sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Mazumder, Rakesh

Normalized to: Mazumder, R.

7 article(s) in total. 28 co-authors, from 1 to 4 common article(s). Median position in authors list is 1,0.

[1]  oai:arXiv.org:1910.11260  [pdf] - 2020574
Simultaneous longitudinal and transverse oscillations in filament threads after a failed eruption
Comments: 8 Pages and 8 figures. Accepted for publication in Astronomy & Astrophysics
Submitted: 2019-10-24
Longitudinal and transverse oscillations are frequently observed in the solar prominences and/or filaments. These oscillations are excited by a large scale shock wave, impulsive flares at one leg of the filament threads, or due to any low coronal eruptions. We report simultaneous longitudinal and transverse oscillations in the filament threads of a quiescent region filament. We observe a big filament in the north-west of the solar disk on $6^{th}$ July 2017. On $7^{th}$ July 2017 it starts rising around 13:00 UT. Then we observe a failed eruption and subsequently, the filament threads start to oscillate around 16 UT. We observe both transverse and longitudinal oscillations in a filament thread. The oscillations damp down and filament threads almost disappear. We place horizontal and vertical artificial slits on the filament threads to capture the longitudinal and transverse oscillations of the threads. Data from Atmospheric Imaging Assembly (AIA) onboard Solar Dynamics Observatory (SDO) is used to detect the oscillations. We find the signatures of large amplitude longitudinal oscillations (LALOs). We also detect damping in LALOs. In one thread of the filament, we observe large amplitude transverse oscillations (LATOs). Using the pendulum model we estimate the lower limit of magnetic field strength and radius of curvature from the observed parameter of LALOs. We show the co-existence of two different wave modes in the same filament threads. We estimate magnetic field from LALOs and hence suggest a possible range of the length of the filament threads using LATOs.
[2]  oai:arXiv.org:1812.10090  [pdf] - 1882491
Quiet Region Jet by Eruption of Minifilament and Associated Change in Magnetic Flux
Comments: 7 pages, 5 figures, accepted for publication in Astronomy Reports
Submitted: 2018-12-25
We observe a coronal jet around 22:08 UT on 23 rd March of 2017, in a quiet region towards the north-east of the solar disk. A minifilament eruption leads to this jet. We analyze dynamics of the minifilament from its formation until its eruption. We observe that the minifilament starts forming around 15:50 UT. Then at a later time, it disappears but again appears and finally erupts as a blowout jet around 22:08 UT. We study the evolution of photospheric magnetic field beneath the minifilament. Initially, we observe subsequent increase and decrease of positive magnetic flux. Prior to the initiation of the eruption, positive magnetic flux shows a continuous decrease until the minifilament disappears. The positive magnetic flux increases and decreases due to new positive flux emergence and cancellation of positive magnetic flux with negative magnetic flux respectively.
[3]  oai:arXiv.org:1812.02489  [pdf] - 1793658
Properties of filament in Solar cycle 20-23 from McIntosh database
Comments: 12 pages, 10 figures, accepted for publication in RAA
Submitted: 2018-12-06
Filament is a cool, dense structure suspended in the solar corona. The eruption of a filament is often associated with coronal mass ejection (CME), which has an adverse effect on space weather. Hence, the study of filament has attracted much attention in the recent past. The tilt angle of active region (AR) magnetic bipoles is a crucial parameter in the context of the solar dynamo. It governs the conversion efficiency of the toroidal magnetic field to poloidal magnetic field. The filament always forms over the Polarity Inversion Lines (PILs). So the study of tilt angles of the filament can provide valuable information about generation of magnetic field in the Sun. We study the tilt angle of filaments and other properties of it using McIntosh archive data. We fit a straight line to each filament to estimate its tilt angle. We study the variation of mean tilt angle with time. The latitude distribution of positive tilt angle filaments and negative tilt angle filaments reveal that there is a dominance of positive tilt angle filaments in the southern hemisphere and negative tilt angle filaments dominate in the northern hemisphere. We study the variation of the mean tilt angle for low and high latitude separately. Study of temporal variation of filament number reveals that total filament number and low latitude filament number varies cyclically, in phase with the solar cycle. The number of filaments in high latitude is less, and they also show a cyclic pattern in temporal variation. We also study the north-south asymmetry of filament for different latitude criteria.
[4]  oai:arXiv.org:1810.02133  [pdf] - 1791105
The Association of Filaments, Polarity Inversion Lines, and Coronal Hole Properties with the Sunspot Cycle: An Analysis of the McIntosh Database
Comments: Accepted for publication in ApJ; 15 pages, 10 figures
Submitted: 2018-10-04
