We consider a measurement of the gravitational acceleration of antimatter, gbar, using muonium. A monoenergetic, low-velocity, horizontal muonium beam will be formed from a surface-muon beam using a novel technique and directed at an atom interferometer. The measurement requires a precision three-grating interferometer: the first grating pair creates an interference pattern which is analyzed by scanning the third grating vertically using piezo actuators. State-of-the-art nanofabrication can produce the needed membrane grating structure in silicon nitride or ultrananoscrystalline diamond. With 100 nm grating pitch, a 10% measurement of gbar can be made using some months of surface-muon beam time. This will be the first gravitational measurement of leptonic matter, of 2nd-generation matter and, possibly, the first measurement of the gravitational acceleration of antimatter.

In 2007, a companion with planetary mass was found around the pulsating subdwarf B star V391 Pegasi with the timing method, indicating that a previously undiscovered population of substellar companions to apparently single subdwarf B stars might exist. Following this serendipitous discovery, the EXOTIME (http://www.na.astro.it/~silvotti/exotime/) monitoring program has been set up to follow the pulsations of a number of selected rapidly pulsating subdwarf B stars on time-scales of several years with two immediate observational goals: 1) determine Pdot of the pulsational periods P 2) search for signatures of substellar companions in O-C residuals due to periodic light travel time variations, which would be tracking the central star's companion-induced wobble around the center of mass. These sets of data should therefore at the same time: on the one hand be useful to provide extra constraints for classical asteroseismological exercises from the Pdot (comparison with "local" evolutionary models), and on the other hand allow to investigate the preceding evolution of a target in terms of possible "binary" evolution by extending the otherwise unsuccessful search for companions to potentially very low masses. While timing pulsations may be an observationally expensive method to search for companions, it samples a different range of orbital parameters, inaccessible through orbital photometric effects or the radial velocity method: the latter favours massive close-in companions, whereas the timing method becomes increasingly more sensitive towards wider separations. In this paper we report on the status of the on-going observations and coherence analysis for two of the currently five targets, revealing very well-behaved pulsational characteristics in HS 0444+0458, while showing HS 0702+6043 to be more complex than previously thought.

The VLT Survey Telescope (VST) is a 2.6m aperture, wide field, UV to I facility, to be installed at the European Southern Observatory (ESO) on the Cerro Paranal Chile. VST was primarily intended to complement the observing capabilities of VLT with wide-angle imaging for detecting and pre-characterising sources for further observations with the VLT.

The VIRMOS consortium of French and Italian Institutes (PI: O. Le Fevre, co-PI: G. Vettolani) is manufacturing two wide field imaging multi-object spectrographs for the European Southern Observatory Very Large Telescope (VLT), with emphasis on the ability to carry over spectroscopic surveys of large numbers of sources: the VIsible Multi-Object Spectrograph, VIMOS, and the Near InfraRed Multi-Object Spectrograph, NIRMOS. There are 52 motors to be controlled in parallel in the spectrograph, making VIMOS a complex machine to be handled. This paper will focus on the description of the control system, designed in the ESO VLT standard control concepts, and on some integration issues and problem solving strategies.

The VST (VLT Survey Telescope) is a 2.6 m Alt-Az telescope to be installed at Mount Paranal in Chile, in the European Southern Observatory (ESO) site. The VST is a wide-field imaging facility planned to supply databases for the ESO Very Large Telescope (VLT) science and carry out stand-alone observations in the UV to I spectral range. This paper will focus mainly on control software aspects, describing the VST software architecture in the context of the whole ESO VLT control concept. The general architecture and the main components of the control software will be described.

The VST (VLT Survey Telescope) is a 2.6 m class Alt-Az telescope to be installed at Mount Paranal in the Atacama desert, Chile, in the European Southern Observatory (ESO) site. The VST is a wide-field imaging facility planned to supply databases for the ESO Very Large Telescope (VLT) science and carry out stand-alone observations in the UV to I spectral range. This paper will focus on the distributed control system of active optics based on CAN bus and PIC microcontrollers. Both axial and radial pads of the primary mirror will be equipped by astatic lever supports controlled by microcontroller units. The same CAN bus + microcontroller boards approach will be used for the temperature acquisition modules.

The VST (VLT Survey Telescope) is a 2.6 m class Alt-Az telescope to be installed on Cerro Paranal in the Atacama desert, Northern Chile, in the European Southern Observatory (ESO) site. The VST is a wide-field imaging facility planned to supply databases for the ESO Very Large Telescope (VLT) science and carry out stand-alone observations in the UV to I spectral range. So far no telescope has been dedicated entirely to surveys; the VST will be the first survey telescope to start the operation, as a powerful survey facility for the VLT observatory. This paper will focus on the axes motion control system. The dynamic model of the telescope will be analyzed, as well as the effect of the wind disturbance on the telescope performance. Some algorithms for the telescope position control will be briefly discussed.

The VIRMOS Consortium has the task to design and manufacture two spectrographs for ESO VLT, VIMOS (Visible Multi-Object Spectrograph) and NIRMOS (Near Infrared Multi-Object Spectrograph). This paper describes how the Mask Manufacturing Unit (MMU), which cuts the slit masks to be used with both instruments, meets the scientific requirements and manages the storage and the insertion of the masks into the instrument. The components and the software of the two main parts of the MMU, the Mask Manufacturing Machine and the Mask Handling System, are illustrated together with the mask material and with the slit properties. Slit positioning is accurate within 15 micron, equivalent to 0.03 arcsec on the sky, while the slit edge roughness has an rms on the order of 0.03 pixels on scales of a slit 5 arcsec long and of 0.01 pixels on the pixel scale (0.205 arcsec). The MMU has been successfully installed during July/August 2000 at the Paranal Observatory and is now operational for spectroscopic mask cutting, compliant with the requested specifications.

The aim of the VIRMOS VLT Deep Survey (VVDS) is to study of the evolution of galaxies, large scale structures and AGNs from a sample of more than 150,000 galaxies with measured redshifts in the range 0<z<5+. The VVDS will rely on the VIMOS and NIRMOS wide field multi-object spectrographs, which the VIRMOS consortium is delivering to ESO. Together, they offer unprecedented multiplex capability in the wavelength range 0.37-1.8microns, allowing for large surveys to be carried out. The VVDS has several main aspects: (1) a deep multi-color imaging survey over 18deg^2 of more than one million galaxies, (2) a "wide" spectroscopic survey with more than 130,000 redshifts measured for objects brighter than IAB=22.5 over 18deg^2, (3) a "deep" survey with 50,000 redshifts measured to IAB=24, (4) ultra-deep" surveys with several thousand redshifts measured to IAB=25, (5) multi-wavelength observations with the VLA and XMM.

We present the concept and preliminary design of the Galileo OH Subtracted Spectrograph [GOHSS], a multifibre NIR spectrograph for faint objects. The instrument represents a collaboration between the Institute of Astronomy, Cambridge and the Observatories of Naples and Rome and will be a second-light instrument for the 3.6m Galileo telescope located on La Palma. The NIR spectrograph accomplishes OH night-sky suppression in a different way from the hardware solution used by both OHS (Maihara etal) and COHSI (Piche' et al). GOHSS provides a multiechelle design with software subtraction capable of yielding ~28 spectra in J+H bands at a spectral resolution R~3000. Such a resolution is the minimum necessary to reduce the impact of atmospheric OH lines.