Sulfur gases significantly affect the photochemistry of planetary atmospheres in our Solar System, and are expected to be important components in exoplanet atmospheres. However, sulfur photochemistry in the context of exoplanets is poorly understood due to a lack of chemical-kinetics information for sulfur species under relevant conditions. Here, we study the photochemical role of hydrogen sulfide (H2S) in warm CO2-rich exoplanet atmospheres (800 K) by carrying out laboratory simulations. We find that H2S plays a significant role in photochemistry, even when present in the atmosphere at relatively low concentrations (1.6%). It participates in both gas and solid phase chemistry, leading to the formation of other sulfur gas products (CH3SH/SO, C2H4S/OCS, SO2/S2, and CS2) and to an increase in solid haze particle production and compositional complexity. Our study shows that we may expect thicker haze with small particle sizes (20 to 140 nm) for warm CO2-rich exoplanet atmospheres that possess H2S.

Sand electrification is important for aeolian sediment transportation on terrestrial bodies with silicate sand as the main sediment composition. However, it has not been thoroughly studied for icy bodies such as Titan with organic sand as the main dune-forming material. We used the colloidal probe atomic force microscopy (AFM) technique to study triboelectric charging processes using Titan and Earth sand analogs. We found that it is easy to generate triboelectric charges between naphthalene (a simple aromatic hydrocarbon), polystyrene (an aromatic hydrocarbon polymer), and borosilicate glass (Earth silicate sand analog). Strong electrostatic forces can be measured after contact and/or tribocharging. In contrast, tholin, a complex organic material, does not generate any detectable electrostatic forces with contact or tribocharging within the detection limit of the instrument. If Titan sand behaves more like tholin, this indicates that the tribocharging capacity of Titan sand is much weaker than Earth silicate sand and much less than previously measured by Mendez-Harper et al., (2017), where only simple organics were used for Titan sand analogs. Thus, triboelectrification may not contribute to increasing interparticle forces between sand particles on Titan as much as on Earth. Interparticle forces generated by other electrostatic processes or other interparticle forces such as van der Waals and capillary cohesion forces could be the dominant interparticle forces that govern Titan sand formation and sediment transportation on the surface. Titan sand is also unlikely to produce large electrical discharge through tribocharging to affect future missions to Titan's surface.

Extensive equatorial linear dunes exist on Titan, but the origin of the sand, which appears to be organic, is unknown. We used nanoindentation to study the mechanical properties of a few Titan sand candidates, several natural sands on Earth, and common materials used in the Titan Wind Tunnel, to understand the mobility of Titan sand. We measured the elastic modulus (E), hardness (H), and fracture toughness (Kc) of these materials. Tholin's elastic modulus (10.4+/-0.5 GPa) and hardness (0.53+/-0.03 GPa) are both an order of magnitude smaller than silicate sand, and is also smaller than the mechanically weak white gypsum sand. With a magnitude smaller fracture toughness (Kc=0.036+/-0.007 MPa-m^(1/2)), tholin is also much more brittle than silicate sand. This indicates that Titan sand should be derived close to the equatorial regions where the current dunes are located, because tholin is too soft and brittle to be transported for long distances.

UV radiation can induce photochemical processes in exoplanet atmospheres and produce haze particles. Recent observations suggest that haze and/or cloud layers could be present in the upper atmospheres of exoplanets. Haze particles play an important role in planetary atmospheres and may provide a source of organic material to the surface which may impact the origin or evolution of life. However, very little information is known about photochemical processes in cool, high-metallicity exoplanetary atmospheres. Previously, we investigated haze formation and particle size distribution in laboratory atmosphere simulation experiments using AC plasma as the energy source. Here, we use UV photons to initiate the chemistry rather than the AC plasma, since photochemistry driven by UV radiation is important for understanding exoplanet atmospheres. We present photochemical haze formation in current UV experiments, we investigated a range of atmospheric metallicities (100x, 1000x, and 10000x solar metallicity) at three temperatures (300 K, 400 K, and 600 K). We find that photochemical hazes are generated in all simulated atmospheres with temperature-dependent production rates: the particles produced in each metallicity group decrease as the temperature increases. The images taken with atomic force microscopy show the particle size (15-190 nm) varies with temperature and metallicity. Our laboratory experimental results provide new insight into the formation and properties of photochemical haze, which could guide exoplanet atmosphere modeling and help to analyze and interpret current and future observations of exoplanets.

Super-Earths and mini-Neptunes are the most abundant types of planets among the ~3500 confirmed exoplanets, and are expected to exhibit a wide variety of atmospheric compositions. Recent transmission spectra of super-Earths and mini-Neptunes have demonstrated the possibility that exoplanets have haze/cloud layers at high altitudes in their atmospheres. However, the compositions, size distributions, and optical properties of these particles in exoplanet atmospheres are poorly understood. Here, we present the results of experimental laboratory investigations of photochemical haze formation within a range of planetary atmospheric conditions, as well as observations of the color and size of produced haze particles. We find that atmospheric temperature and metallicity strongly affect particle color and size, thus altering the particles' optical properties (e.g., absorptivity, scattering, etc.); on a larger scale, this affects the atmospheric and surface temperature of the exoplanets, and their potential habitability. Our results provide constraints on haze formation and particle properties that can serve as critical inputs for exoplanet atmosphere modeling, and guide future observations of super-Earths and mini-Neptunes with the Transiting Exoplanet Survey Satellite (TESS), the James Webb Space Telescope (JWST), and the Wide-Field Infrared Survey Telescope (WFIRST).

To understand the origin of the dunes on Titan, it is important to investigate the material properties of Titan's organic sand particles on Titan. The organic sand may behave distinctively compared to the quartz/basaltic sand on terrestrial planets (Earth, Venus, Mars) due to differences in interparticle forces. We measured the surface energy (through contact angle measurements) and elastic modulus (through Atomic Force Microscopy, AFM) of the Titan aerosol analog (tholin). We find the surface energy of a tholin thin film is about 70.9 mN/m and its elastic modulus is about 3.0 GPa (similar to hard polymers like PMMA and polystyrene). For two 20 $\mu$m diameter particles, the theoretical cohesion force is therefore 3.3 $\mu$N. We directly measured interparticle forces for relevant materials: tholin particles are 0.8$\pm$0.6 $\mu$N, while the interparticle cohesion between walnut shell particles (a typical model materials for the Titan Wind Tunnel, TWT) is only 0.4$\pm$0.1 $\mu$N. The interparticle cohesion forces are much larger for tholins and presumably Titan sand particles than materials used in the TWT. This suggests we should increase the interparticle force in both analog experiments (TWT) and threshold models to correctly translate the results to real Titan conditions. The strong cohesion of tholins may also inform us how the small aerosol particles ($\sim$1 $\mu$m) in Titan's atmosphere are transformed into large sand particles ($\sim$200 $\mu$m). It may also support the cohesive sand formation mechanism suggested by Rubin and Hesp (2009), where only unidirectional wind is needed to form linear dunes on Titan.