sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Nagarkoti, Shreeram

Normalized to: Nagarkoti, S.

3 article(s) in total. 4 co-authors, from 1 to 3 common article(s). Median position in authors list is 3,0.

[1]  oai:arXiv.org:1902.04833  [pdf] - 1878741
Delayed Outburst of H 1743--322 in 2003 and relation with its other outbursts
Comments: 29 pages, 6 figures, 3 tables (accepted for publication in "Advances in Space Research")
Submitted: 2019-02-13
The Galactic transient black hole candidate H 1743--322 exhibited a long duration outburst in 2003 after more than two and a half decades of inactivity. The 2003 event was extensively studied in multi-wavelength bands by many groups. The striking feature is that the total energy released is extremely high as compared to that in tens of outbursts which followed. In this paper, we look at this event and study both the spectral and temporal properties of the source using two component advective flow (TCAF) paradigm. We extract accretion flow parameters for each observation from spectral properties of the decay phase and determine the mass of the black hole. We computed the energy released during all the known outbursts since 2003 and showed that on an average, the energy release in an outburst is proportional to the duration of the quiescent state just prior to it, with the exception of the 2004 outburst. A constant rate of supply of matter from the companion cannot explain the energy release in 2004 outburst. However, if the energy release of 2003 is incomplete and the leftover is released in 2004, then the companion's rate of matter supply can be constant since 1977 till date. We believe that erratic behaviour of viscosity at the accumulation radius $X_p$ of matter as well as location the $X_p$ itself, rather than the random variation of mass transfer rate from the companion, could be responsible for non-uniformity in outburst pattern. We discuss several factors on which the waiting time and duration of the next outburst could depend.
[2]  oai:arXiv.org:1708.00455  [pdf] - 1593575
Possible range of viscosity parameter to trigger black hole candidates to exhibit different states of outbursts
Comments: 28 pages, 2 figures, 3 tables, in press: ApJ (05/07/17)
Submitted: 2017-08-01
In a two component advective flow around a compact object, a high viscosity Keplerian disk is flanked by a low angular momentum and low viscosity flow which forms a centrifugal pressure supported shock wave close to the black hole. The post-shock region which behaves as a Compton cloud becomes progressively smaller during the outburst as the spectra change from the hard state to the soft state in order to satisfy Rankine-Hugoniot relation in presence of cooling. The resonance oscillation of the shock wave which causes low frequency quasi-periodic oscillations (QPOs) also allows us to obtain the shock location from each observed QPO frequency. Applying the theory of transonic flow with Compton cooling and viscosity, we obtain the viscosity parameter $\alpha_{SK}$ required for the shock to form at those places in the low-Keplerian component. When we compare the evolution of $\alpha_{SK}$ for each outburst, we arrive at a major conclusion: In each source, the advective flow component typically requires exactly a similar value of $\alpha_{SK}$ when transiting from one spectral state to another (e.g., from hard state to soft state through intermediate states and the other way around in the declining phase). Most importantly, these $\alpha_{SK}$ values in the low-angular momentum advective component are fully self-consistent in the sense that they remain below critical value $\alpha_{cr}$ required to form a Keplerian disk. For a further consistency check, we compute the $\alpha_K$ of the Keplerian component, and find that in each of the objects, $\alpha_{SK}$ $<$ $\alpha_{cr}$ $<$ $\alpha_K$.
[3]  oai:arXiv.org:1607.04966  [pdf] - 1439195
Viscosity parameter in dissipative accretion flows with mass outflow around black holes
Comments: 9 pages, 7 figures
Submitted: 2016-07-18
Numerical hydrodynamic simulation of inviscid and viscous flows have shown that significant outflows could be produced from the CENtrifugal pressure supported BOundary Layer or CENBOL of an advective disk. However, this barrier is weakened in presence of viscosity, more so, if there are explicit energy dissipations at the boundary layer itself. We study effects of viscosity and energy dissipation theoretically on the outflow rate and show that as the viscosity or energy dissipation (or both) rises, the prospect of formation of outflows is greatly reduced, thereby verifying results obtained through observations and numerical simulations. Indeed, we find that in a dissipative viscous flow, shocks in presence of outflows can be produced only if the Shakura-Sunyaev viscosity parameter {\alpha} is less than 0.2. This is a direct consequence of modification of the Rankine-Hugoniot relation across the shock in a viscous flow, when the energy dissipation and mass loss in the form of outflows from the post-shock region are included. If we ignore the effects of mass loss altogether, the standing dissipative shocks in viscous flows may occur only if {\alpha} < 0.27. These limits are tighter than the absolute limit of {\alpha} = 0.3 valid for a situation when the shock itself neither dissipates energy nor any outflow is formed. We compute typical viscosity parameters required to understand spectral and temporal properties of several black hole candidates such as GX399-4, MAXI J1659-152 and MAXI J1836-194 and find that required {\alpha} are indeed well within our prescribed limit.