We model the evolution of buoyant magnetic flux tubes in the Sun's convection zone. A flux tube is assumed to lie initially near the top of the stably stratified radiative core below the convection zone, but a segment of it is perturbed into the convection zone by gradual heating and convective overshoot motions. The ends ("footpoints") of the segment remain anchored at the base of the convection zone, and if the segment is sufficiently long, it may be buoyantly unstable, rising through the convection zone in a short time. The length of the flux tube determines the ratio of buoyancy to magnetic tension: short loops of flux are arrested before reaching the top of the convection zone, while longer loops emerge to erupt through the photosphere. Using Spruit's convection zone model, we compute the minimum footpoint separation $L_c$ required for erupting flux tubes. We explore the dependence of $L_c$ on the initial thermal state of the perturbed flux tube segment and on its initial magnetic field strength. Following an investigation of thermal diffusion time scales and the dynamic rise times of unstable flux tube segments, we conclude that the most likely origin for magnetic flux which erupts to the surface is from short length scale perturbations ($L < L_c$) which are initially stable, but which are subsequently destabilized either by diffusion of heat into the tube or by stretching of the anchor points until $L$ just exceeds $L_c$. In either case, the separation of the anchor points of the emergent tube should lie between the critical distance for a tube in mechanical equilibrium and one in thermal equilibrium. Finally, after comparing the dispersion of dynamic rise times with the much shorter observed active region formation time scales, we conclude that active regions form from the emergence of a single flux tube segment.

Where does solar flare energy come from? More specifically, assuming that the ultimate source of flare energy is mechanical energy in the convection zone, how is this translated into energy dissipated or stored in the corona? This question appears to have been given relatively little thought, as attention has been focussed predominantly on mechanisms for the rapid dissipation of coronal magnetic energy by way of MHD instabilities and plasma micro instabilities. We consider three types of flare theory: the steady state "photospheric dynamo" model in which flare power represents coronal dissipation of currents generated simultaneously by sub-photospheric flows; the "magnetic energy storage" model where sub-photospheric flows again induce coronal currents but which in this case are built up over a longer period before being released suddenly; and "emerging flux" models, in which new magnetic flux rising to the photosphere already contains free energy, and does not require subsequent stressing by photospheric motions. We conclude that photospheric dynamos can power only very minor flares; that coronal energy storage can in principle meet the requirements of a major flare, although perhaps not the very largest flares, but that difficulties in coupling efficiently to the energy source may limit this mechanism to moderate sized flares; and that emerging magnetic flux tubes, generated in the solar interior, can carry sufficient free energy to power even the largest flares ever observed.