We report the design and development of a self-contained multi-band receiver (MBR) system, intended for use with a single large aperture to facilitate sensitive & high time-resolution observations simultaneously in 10 discrete frequency bands sampling a wide spectral span (100-1500 MHz) in a nearly log-periodic fashion. The development of this system was primarily motivated by need for tomographic studies of pulsar polar emission regions. Although the system design is optimized for the primary goal, it is also suited for several other interesting astronomical investigations. The system consists of a dual-polarization multi-band feed (with discrete responses corresponding to the 10 bands pre-selected as relatively RFI-free), a common wide-band RF front-end, and independent back-end receiver chains for the 10 individual sub-bands. The raw voltage time-sequences corresponding to 16 MHz bandwidth each for the two linear polarization channels and the 10 bands, are recorded at the Nyquist rate simultaneously. We present the preliminary results from the tests and pulsar observations carried out with the Green Bank Telescope using this receiver. The system performance implied by these results, and possible improvements are also briefly discussed.

Broadband antenna feeds are of particular interest to existing and future radio telescopes for multi-frequency studies of astronomical sources. Although a 1:15 range in frequency is difficult to achieve, the well-known Eleven feed design offers a relatively uniform response over such a range, and reasonably well-matched responses in E & H planes. However, given the severe Radio Frequency Interference in several bands over such wide spectral range, one desires to selectively reject the corresponding bands. With this view, we have explored the possibilities of having a multi-band feed antenna spanning a wide frequency range, but which would have good response only in a number of pre-selected (relatively) RFI-free windows (for a particular telescope-site). The designs we have investigated use the basic configuration of pairs of dipoles as in the Eleven feed, but use simple wire dipoles instead of folded dipoles used in the latter. From our study of the two designs we have investigated, we find that the design with feed-lines constructed using co-axial lines shows good rejection in the unwanted parts of the spectrum and control over the locations of resonant bands.