Since the onset of the `space revolution' of high-precision high-cadence photometry, asteroseismology has been demonstrated as a powerful tool for informing Galactic archaeology investigations. The launch of the NASA TESS mission has enabled seismic-based inferences to go full sky -- providing a clear advantage for large ensemble studies of the different Milky Way components. Here we demonstrate its potential for investigating the Galaxy by carrying out the first asteroseismic ensemble study of red giant stars observed by TESS. We use a sample of 25 stars for which we measure their global asteroseimic observables and estimate their fundamental stellar properties, such as radius, mass, and age. Significant improvements are seen in the uncertainties of our estimates when combining seismic observables from TESS with astrometric measurements from the Gaia mission compared to when the seismology and astrometry are applied separately. Specifically, when combined we show that stellar radii can be determined to a precision of a few percent, masses to 5-10% and ages to the 20% level. This is comparable to the precision typically obtained using end-of-mission Kepler data

Galactic astrophysics is now in the process of building a multi-dimensional map of the Galaxy. For such a map, stellar ages are the essential ingredient. Ages are however measured only indirectly by comparing observational data with models. It is often difficult to provide a single age value for a given star, as several non-overlapping solutions are possible. We aim at recovering the underlying log(age) distribution from the measured log(age) probability density function for an arbitrary set of stars. We build an age inversion method, namely, we represent the measured log(age) probability density function as a weighted sum of probability density functions of mono-age populations. Weights in that sum give the underlying log(age) distribution. Mono-age populations are simulated so that the distribution of stars on the log g-[Fe/H] plane is close to that of the observed sample. We tested the age inversion method on simulated data, demonstrating that it is capable of properly recovering the true log(age) distribution for a large (N > 103) sample of stars. The method was further applied to large public spectroscopic surveys. For RAVE-on, LAMOST and APOGEE we also applied age inversion to mono-metallicity samples, successfully recovering age-metallicity trends present in higher-precision APOGEE data and chemical evolution models. We conclude that applying an age inversion method as presented in this work is necessary to recover the underlying age distribution of a large (N > 103 ) set of stars. These age distributions can be used to explore for instance age-metallicity relations.

Context. Large spectroscopic surveys open the way to explore our Galaxy. In order to use the data from these surveys to understand the Galactic stellar population, we need to be sure that stars contained in a survey are a representative subset of the underlying population. Without the selection function taken into account, the results might reflect the properties of the selection function rather than those of the underlying stellar population. Aims. In this work, we introduce a method to estimate the selection function for a given spectroscopic survey. We apply this method to a large sample of public spectroscopic surveys. Methods. We apply a median division binning algorithm to bin observed stars in the colour-magnitude space. This approach produces lower uncertainties and lower biases of the selection function estimate as compared to traditionally used 2D-histograms. We run a set of simulations to verify the method and calibrate the one free parameter it contains. These simulations allow us to test the precision and accuracy of the method. Results. We produce and publish estimated values and uncertainties of selection functions for a large sample of public spectroscopic surveys. We publicly release the code used to produce the selection function estimates. Conclusions. The effect of the selection function on distance modulus and metallicity distributions of stars in surveys is important for surveys with small and largely inhomogeneous spatial coverage. For surveys with contiguous spatial coverage the effect of the selection function is almost negligible.

In cases where both components of a binary system show oscillations, asteroseismology has been proposed as a method to identify the system. For KIC 2568888, observed with $Kepler$, we detect oscillation modes for two red giants in a single power density spectrum. Through an asteroseismic study we investigate if the stars have similar properties, which could be an indication that they are physically bound into a binary system. While one star lies on the red giant branch (RGB), the other, more evolved star, is either a RGB or asymptotic-giant-branch star. We found similar ages for the red giants and a mass ratio close to 1. Based on these asteroseismic results we propose KIC 2568888 as a rare candidate binary system ($\sim 0.1\%$ chance). However, when combining the asteroseismic data with ground-based $BVI$ photometry we estimated different distances for the stars, which we cross-checked with $Gaia$ DR2. From $Gaia$ we obtained for one object a distance between and broadly consistent with the distances from $BVI$ photometry. For the other object we have a negative parallax with a not yet reliable $Gaia$ distance solution. The derived distances challenge a binary interpretation and may either point to a triple system, which could explain the visible magnitudes, or, to a rare chance alignment ($\sim 0.05\%$ chance based on stellar magnitudes). This probability would even be smaller, if calculated for close pairs of stars with a mass ratio close to unity in addition to similar magnitudes, which may indeed indicate that a binary scenario is more favourable.

