We retrieved the total content of the atmospheric water vapor (or Integrated Water Vapor, IWV) from extensive sets of photometric data obtained since 1995 at Lindenberg Meteorological Observatory with star and sun photometers. Different methods of determination of the empirical parameters that are necessary for the retrieval are discussed. The instruments were independently calibrated using laboratory measurements made at Pulkovo Observatory with the VKM-100 multi-pass vacuum cell. The empirical parameters were also calculated by the simulation of the atmospheric absorption by water vapor, using the MODRAN-4 program package for different model atmospheres. The results are compared to those presented in the literature, obtained with different instruments and methods of the retrieval. The reliability of the empirical parameters, used for the power approximation that links the water vapor content with the observed absorption, is analyzed. Currently, the total (from measurements, calibration, and calculations) errors yield the standard uncertainty of about 10% in the total column water vapor. We discuss the possibilities for improving the accuracy of calibration to ~1% as indispensable condition in order to make it possible to use data obtained by optical photometry as an independent reference for other methods (GPS, MW-radiometers, lidar, etc).

We describe the laboratory complex for the calibration of photometers that are used in weather service to measure the water vapor content in the Earth atmosphere. The complex was built up in Pulkovo Observatory and developed within the framework of collaboration between Pulkovo Observatory and Lindenberg Meteorological Observatory (Meteorologisches Observatorium Lindenberg - Richard-A{\ss}mann-Observatorium, Lindenberg, Germany). It is used to obtain calibration dependences for individual devices, and also to develop and compare various methods of construction of calibration dependences. These techniques are based on direct calibration of the photometers, on the use of spectral laboratory transmission functions for water vapor, on calculation methods using spectroscopical databases for individual lines. We hope that when the parameters of the equipment are taken into account in detail and new results for the absorptive power of water vapor are used, the accuracy of determination of the water vapor content in the atmosphere of 1-2% may be attained.

In spectral studies of water vapor under laboratory conditions (determination of molecular constants, measurement for spectral transmission functions), the amount of water vapor in the time of the measurements is one of the most essential parameters, which should be determined accurately. We discuss the application for this purpose of polymer sensors of humidity manufactured by Praktik-NC (Moscow) and used in the Pulkovo VKM-100 multipass vacuum cell. These sensors were examined in the laboratory of Lindenberg Meteorological observatory (Germany) by comparison between their readings and those of standard measuring devices for various values of relative humidity, pressure, and temperature. We also carried out measurements of relative humidity in boxes with saline solution, in which the relative humidity that corresponds to a given solution is guaranteed with the accuracy of several tenths of percent. The analysis of the results of the laboratory examination of the sensors and extended sets of measurements made with the Pulkovo cell made it possible to conclude that in measurements in the interval of relative humidity 40-80%, the ~5% accuracy of the measurements for the water vapor content is reached. Further paths are indicated for the increase of the accuracy of measurements and extending the interval of the relative humidity, in which accurate measurements may be carried out.