Normalized to: Lorincik, J.
[1]
oai:arXiv.org:1910.08620 [pdf] - 2026060
Observation of all pre- and post-reconnection structures involved in
three-dimensional reconnection geometries in solar eruptions
Submitted: 2019-10-18
We report on observations of the two newly-identified reconnection geometries
involving erupting flux ropes. In 3D, a flux rope can reconnect either with a
surrounding coronal arcade (recently named "ar-rf" reconnection) or with itself
("rr-rf" reconnection), and both kinds of reconnection create a new flux rope
field line and a flare loop. For the first time, we identify all four
constituents of both reconnections in a solar eruptive event, the filament
eruption of 2011 June 07 observed by SDO/AIA. The ar-rf reconnection manifests
itself as shift of one leg of the filament by more than 25" northward. At its
previous location, a flare arcade is formed, while the new location of the
filament leg previously corresponded to a footpoint of a coronal loop in 171 A.
In addition, the evolution of the flare ribbon hooks is also consistent with
the occurrence of ar--rf reconnection as predicted by MHD simulations.
Specifically, the growing hook sweeps footpoints of preeruptive coronal
arcades, and these locations become inside the hook. Furthermore, the rr-rf
reconnection occurs during the peak phase above the flare arcade, in an
apparently X-type geometry involving a pair of converging bright filament
strands in the erupting filament. A new flare loop forms near the leg of one of
the strands, while a bright blob, representing a remnant of the same strand, is
seen ascending into the erupting filament. All together, these observations
vindicate recent predictions of the 3D standard solar flare model.
[2]
oai:arXiv.org:1909.03825 [pdf] - 2000252
Manifestations of three dimensional magnetic reconnection in an eruption
of a quiescent filament: \\ Filament strands turning to flare loops
Submitted: 2019-09-09
We report on observations of conversion of bright filament strands into flare
loops during 2012 August 31 filament eruption. Prior to the eruption,
individual bright strands composing one of the legs of the filament were
observed in the 171 A filter channel data of the Atmospheric Imaging Assembly.
After the onset of the eruption, one of the hooked ribbons started to propagate
and contract, sweeping footpoints of the bright filament strands as well as
coronal loops located close by. Later on, hot flare loops appeared in regions
swept by the hook, where the filament strands were rooted. Timing and
localization of these phenomena suggest that they are caused by reconnection of
field lines composing the filament at the hook, which, to our knowledge, has
not been observed before. This process is not included in the standard flare
model (CSHKP), as it does not address footpoints of erupting flux ropes and
ribbon hooks. It has, however, been predicted using the recent
three-dimensional extensions to the standard flare model. There, the erupting
flux rope can reconnect with surrounding coronal arcades as the hooked
extensions of current ribbons sweep its footpoints. This process results in
formation of flare loops rooted in previous footpoints of the flux rope. Our
observations of sweeping of filament footpoints are well described by this
scenario. In all observed cases, all of the footpoints of the erupting filament
became footpoints of flare loops. This process was observed to last for about
150 minutes, throughout the whole eruption.
[3]
oai:arXiv.org:1505.04333 [pdf] - 1245787
Imaging and Spectroscopic Observations of a Transient Coronal Loop:
Evidence for the Non-Maxwellian $\kappa$-Distributions
Dudik, Jaroslav;
Mackovjak, Simon;
Dzifcakova, Elena;
Del Zanna, Giulio;
Williams, David R.;
Karlicky, Marian;
Mason, Helen E.;
Lorincik, Juraj;
Kotrc, Pavel;
Farnik, Frantisek;
Zemanova, Alena
Submitted: 2015-05-16
We report on the SDO/AIA and Hinode/EIS observations of a transient coronal
loop. The loop brightens up in the same location after the disappearance of an
arcade formed during a B8.9-class microflare three hours earlier. EIS captures
this loop during its brightening phase as observed in most of the AIA filters.
We use the AIA data to study the evolution of the loop, as well as to perform
the DEM diagnostics as a function of $\kappa$. Fe XI--XIII lines observed by
EIS are used to perform the diagnostics of electron density and subsequently
the diagnostics of $\kappa$. Using ratios involving the Fe XI 257.772\AA
selfblend, we diagnose $\kappa$ $\lesssim$ 2, i.e., an extremely non-Maxwellian
distribution. Using the predicted Fe line intensities derived from the DEMs as
a function of $\kappa$, we show that, with decreasing $\kappa$, all
combinations of ratios of line intensities converge to the observed values,
confirming the diagnosed $\kappa$ $\lesssim$ 2. These results represent the
first positive diagnostics of $\kappa$-distributions in the solar corona
despite the limitations imposed by calibration uncertainties.