After coming to rest on the night side of comet 67P/Churyumov-Gerasimenko, the ROLIS camera on-board Rosetta's Philae lander acquired five images of the surface below the lander, four of which were with the aid of LED illumination of different colors. The images confirm that Philae was perched on a sloped surface. A local horizon is visible in one corner of the image, beyond which we can see the coma. Having spent a full day on the surface Philae was commanded to lift and rotate, after which a final, sixth, LED image was acquired. The change in perspective allowed us to construct a shape model of the surface. The distance to the foreground was about 80 cm, much larger than the nominal 30 cm. This caused stray light, rather than directly reflected LED light, to dominate the image signal, complicating the analysis. The images show a lumpy surface with a roughness of apparently fractal nature. Its appearance is completely different from that of the first landing site, which was characterized by centimeter to meter-sized debris (Mottola et al., 2015). We recognize neither particles nor pores at the image resolution of 0.8 mm per pixel and large color variations are absent. The surface has a bi-modal brightness distribution that can be interpreted in terms of the degree of consolidation, a hypothesis that we support with experimental evidence. We propose the surface below the lander to consist of smooth, cracked plates with unconsolidated edges, similar to terrain seen in CIVA images.

This paper gives a summary on the system concept and design of the focal plane assembly of AsteroidFinder/SSB, a small satellite mission which is currently under development at the German Aerospace Center (DLR). An athermal design concept has been developed in accordance to the requirements of the instrument and spacecraft. Key aspects leading to this approach have been a trade-off study of the mechanical telescope interface, the definition of electrical and thermal interfaces and a material selection which minimizes thermally induced stresses. As a novelty, the structure will be manufactured from a machinable AlN-BN composite ceramic. To enable rapid design iterations and development, an integrated modeling approach has been used to conduct a thermo-mechanical analysis of the proposed concept in order to prove its feasibility. The steady-state temperature distribution for various load cases and the resulting stress and strain within the assembly have both been computed using a finite element simulation.