A series of solar energetic particle (SEP) events were observed at Parker Solar Probe (PSP) by the Integrated Science Investigation of the Sun (\ISOIS) during the period from April 18, 2019 through April 24, 2019. The PSP spacecraft was located near 0.48 au from the Sun on Parker spiral field lines that projected out to 1 au within $\sim 25^\circ$ of near Earth spacecraft. These SEP events, though small compared to historically large SEP events, were amongst the largest observed thus far in the PSP mission and provide critical information about the space environment inside 1 au during SEP events. During this period the Sun released multiple coronal mass ejections (CMEs). One of these CMEs observed was initiated on April 20, 2019 at 01:25 UTC, and the interplanetary CME (ICME) propagated out and passed over the PSP spacecraft. Observations by the Electromagnetic Fields Investigation (FIELDS) show that the magnetic field structure was mostly radial throughout the passage of the compression region and the plasma that followed, indicating that PSP did not directly observe a flux rope internal to the ICME, consistent with the location of PSP on the ICME flank. Analysis using relativistic electrons observed near Earth by the Electron, Proton and Alpha Monitor (EPAM) on the Advanced Composition Explorer (ACE) demonstrates the presence of electron seed populations (40--300 keV) during the events observed. The energy spectrum of the \ISOIS~ observed proton seed population below 1 MeV is close to the limit of possible stationary state plasma distributions out of equilibrium. \ISOIS~ observations reveal the \revise{enhancement} of seed populations during the passage of the ICME, which \revise{likely indicates a key part} of the pre-acceleration process that occurs close to the Sun.

The authors of this report met on 28-30 March 2018 at the New Jersey Institute of Technology, Newark, New Jersey, for a 3-day workshop that brought together a group of data providers, expert modelers, and computer and data scientists, in the solar discipline. Their objective was to identify challenges in the path towards building an effective framework to achieve transformative advances in the understanding and forecasting of the Sun-Earth system from the upper convection zone of the Sun to the Earth's magnetosphere. The workshop aimed to develop a research roadmap that targets the scientific challenge of coupling observations and modeling with emerging data-science research to extract knowledge from the large volumes of data (observed and simulated) while stimulating computer science with new research applications. The desire among the attendees was to promote future trans-disciplinary collaborations and identify areas of convergence across disciplines. The workshop combined a set of plenary sessions featuring invited introductory talks and workshop progress reports, interleaved with a set of breakout sessions focused on specific topics of interest. Each breakout group generated short documents, listing the challenges identified during their discussions in addition to possible ways of attacking them collectively. These documents were combined into this report-wherein a list of prioritized activities have been collated, shared and endorsed.

On 2017-09-10, solar energetic particles (SEPs) originating from the active region 12673 were registered as a ground level enhancement (GLE) at Earth and the biggest GLE on the surface of Mars as observed by the Radiation Assessment Detector (RAD) since the landing of the Curiosity rover in August 2012. Based on multi-point coronagraph images, we identify the initial 3D kinematics of an extremely fast CME and its shock front as well as another 2 CMEs launched hours earlier (with moderate speeds) using the Graduated Cylindrical Shell (GCS) model. These three CMEs interacted as they propagated outwards into the heliosphere and merged into a complex interplanetary CME (ICME). The arrival of the shock and ICME at Mars caused a very significant Forbush Decrease (FD) seen by RAD only a few hours later than that at Earth which is about 0.5 AU closer to the Sun. We investigate the propagation of the three CMEs and the consequent ICME together with the shock using the Drag Based Model (DBM) and the WSA-ENLIL plus cone model constrained by the in-situ SEP and FD/shock onset timing. The synergistic modeling of the ICME and SEP arrivals at Earth and Mars suggests that in order to better predict potentially hazardous space weather impacts at Earth and other heliospheric locations for human exploration missions, it is essential to analyze 1) the CME kinematics, especially during their interactions and 2) the spatially and temporally varying heliospheric conditions, such as the evolution and propagation of the stream interaction regions.

The remoteness of the Sun and the harsh conditions prevailing in the solar corona have so far limited the observational data used in the study of solar physics to remote-sensing observations taken either from the ground or from space. In contrast, the `solar wind laboratory' is directly measured in situ by a fleet of spacecraft measuring the properties of the plasma and magnetic fields at specific points in space. Since 2007, the solar-terrestrial relations observatory (STEREO) has been providing images of the solar wind that flows between the solar corona and spacecraft making in-situ measurements. This has allowed scientists to directly connect processes imaged near the Sun with the subsequent effects measured in the solar wind. This new capability prompted the development of a series of tools and techniques to track heliospheric structures through space. This article presents one of these tools, a web-based interface called the 'Propagation Tool' that offers an integrated research environment to study the evolution of coronal and solar wind structures, such as Coronal Mass Ejections (CMEs), Corotating Interaction Regions (CIRs) and Solar Energetic Particles (SEPs). These structures can be propagated from the Sun outwards to or alternatively inwards from planets and spacecraft situated in the inner and outer heliosphere. In this paper, we present the global architecture of the tool, discuss some of the assumptions made to simulate the evolution of the structures and show how the tool connects to different databases.