Context. Currently galactic exploration is being revolutionized by a flow of new data: Gaia provides measurements of stellar distances and kinematics; growing numbers of spectroscopic surveys provide values of stellar atmospheric parameters and abundances of elements; and Kepler and K2 missions provide asteroseismic information for an increasing number of stars. Aims. In this work we aim to determine stellar distances and ages using Gaia and spectrophotometric data in a consistent way. We estimate precisions of age and distance determinations with Gaia end-of-mission and TGAS parallax precisions. Methods. To this end we incorporated parallax and extinction data into the isochrone fitting method used in the Unified tool to estimate Distances, Ages, and Masses (UniDAM). We prepared datasets that allowed us to study the improvement of distance and age estimates with the inclusion of TGAS and Gaia end-of-mission parallax precisions in isochrone fitting. Results. Using TGAS parallaxes in isochrone fitting we are able to reduce distance and age estimate uncertainties for TGAS stars for distances up to 1 kpc by more than one third, compared to results based only on spectrophotometric data. With Gaia end-of-mission parallaxes in isochrone fitting we will be able to further decrease our distance uncertainties by about a factor of 20 and age uncertainties by a factor of two for stars up to 10 kpc away from the Sun. Conclusions. We demonstrate that we will be able to improve our distance estimates for about one third of stars in spectroscopic surveys and to decrease log(age) uncertainties by about a factor of two for over 80% of stars as compared to the uncertainties obtained without parallax priors using Gaia end-of-mission parallaxes consistently with spectrophotometry in isochrone fitting .

Galactic archaeology - the study of the formation and evolution of the Milky Way by reconstructing its past from its current constituents - requires precise and accurate knowledge of stellar parameters for as many stars as possible. To achieve this a number of large spectroscopic surveys have been undertaken and are still ongoing. So far consortia carrying out the different spectroscopic surveys have used different tools to determine stellar parameters of stars from their derived effective temperatures (Teff), surface gravities (log g) and metallicities ([Fe/H]) possibly combined with photometric, astrometric, interferometric or asteroseismic information. Here we aim to homogenise the stellar characterisation by applying a unified tool to a large set of publicly available spectrophotometric data. We use spectroscopic data from a variety of large surveys combined with infra-red photometry from 2MASS and AllWISE and compare these in a Bayesian manner with PARSEC isochrones to derive probability density functions (PDFs) for stellar masses, ages and distances. We treat PDFs of pre-helium-core burning, helium-core burning and post helium-core burning solutions as well as different peaks in multi-modal PDFs (i.e. each unimodal sub-PDF) of the different evolutionary phases separately. For over 2.5 million stars we report mass, age and distance estimate for each evolutionary phase and unimodal sub-PDF. We report Gaussian, skewed Gaussian, truncated Gaussian, modified truncated exponential distribution or truncated Student's t-distribution functions to represent each sub-PDF, allowing to reconstruct detailed PDFs. Comparisons with stellar parameter estimates from the literature show good agreement within uncertainties. We present UniDAM - the unified tool applicable to spectrophotometric data of different surveys to obtain a homogenised set of stellar parameters.

In the updated APOGEE-Kepler catalog, we have asteroseismic and spectroscopic data for over 3000 first ascent red giants. Given the size and accuracy of this sample, these data offer an unprecedented test of the accuracy of stellar models on the post-main-sequence. When we compare these data to theoretical predictions, we find a metallicity dependent temperature offset with a slope of around 100 K per dex in metallicity. We find that this effect is present in all model grids tested and that theoretical uncertainties in the models, correlated spectroscopic errors, and shifts in the asteroseismic mass scale are insufficient to explain this effect. Stellar models can be brought into agreement with the data if a metallicity dependent convective mixing length is used, with $ \Delta\alpha_{\rm ML, YREC} \sim 0.2$ per dex in metallicity, a trend inconsistent with the predictions of three dimensional stellar convection simulations. If this effect is not taken into account, isochrone ages for red giants from the Gaia data will be off by as much as a factor of 2 even at modest deviations from solar metallicity ([Fe/H]=$-$0.5).

