric distances from Jupiter to deep in the Kuiper belt, enabling a wide variety of scientific investigations. We describe here how to transform LORRI images from raw (engineering) units into scientific (calibrated) units for both resolved and unresolved targets. We also describe various instrumental artifacts that could affect the interpretation of LORRI images under some observing circumstances.

The Pluto system was recently explored by NASA's New Horizons spacecraft, making closest approach on 14 July 2015. Pluto's surface displays diverse landforms, terrain ages, albedos, colors, and composition gradients. Evidence is found for a water-ice crust, geologically young surface units, surface ice convection, wind streaks, volatile transport, and glacial flow. Pluto's atmosphere is highly extended, with trace hydrocarbons, a global haze layer, and a surface pressure near 10 microbars. Pluto's diverse surface geology and long-term activity raise fundamental questions about how small planets remain active many billions of years after formation. Pluto's large moon Charon displays tectonics and evidence for a heterogeneous crustal composition, its north pole displays puzzling dark terrain. Small satellites Hydra and Nix have higher albedos than expected.

Since the beginning of the Space Age optical sensors have been one of the main instruments for positioning and tracking known space objects. Nowadays, the unrelenting growth of man-made objects together with the overcrowding of the useful satellite orbits, and the real space debris and NEO hazards, has made necessary to carry out surveys of the space looking for uncatalogued objects. Optical telescopes play a key role in the Space Surveillance and Tracking (SST) as a primary Space Situational Awareness element and, it is known, that the best instrument for this task is a fully robotic wide-field telescope with a minimum aperture of 40cm. The Baker-Nunn Cameras (BNCs) were produced by the Smithsonian Institution during the late 50s as an optical tracking system for artificial satellites. These wide-field telescopes of 50cm of aperture were manufactured by Perkin- Elmer (optics) and Boller & Chivens (mechanics) with the highest quality specifications. The TFRM is a fully robotic refurbished BNC that exploits the excellent mechanical and optical original design to obtain an equatorial telescope with a useful 4.4{\deg}x4.4{\deg} CCD field of view. TFRM is therefore a European asset very well suited for SST (satellites and space debris) and NEO observations. Moreover, its control system allows tracking of all kinds of orbits, including LEOs.

The telescope Fabra ROA at Montsec (TFRM) is a 0.5m f/1 refurbished Baker-Nunn Camera (BNC) operated by a collaboration between the Fabra Observatory - Royal Academy of Arts and Sciences of Barcelona and the Spanish Navy Observatory (ROA), and installed at Montsec Astronomical Observatory (Spain). Among other capabilities, its CCD FoV (4.4{\deg}x4.4{\deg}), the telescope tracking at arbitrary RA and DEC rates, and the CCD shutter commanding at will during the exposure are specially remarkable for Space Surveillance and Tracking (SST) observational programs. On Feb 2011, the TFRM participated, in the CO-VI third run satellite tracking campaign of the ESA SST/Space Surveillance Awareness Preparatory Program (SST/SSA-PP). During this multi-asset 7-day campaign the TFRM conducted systematic observations of artificial satellites which yielded to the determination of 1137 accurate position measurements. Since Feb 2011, the TFRM is observing in remote and fully unattended robotic modes under commissioning status. A summary of the results of the ESA CO-VI SST optical observational campaign and insights of other SST-like observations in process will be presented.

The introduction of infrared arrays for lunar occultations (LO) work and the improvement of predictions based on new deep IR catalogues have resulted in a large increase in the number of observable occultations. We provide the means for an automated reduction of large sets of LO data. This frees the user from the tedious task of estimating first-guess parameters for the fit of each LO lightcurve. At the end of the process, ready-made plots and statistics enable the user to identify sources which appear to be resolved or binary and to initiate their detailed interactive analysis. The pipeline is tailored to array data, including the extraction of the lightcurves from FITS cubes. Because of its robustness and efficiency, the wavelet transform has been chosen to compute the initial guess of the parameters of the lightcurve fit. We illustrate and discuss our automatic reduction pipeline by analyzing a large volume of novel occultation data recorded at Calar Alto Observatory. The automated pipeline package is available from the authors.

