We investigate how wave propagation is modified by the presence of heat sources and sinks, in the simple 1D, hydrodynamical case, including chromosphere and solar wind. We integrate the time-dependent hydrodynamic equations of the solar wind with spherical symmetry, including conduction, radiative cooling and a prescribed mechanical heat flux. Once a quasi-stationary wind is established, we study the response of the system to pressure oscillations at the photospheric boundary. We use transparent boundary conditions. We find that wavepackets with high enough amplitude propagating upward from the photosphere implode just below the transition region. This implosion is due to the radiative cooling term generating pressure holes close to the wave crests of the wave, which make the wave collapse. In the case where heat sources and sinks are not present in the equations, the wave remains stable whatever the initial wave amplitude, which is compatible with published work. Instability should be observable when and where the TR is high enough above the optically thick regions.

The intention of the ''von Karman sodium'' (VKS) experiment is to study the hydromagnetic dynamo effect in a highly turbulent and unconstrained flow. Much effort has been devoted to the optimization of the mean flow and the lateral boundary conditions in order to minimize the critical magnetic Reynolds number and hence the necessary motor power. The main focus of this paper lies on the role of ''lid layers'', i.e. layers of liquid sodium between the impellers and the end walls of the cylinder. First, we study an analytical test flow to show that lid layers can have an ambivalent effect on the efficiency of the dynamo. The critical magnetic Reynolds number shows a flat minimum for a small lid layer thickness, but increases for thicker layers. For the actual VKS geometry it is shown that static lid layers yield a moderate increase of the critical magnetic Reynolds number by approximately 12 per cent. A more dramatic increase by 100 until 150 per cent can occur when some rotational flow is taken into account in those layers. Possible solutions of this problem are discussed for the real dynamo facility.