Directional detection of dark matter has sensitivity for both recoil energy and direction of nuclear recoil. It opens the way to measure local velocity distribution of dark matter. In this paper, we study possibility to discriminate isotropic distribution and anisotropic one suggested by a N-body simulation with directional detector. Numerical simulation is performed for two cases according to the detectors, one corresponds to angular histogram and the other is energy-angular distribution of the signals. We reveal that the anisotropy of velocity distribution can be discriminated at 90% C.L. with chi-squared test if O($10^4$) signals are obtained.

Velocity distribution of dark matter is assumed to be isotropic in most cases, however, anisotropy is suggested in some simulations. Directional direct detection of dark matter is a hopeful way to discriminate the anisotropy of dark matter velocity distribution. We simulate the dark matter and target scattering in the directional direct detection, and investigate conditions required to discriminate the anisotropy. If dark matter mass is known, $O(10^3)-O(10^4)$ events are required for the discrimination if the dark matter mass is known by other experiments. We also study the case that the dark matter mass is not known, and in analysis using both the recoil energy and the scattering angle data, both the dark matter mass and the anisotropy can be restricted much better than the analysis only with either of them.

The velocity distribution of dark matter is supposed to be isotropic Maxwell- Boltzmann distribution in most cases, however, its anisotropy is suggested by some simulations. We investigate conditions to give constraints on the anisotropy with directional direct detections.

Velocity distribution of dark matter is supposed to be isotropic Maxwell-Boltzmann distribution in most cases, however, other distribution models including anisotropic one are suggested by simulations. Directional direct detection of dark matter is expected to be a hopeful way to discriminate isotropic distribution from anisotropic one. We investigate the possibility to obtain the anisotropy and WIMP mass by Monte-Carlo simulation supposing the directional detector.

Direct detection of dark matter with directional sensitivity has the potential to discriminate the dark matter velocity distribution. Especially, it will be suitable to discriminate isotropic distribution from anisotropic one. Analyzing data produced with Monte-Carlo simulation, required conditions for the discrimination is estimated. If energy threshold of detector is optimized, $O(10^3-10^4)$ event number is required to discriminate the anisotropy.

Although the velocity distribution of dark matter is assumed to be generally isotropic, some studies have found that $\sim\hspace{-0.1cm}25$\% of the distribution can have anisotropic components. As the directional detection of dark matter is sensitive to both the recoil energy and direction of nuclear recoil, directional information can prove useful in measuring the distribution of dark matter. Using a Monte Carlo simulation based on the modeled directional detection of dark matter, we analyze the differences between isotropic and anisotropic distributions and show that the isotropic case can be rejected at a 90\% confidence level if $O(10^4)$ events can be obtained.

We compute one-loop corrections to the annihilation of non--relativistic particles $\chi$ due to the exchange of a (gauge or Higgs) boson $\phi$ with mass $\mu$ in the initial state. In the limit $m_\chi \gg \mu$ this leads to the "Sommerfeld enhancement" of the annihilation cross section. However, here we are interested in the case $\mu \lsim m_\chi$, where the one--loop corrections are well--behaved, but can still be sizable. We find simple and accurate expressions for annihilation from both $S-$ and $P-$wave initial states; they differ from each other if $\mu \neq 0$. In order to apply our results to the calculation of the relic density of Weakly Interacting Massive Particles (WIMPs), we describe how to compute the thermal average of the corrected cross sections. We apply this formalism to scalar and Dirac fermion singlet WIMPs, and show that the corrections are always very small in the former case, but can be very large in the latter. Moreover, in the context of the Minimal Supersymmetric Standard Model, these corrections can decrease the relic density of neutralinos by more than 1%, if the lightest neutralino is a strongly mixed state.