We investigate the early phase of the 13 February 2009 coronal mass ejection (CME). Observations with the twin STEREO spacecraft in quadrature allow us to compare for the first time in one and the same event the temporal evolution of coronal EUV dimmings, observed simultaneously on-disk and above the limb. We find that these dimmings are synchronized and appear during the impulsive acceleration phase of the CME, with the highest EUV intensity drop occurring a few minutes after the maximum CME acceleration. During the propagation phase two confined, bipolar dimming regions, appearing near the footpoints of a pre-flare sigmoid structure, show an apparent migration away from the site of the CME-associated flare. Additionally, they rotate around the 'center' of the flare site, i.e., the configuration of the dimmings exhibits the same 'sheared-to-potential' evolution as the postflare loops. We conclude that the motion pattern of the twin dimmings reflects not only the eruption of the flux rope, but also the ensuing stretching of the overlying arcade. Finally, we find that: (1) the global-scale dimmings, expanding from the source region of the eruption, propagate with a speed similar to that of the leaving CME front; (2) the mass loss occurs mainly during the period of strongest CME acceleration. Two hours after the eruption Hinode/EIS observations show no substantial plasma outflow, originating from the 'open' field twin dimming regions.

To test the standard flare model (CSHKP-model), we measured the magnetic-flux change rate in five flare events of different GOES classes using chromospheric/photospheric observations and compared its progression with observed nonthermal flare emission. We calculated the cumulated positive and negative magnetic flux participating in the reconnection process, as well as the total reconnection flux. Finally, we investigated the relations between the total reconnection flux, the GOES class of the events, and the linear velocity of the flare-associated CMEs. Using high-cadence H-alpha and TRACE 1600 A image time-series data and MDI/SOHO magnetograms, we measured the required observables (newly brightened flare area and magnetic-field strength inside this area). RHESSI and INTEGRAL hard X-ray time profiles in nonthermal energy bands were used as observable proxies for the flare-energy release rate. We detected strong temporal correlations between the derived magnetic-flux change rate and the observed nonthermal emission of all events. The cumulated positive and negative fluxes, with flux ratios of between 0.64 and 1.35, were almost equivalent to each other. Total reconnection fluxes ranged between 1.8 x 10^21 Mx for the weakest event (GOES class B9.5) and 15.5 x 10^21 Mx for the most energetic one (GOES class X17.2). The amount of magnetic flux participating in the reconnection process was higher in more energetic events than in weaker ones. Flares with more reconnection flux were associated with faster CMEs.

In a case study (June 6-7, 2008) we report on how the internal structure of a coronal mass ejection (CME) at 1 AU can be anticipated from remote observations of white-light images of the heliosphere. Favorable circumstances are the absence of fast equatorial solar wind streams and a low CME velocity which allow us to relate the imaging and in-situ data in a straightforward way. The STEREO-B spacecraft encountered typical signatures of a magnetic flux rope inside an interplanetary CME (ICME) whose axis was inclined at 45 degree to the solar equatorial plane. Various CME direction-finding techniques yield consistent results to within 15 degree. Further, remote images from STEREO-A show that (1) the CME is unambiguously connected to the ICME and can be tracked all the way to 1 AU, (2) the particular arc-like morphology of the CME points to an inclined axis, and (3) the three-part structure of the CME may be plausibly related to the in situ data. This is a first step in predicting both the direction of travel and the internal structure of CMEs from complete remote observations between the Sun and 1 AU, which is one of the main requirements for forecasting the geo-effectiveness of CMEs.

It is assumed that HXR sources map to the primary energy release site in flares where particle acceleration occurs. Strong HXR sources are mostly observed at confined regions along the reconnecting magnetic arcade. We make a general approach on how the geometry of the reconnecting current sheet (CS) may influence the strength and localization of observed HXR sources. For this we use results from an analysis on the 3B/X3.8 flare on January 17, 2005 (Temmer et al., 2007), as well as measurements from the associated CME. Due to the close match of the CME acceleration profile and the flare HXR flux, we suppose that the CME might play a certain role in modifying the geometry of the CS ('symmetric' versus 'asymmetric' vertically stretched CS). This could be the driver for 'guiding' the accelerated particles to confined areas along the flaring arcade and might explain the spatially limited occurrence of strong HXR sources in comparison to elongated ribbons as seen in H-alpha and UV.