Context. Clusters of galaxies are important for cosmology and astrophysics. They may be discovered through either the summed optical/IR radiation originating from their member galaxies or via X-ray emission originating from the hot intracluster medium. X- ray samples are not affected by projection effects but a redshift determination typically needs optical and infrared follow-up to then infer X-ray temperatures and luminosities. Aims. We want to confirm serendipitously discovered X-ray emitting cluster candidates and measure their cosmological redshift through the analysis and exploration of multi-wavelength photometric catalogues. Methods. We developed a tool, the Integrated Cluster Finder (ICF), to search for clusters by determining overdensities of potential member galaxies in optical and infrared catalogues. Based on a spectroscopic meta-catalogue we calibrated colour-redshift relations that combine optical (SDSS) and IR data (UKIDSS, WISE). The tool is used to quantify the overdensity of galaxies against the background via a modified redMaPPer technique and to quantify the confidence of a cluster detection. Results. Cluster finding results are compared to reference catalogues found in the literature. The results agree to within 95-98%. The tool is used to confirm 488 out of 830 cluster candidates drawn from 3XMMe in the footprint of the SDSS and CFHT catalogues. Conclusions. The ICF is a flexible and highly efficient tool to search for galaxy clusters in multiple catalogues and is freely available to the community. It may be used to identify the cluster content in future X-ray catalogues from XMM-Newton and eventually from eROSITA.

We lay the foundations of a statistical framework for multi-catalogue cross-correlation and cross-identification based on explicit simplified catalogue models. A proper identification process should rely on both astrometric and photometric data. Under some conditions, the astrometric part and the photometric part can be processed separately and merged a posteriori to provide a single global probability of identification. The present paper addresses almost exclusively the astrometrical part and specifies the proper probabilities to be merged with photometric likelihoods. To select matching candidates in n catalogues, we used the Chi (or, indifferently, the Chi-square) test with 2(n-1) degrees of freedom. We thus call this cross-match a chi-match. In order to use Bayes' formula, we considered exhaustive sets of hypotheses based on combinatorial analysis. The volume of the Chi-test domain of acceptance -- a 2(n-1)-dimensional acceptance ellipsoid -- is used to estimate the expected numbers of spurious associations. We derived priors for those numbers using a frequentist approach relying on simple geometrical considerations. Likelihoods are based on standard Rayleigh, Chi and Poisson distributions that we normalized over the Chi-test acceptance domain. We validated our theoretical results by generating and cross-matching synthetic catalogues. The results we obtain do not depend on the order used to cross-correlate the catalogues. We applied the formalism described in the present paper to build the multi-wavelength catalogues used for the science cases of the ARCHES (Astronomical Resource Cross-matching for High Energy Studies) project. Our cross-matching engine is publicly available through a multi-purpose web interface. In a longer term, we plan to integrate this tool into the CDS XMatch Service.

ARCHES (Astronomical Resource Cross-matching for High Energy Studies) is a FP7-Space funded project whose aim is to provide the international astronomical community with well-characterised multi-wavelength data in the form of spectral energy distributions (SEDs) for large samples of objects extracted from the 3XMM DR5 X-ray catalogue of serendipitous sources. The project has developed new tools implementing fully probabilistic simultaneous cross-correlation of several catalogues for unresolved sources and a multi-wavelength finder for clusters of galaxies for extended sources. These enhanced resources have been tested in the framework of several science cases.

The goal of this paper is to study possibilities of using first, second and third massive stars in open clusters to estimate total cluster mass and membership. We built estimator functions with the use of numerical simulations and analytical approximations and studied the precision and error distribution of the obtained estimator functions. We found that the distribution of the mass of first, second and third massive stars shows strong power-law tails at the high-mass end, thus it is better to use median or mode values instead of average ones. We show that the third massive star is a much better estimator then the first as it is more precise and less dependent on parameters such as maximum allowed stellar mass.