Normalized to: Moldenhauer, N.
[1]
oai:arXiv.org:1507.07100 [pdf] - 1323435
Binary Neutron Stars with Generic Spin, Eccentricity, Mass ratio, and
Compactness - Quasi-equilibrium Sequences and First Evolutions
Submitted: 2015-07-25
Information about the last stages of a binary neutron star inspiral and the
final merger can be extracted from quasi-equilibrium configurations and
dynamical evolutions. In this article, we construct quasi-equilibrium
configurations for different spins, eccentricities, mass ratios, compactnesses,
and equations of state. For this purpose we employ the SGRID code, which allows
us to construct such data in previously inaccessible regions of the parameter
space. In particular, we consider spinning neutron stars in isolation and in
binary systems; we incorporate new methods to produce highly eccentric and
eccentricity reduced data; we present the possibility of computing data for
significantly unequal-mass binaries; and we create equal-mass binaries with
individual compactness up to 0.23. As a proof of principle, we explore the
dynamical evolution of three new configurations. First, we simulate a $q=2.06$
mass ratio which is the highest mass ratio for a binary neutron star evolved in
numerical relativity to date. We find that mass transfer from the companion
star sets in a few revolutions before merger and a rest mass of
$\sim10^{-2}M_\odot$ is transferred between the two stars. This configuration
also ejects a large amount of material during merger, imparting a substantial
kick to the remnant. Second, we simulate the first merger of a precessing
binary neutron star. We present the dominant modes of the gravitational waves
for the precessing simulation, where a clear imprint of the precession is
visible in the (2,1) mode. Finally, we quantify the effect of an eccentricity
reduction procedure on the gravitational waveform. The procedure improves the
waveform quality and should be employed in future precision studies, but also
other errors, notably truncation errors, need to be reduced in order for the
improvement due to eccentricity reduction to be effective. [abridged]
[2]
oai:arXiv.org:1408.4136 [pdf] - 890409
Initial data for binary neutron stars with adjustable eccentricity
Submitted: 2014-08-18, last modified: 2014-10-30
Binary neutron stars in circular orbits can be modeled as helically
symmetric, i.e., stationary in a rotating frame. This symmetry gives rise to a
first integral of the Euler equation, often employed for constructing
equilibrium solutions via iteration. For eccentric orbits, however, the lack of
helical symmetry has prevented the use of this method, and the numerical
relativity community has often resorted to constructing initial data by
superimposing boosted spherical stars without solving the Euler equation. The
spuriously excited neutron star oscillations seen in evolutions of such data
arise because such configurations lack the appropriate tidal deformations and
are stationary in a linearly comoving---rather than rotating---frame. We
consider eccentric configurations at apoapsis that are instantaneously
stationary in a rotating frame. We extend the notion of helical symmetry to
eccentric orbits, by approximating the elliptical orbit of each companion as
instantaneously circular, using the ellipse's inscribed circle. The two
inscribed helical symmetry vectors give rise to approximate instantaneous first
integrals of the Euler equation throughout each companion. We use these
integrals as the basis of a self-consistent iteration of the Einstein
constraints to construct conformal thin-sandwich initial data for eccentric
binaries. We find that the spurious stellar oscillations are reduced by at
least an order of magnitude, compared with those found in evolutions of
superposed initial data. The tidally induced oscillations, however, are
physical and qualitatively similar to earlier evolutions. Finally, we show how
to incorporate radial velocity due to radiation reaction in our inscribed
helical symmetry vectors, which would allow one to obtain truly non-eccentric
initial data when our eccentricity parameter $e$ is set to zero.