Normalized to: Milliken, R.
[1]
oai:arXiv.org:1407.2550 [pdf] - 872198
Water in the Martian regolith from OMEGA/Mars Express
Submitted: 2014-07-09
Here we discuss one of the current reservoirs of water on Mars, the regolith
and rocks exposed at the surface. This reservoir is characterized by the
presence of H_{2}O- and OH- bearing phases that produce a broad absorption at a
wavelength of \sim 3 \mu m in near-infrared (NIR) reflectance spectra. This
absorption is present in every ice-free spectrum of the Martian surface
obtained thus far by orbital NIR spectrometers. We present a quantitative
analysis of the global distribution of the 3 \mu m absorption using the
Observatoire pour la Min\'eralogie, l\'\Eau, les Glaces et l\'\Activit\'e
(OMEGA) imaging spectrometer that has been mapping the surface of Mars at
kilometer scale for more than ten years. Based on laboratory reflectance
spectra of a wide range of hydrous minerals and phases, we estimate a
model-dependent water content of 4\pm 1 wt. \% in the equatorial and
mid-latitudes. Surface hydration increases with latitude, with an asymmetry in
water content between the northern and southern hemispheres. The surface
hydration is compared to various parameters (albedo, dust, geological units,
time, relative humidity, atmospheric water pressure, and in situ measurements
performed by Phoenix and Curiosity) to constrain the nature of the reservoir.
We conclude that the nature of the surface hydration of the Martian low
latitudes is not adsorbed water but rather more tightly-bound water molecules
and hydroxyl groups in the structure of the materials of the near-top surface.
A frost-related process best explains the implementation of water into and onto
the first microns of the high latitudes Martian regolith.
[2]
oai:arXiv.org:0903.3687 [pdf] - 22598
MRO/CRISM Retrieval of Surface Lambert Albedos for Multispectral Mapping
of Mars with DISORT-based Rad. Transfer Modeling: Phase 1 - Using Historical
Climatology for Temperatures, Aerosol Opacities, & Atmo. Pressures
McGuire, P. C.;
Wolff, M. J.;
Smith, M. D.;
Arvidson, R. E.;
Murchie, S. L.;
Clancy, R. T.;
Roush, T. L.;
Cull, S. C.;
Lichtenberg, K. A.;
Wiseman, S. M.;
Green, R. O.;
Martin, T. Z.;
Milliken, R. E.;
Cavender, P. J.;
Humm, D. C.;
Seelos, F. P.;
Seelos, K. D.;
Taylor, H. W.;
Ehlmann, B. L.;
Mustard, J. F.;
Pelkey, S. M.;
Titus, T. N.;
Hash, C. D.;
Malaret, E. R.;
Team, the CRISM
Submitted: 2009-03-21
We discuss the DISORT-based radiative transfer pipeline ('CRISM_LambertAlb')
for atmospheric and thermal correction of MRO/CRISM data acquired in
multispectral mapping mode (~200 m/pixel, 72 spectral channels). Currently, in
this phase-one version of the system, we use aerosol optical depths, surface
temperatures, and lower-atmospheric temperatures, all from climatology derived
from Mars Global Surveyor Thermal Emission Spectrometer (MGS-TES) data, and
surface altimetry derived from MGS Mars Orbiter Laser Altimeter (MOLA). The
DISORT-based model takes as input the dust and ice aerosol optical depths
(scaled to the CRISM wavelength range), the surface pressures (computed from
MOLA altimetry, MGS-TES lower-atmospheric thermometry, and Viking-based
pressure climatology), the surface temperatures, the reconstructed instrumental
photometric angles, and the measured I/F spectrum, and then outputs a
Lambertian albedo spectrum. The Lambertian albedo spectrum is valuable
geologically since it allows the mineralogical composition to be estimated.
Here, I/F is defined as the ratio of the radiance measured by CRISM to the
solar irradiance at Mars divided by $\pi$. After discussing the capabilities
and limitations of the pipeline software system, we demonstrate its application
on several multispectral data cubes: the outer northern ice cap of Mars,
Tyrrhena Terra, and near the landing site for the Phoenix mission. For the icy
spectra near the northern polar cap, aerosols need to be included in order to
properly correct for the CO_2 absorption in the H_{2}O ice bands at wavelengths
near 2.0 $\mu$m. In future phases of software development, we intend to use
CRISM data directly in order to retrieve the spatiotemporal maps of aerosol
optical depths, surface pressure and surface temperature.