sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Lubiński, P.

Normalized to: Lubiński, P.

3 article(s) in total. 44 co-authors, from 1 to 2 common article(s). Median position in authors list is 6,0.

[1]  oai:arXiv.org:2006.02154  [pdf] - 2120034
Distinct accretion modes of Cygnus X-1 revealed from hard X-rays
Comments: 21 pages, 11 figures, accepted for publication in ApJ
Submitted: 2020-06-03
Thanks to recurrent observations of the black hole binary Cyg X-1 carried out over 15 years the INTEGRAL satellite has collected the largest data set in the hard X-ray band for this source. We have analyzed these data, complemented by data collected by other X-ray satellites and radio flux at 15 GHz. To characterize the spectral and variability properties of the system we have examined parameters such as the hard X-ray flux, photon index and fractional variability. Our main result is that the 2D distribution of the photon index and flux determined for the 22-100 keV band forms six clusters. This result, interpreted within the Comptonization scenario as the dominant process responsible for the hard X-ray emission, leads to a conclusion that the hot plasma in Cyg X-1 takes the form of six specific geometries. The distinct character of each of these plasma states is reinforced by their different X-ray and radio variability patterns. In particular, the hardest and softest plasma states show no short-term flux - photon index correlation typical for the four other states, implying a lack of interaction between the plasma and accretion disk. The system evolves between these two extreme states, with the spectral slope regulated by a variable cooling of the plasma by the disk photons.
[2]  oai:arXiv.org:1307.3409  [pdf] - 1937871
Performance of the Cherenkov Telescope Array at energies above 10 TeV
Comments: In Proceedings of the 33rd International Cosmic Ray Conference (ICRC2013), Rio de Janeiro (Brazil). All CTA contributions at arXiv:1307.2232
Submitted: 2013-07-12
The Cherenkov Telescope Array (CTA) is the next generation observatory for very high energy gamma rays. The capability of the array to detect gamma-rays above 10 TeV is going to be achieved with a large number of Small Size Telescopes (SSTs) which will cover a large area. The subarray composed of SSTs has to compromise the number of telescopes (cost) and the large effective area. The separation between the telescopes has to be adjusted to achieve highest sensitivity with the smallest number of telescopes. On the other hand larger separation can worsen the energy threshold as well as the energy and angular resolutions. In our study we have investigated the optimal spacing between the telescopes of the SST array using an analytical approach and the concept of telescope cell consisting of four telescopes as well as Monte Carlo simulations of the sets of cells.
[3]  oai:arXiv.org:1307.3137  [pdf] - 1937867
4 m Davies-Cotton telescope for the Cherenkov Telescope Array
Comments: In Proceedings of the 33rd International Cosmic Ray Conference (ICRC2013), Rio de Janeiro (Brazil). All CTA contributions at arXiv:1307.2232
Submitted: 2013-07-11
The Cherenkov Telescope Array (CTA) is the next generation very high energy gamma-ray observatory. It will consist of three classes of telescopes, of large, medium and small sizes. The small telescopes, of 4 m diameter, will be dedicated to the observations of the highest energy gamma-rays, above several TeV. We present the technical characteristics of a single mirror, 4 m diameter, Davies-Cotton telescope for the CTA and the performance of the sub-array consisting of the telescopes of this type. The telescope will be equipped with a fully digital camera based on custom made, hexagonal Geiger-mode avalanche photodiodes. The development of cameras based on such devices is an RnD since traditionally photomultipliers are used. The photodiodes are now being characterized at various institutions of the CTA Consortium. Glass mirrors will be used, although an alternative is being considered: composite mirrors that could be adopted if they meet the project requirements. We present a design of the telescope structure, its components and results of the numerical simulations of the telescope performance.