Filaments and coronal holes, two principal features observed in the solar corona are sources of space weather variations. Filament formation is closely associated with polarity inversion lines (PIL) on the solar photosphere which separate positive and negative polarities of the surface magnetic field. The origin of coronal holes is governed by large-scale unipolar magnetic patches on the photosphere from where open magnetic field lines extend to the heliosphere. We study properties of filaments, PILs and coronal holes in solar cycles 20, 21, 22 and 23 utilizing the McIntosh archive. We detect a prominent cyclic behavior of filament length, PIL length, and coronal hole area with significant correspondence with the solar magnetic cycle. The spatio-temporal evolution of the geometric centers of filaments shows a butterfly-like structure and distinguishable pole-ward migration of long filaments during cycle maxima. We identify this rush to the poles of filaments to be co-temporal with the initiation of polar field reversal as gleaned from Mount Wilson and Wilcox Solar Observatory polar field observations and quantitatively establish their temporal correspondence. We analyze the filament tilt angle distribution to constrain their possible origins. Majority of the filaments exhibit negative and positive tilt angles in the northern and the southern hemispheres, respectively -- strongly suggesting that their formation is governed by the overall large-scale magnetic field distribution on the solar photosphere and not by the small-scale intra-active region magnetic field configurations. We also investigate the hemispheric asymmetry in filaments, PILs, and coronal holes. We find that the hemispheric asymmetry in filaments and PILs are positively correlated -- whereas coronal hole asymmetry is uncorrelated -- with sunspot area asymmetry.
[5]  oai:arXiv.org:1807.07601  [pdf] - 1719610
The Extended Solar Cycle: Muddying the Waters of Solar/Stellar Dynamo Modeling Or Providing Crucial Observational Constraints?
Comments: 11 Pages; 03 Figures
Submitted: 2018-07-19
In 1844 Schwabe discovered that the number of sunspots increased and decreased over a period of about 11 years, that variation became known as the sunspot cycle. Almost eighty years later, Hale described the nature of the Sun's magnetic field, identifying that it takes about 22 years for the Sun's magnetic polarity to cycle. It was also identified that the latitudinal distribution of sunspots resembles the wings of a butterfly showing migration of sunspots in each hemisphere that abruptly start at mid-latitudes towards the Sun's equator over the next 11 years. These sunspot patterns were shown to be asymmetric across the equator. In intervening years, it was deduced that the Sun (and sun-like stars) possess magnetic activity cycles that are assumed to be the physical manifestation of a dynamo process that results from complex circulatory transport processes in the star's interior. Understanding the Sun's magnetism, its origin and its variation, has become a fundamental scientific objective \-- the distribution of magnetism, and its interaction with convective processes, drives various plasma processes in the outer atmosphere. In the past few decades, a range of diagnostic techniques have been employed to systematically study finer scale magnetized objects, and associated phenomena. The patterns discerned became known as the ``Extended Solar Cycle'' (ESC). The patterns of the ESC appeared to extend the wings of the activity butterfly back in time, nearly a decade before the formation of the sunspot pattern, and to much higher solar latitudes. In this short review, we describe their observational patterns of the ESC and discuss possible connections to the solar dynamo as we depart on a multi-national collaboration to investigate the origins of solar magnetism through a blend of archived and contemporary data analysis with the goal of improving solar dynamo understanding and modeling.
[6]  oai:arXiv.org:1611.03984  [pdf] - 1528357
Simultaneous longitudinal and transverse oscillation in an active filament
Comments: Accepted for publication in Solar Physics
Submitted: 2016-11-12
We report on the co-existence of longitudinal and transverse oscillations in an active filament. On March 15$^{th}$ 2013, a M1.1 class flare was observed in the active region AR 11692. A CME was found to be associated with the flare. {The CME generated a shock wave that triggered the oscillations in a nearby filament}, situated at the south-west of the active region as observed from National Solar Observatory (NSO)\textit{Global Oscillation Network Group}(GONG) H$\alpha$ images. In this work we report the longitudinal oscillations in the two ends of the filament, co-existing with the transverse oscillations. We propose a scenario in which {an} incoming shock wave hits the filament obliquely and triggers both longitudinal and transverse oscillations. Using the observed parameters, we estimate the lower limit of the magnetic field strength. We use simple pendulum model with gravity as the restoring force to estimate the radius of curvature. We also calculate the mass accretion rate which causes the filament motions to damp quite fast.
[7]  oai:arXiv.org:1505.04473  [pdf] - 1037691
Dynamics of on-disk plumes as observed with Interface Region Imaging Spectrograph, Atmospheric Imaging Assembly and Helioseismic and Magnetic Imager
Comments: 32 pages, 11 figures, 2 tables, Accepted for publication in APJ
Submitted: 2015-05-17
We examine the role of small-scale transients in the formation and evolution of solar coronal plumes. We study the dynamics of plume footpoints seen in the vicinity of a coronal hole using the Atmospheric Imaging Assembly (AIA) images, the Helioseismic and Magnetic Imager (HMI) magnetogram on board the Solar Dynamics Observatory (SDO) and spectroscopic data from the Interface Region Imaging Spectrograph (IRIS). Quasi-periodic brightenings are observed in the base of the plumes and are associated with magnetic flux changes. With the high spectral and spatial resolution of IRIS, we identify the sources of these oscillations and try to understand what role the transients at the foot points can play in sustaining the coronal plumes. IRIS sit and stare observation provide a unique opportunity to study the evolution of foot points of the plumes. We notice enhanced line width, intensity and large deviation from the average Doppler shift in the line profiles at specific instances which indicate the presence of flows at the foot points of plumes. We propose that outflows (jet-like features) as a result of small scale reconnections affect the line profiles. These jet-like features may be also responsible for the generation of propagating disturbances within the plumes which are observed to be propagating to larger distances as recorded from multiple AIA channels. These propagating disturbances can be explained in terms of slow magnetoacoustic waves.