Landeck, A.
Normalized to: Landeck, A.
2 article(s) in total. 10 co-authors, from 1 to 2 common article(s). Median position in authors list is 3,0.
[1]
oai:arXiv.org:1904.07543 [pdf] - 1871611
The footprint of cometary dust analogues: II. Morphology as a tracer of
tensile strength and application to dust collection by the Rosetta spacecraft
Submitted: 2019-04-16
The structure of cometary dust is a tracer of growth processes in the
formation of planetesimals. Instrumentation on board the Rosetta mission to
comet 67P/Churyumov- Gerasimenko captured dust particles and analysed them in
situ. However, these deposits are a product of a collision within the
instrument. We conducted laboratory experiments with cometary dust analogues,
simulating the collection process by Rosetta instruments (specifically COSIMA,
MIDAS). In Paper I we reported that velocity is a key driver in determining the
appearance of deposits. Here in Paper II we use materials with different
monomer sizes, and study the effect of tensile strength on the appearance of
deposits. We find that mass transfer efficiency increases from $\sim$1 up to
$\sim$10% with increasing monomer diameter from 0.3 $\mu$m to 1.5 $\mu$m (i.e.
tensile strength decreasing from $\sim$12 to $\sim$3 kPa), and velocities
increasing from 0.5 to 6 m/s. Also, the relative abundance of small fragments
after impact is higher for material with higher tensile strength. The
degeneracy between the effects of velocity and material strength may be lifted
by performing a closer study of the deposits. This experimental method makes it
possible to estimate the mass transfer efficiency in the COSIMA instrument.
Extrapolating these results implies that more than half of the dust collected
during the Rosetta mission has not been imaged. We analysed two COSIMA targets
containing deposits from single collisions. The collision that occurred closest
to perihelion passage led to more small fragments on the target.
[2]
oai:arXiv.org:1705.07127 [pdf] - 1583655
The footprint of cometary dust analogs: I. Laboratory experiments of
low-velocity impacts and comparison with Rosetta data
Ellerbroek, L. E.;
Gundlach, B.;
Landeck, A.;
Dominik, C.;
Blum, J.;
Merouane, S.;
Hilchenbach, M.;
Bentley, M. S.;
Mannel, T.;
John, H.;
van Veen, H. A.
Submitted: 2017-05-19
Cometary dust provides a unique window on dust growth mechanisms during the
onset of planet formation. Measurements by the Rosetta spacecraft show that the
dust in the coma of comet 67P/Churyumov-Gerasimenko has a granular structure at
size scales from sub-um up to several hundreds of um, indicating hierarchical
growth took place across these size scales. However, these dust particles may
have been modified during their collection by the spacecraft instruments. Here
we present the results of laboratory experiments that simulate the impact of
dust on the collection surfaces of COSIMA and MIDAS, instruments onboard the
Rosetta spacecraft. We map the size and structure of the footprints left by the
dust particles as a function of their initial size (up to several hundred um)
and velocity (up to 6 m/s). We find that in most collisions, only part of the
dust particle is left on the target; velocity is the main driver of the
appearance of these deposits. A boundary between sticking/bouncing and
fragmentation as an outcome of the particle-target collision is found at v ~ 2
m/s. For velocities below this value, particles either stick and leave a single
deposit on the target plate, or bounce, leaving a shallow footprint of
monomers. At velocities > 2 m/s and sizes > 80 um, particles fragment upon
collision, transferring up to 50 per cent of their mass in a rubble-pile-like
deposit on the target plate. The amount of mass transferred increases with the
impact velocity. The morphologies of the deposits are qualitatively similar to
those found by the COSIMA instrument.