We present an update of the lunar occultation program which is routinely carried out in the near-IR at the Calar Alto Observatory. A total of 350 events were recorded since our last report (Fors et al. 2004). In the course of eight runs we have observed, among others, late-type giants, T-Tauri stars, and infrared sources. Noteworthy was a passage of the Moon close to the galactic center, which produced a large number of events during just a few hours in July 2004. Results include the determinations of the angular diameter of RZ Ari, and the projected separations and brightness ratios for one triple and 13 binary stars, almost all of which representing first time detections. Projected separations range from 0.09arcsec to 0.007arcsec. We provide a quantitative analysis of the performance achieved in our observations in terms of angular resolution and sensitivity, which reach about 0.003arcsec and K~8.5mag, respectively. We also present a statistical discussion of our sample, and in particular of the frequency of detection of binaries among field stars.

A new application of a fast CCD drift scanning technique that allows us to perform speckle imaging of binary stars is presented. For each observation, an arbitrary number of speckle frames is periodically stored on a computer disk, each with an appropriate exposure time given both atmospheric and instrumental considerations. The CCD charge is shifted towards the serial register and read out sufficiently rapidly to avoid an excessive amount of interframe dead time. Four well-known binary systems (ADS 755, ADS 2616, ADS 3711 and ADS 16836) are observed in to show the feasibility of the proposed technique. Bispectral data analysis and power spectrum fitting is carried out for each observation, yielding relative astrometry and photometry. A new approach for self-calibrating this analysis is also presented and validated. The proposed scheme does not require any additional electronic or optical hardware, so it should allow most small professional observatories and advanced amateurs to enjoy the benefits of diffraction-limited imaging.

In this paper we present a multiresolution-based method for period determination that is able to deal with unevenly sampled data. This method allows us to detect superimposed periodic signals with lower signal-to-noise ratios than in classical methods. This multiresolution-based method is a generalization of the wavelet-based method for period detection that is unable to deal with unevenly sampled data, presented by the authors in Otazu et al. (2002). This new method is a useful tool for the analysis of real data and, in particular, for the analysis of astronomical data.

We present a program of routine lunar occultations, at optical and near-IR wavelengths, recently started at the 1.5m Spanish telescope at the Calar Alto Observatory. Both a CCD and an infrared array detector are used. The program is aimed mainly at the detection and investigation of binary systems, although results in other areas of stellar research are also anticipated. Occultations are reported for a total of 40 stars. Among these, SAO 164567, SAO 78258 and AG+24 788 have been discovered to be binaries, with projected separations as small as 0.006". Furthermore, binarity is suspected in the case of SAO 78119 and SAO 79251. Additionally, the angular diameter of the late-type giant 30 Psc and of the infrared star V349 Gem have been accurately measured, this latter for the first time. We finally evaluate the instrumentation performance in terms of limiting magnitude and angular resolution, and discuss applications to larger telescopes.

In this paper we present a wavelet based algorithm that is able to detect superimposed periodic signals in data with low signal-noise ratio. In this context, the results given by classical period determination methods highly depend on the intrinsic characteristics of each periodic signal, like amplitude or profile. It is then difficult to detect the different periods present in the data set. The results given by the wavelet based method for period determination we present here are independent of the characteristics of the signals.

A CCD drift-scanning technique for lunar occultation (LO) observations is presented. While this approach has been addressed before by Sturmann (1994) for the case of large telescopes, the technical validity has never been discussed for sub-meter class telescopes. In contrast to Sturmann's scheme, the proposed technique places the CCD in the image plane of the telescope. This does not represent a problem in the case of small telescopes, where the practical angular resolution attainable by LO is not limited by aperture smoothing. Photon-generated charge is read out at millisecond rate on a column-per-column basis, as the diffraction pattern of the occulted star is being tracked. Two LO events (SAO 79031 and SAO 77911) were observed to demonstrate the feasibility of the method. Data analysis was carried out and no angular diameter the observed stars were resolved. We show, however, that the technique could be useful for close binary detections with small telescopes. A discussion of the limiting resolution and magnitude imposed by our instrumentation is carried out, showing that drift-scanning technique could be extended to 1-2m telescopes for stellar diameter determination purposes. Finally, we point out that the technical demands required by this technique can be easily met by most small professional observatories and advanced amateurs.

We report the discovery of a low dimensional dynamical system in a 5.5 hr Hubble Space Telescope High Speed Photometer observation of a rapidly oscillating star. The topological description of the phase space orbits is given, as well as a dynamical model which describes the results. This model should motivate theorists of stellar pulsations to search for a three-dimensional system with the same topological structure to describe the mechanisms for pulsation. The equations are compatible with recently proposed nonlinear mode interaction models.