sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Kumazaki, Kohei

Normalized to: Kumazaki, K.

6 article(s) in total. 22 co-authors, from 1 to 4 common article(s). Median position in authors list is 1,5.

[1]  oai:arXiv.org:1409.4151  [pdf] - 1216938
Comparison of algorithms for determination of rotation measure and Faraday structure I. 1100 - 1400 MHz
Comments: 15 pages, 8 figures, 5 tables, accepted by AJ. Some figures have been degraded, for a full resolution version, see http://physics.usyd.edu.au/~xhsun/datachallengeI.pdf
Submitted: 2014-09-15
(abridged) We run a Faraday structure determination data challenge to benchmark the currently available algorithms including Faraday synthesis (previously called RM synthesis in the literature), wavelet, compressive sampling and $QU$-fitting. The frequency set is similar to POSSUM/GALFACTS with a 300 MHz bandwidth from 1.1 to 1.4 GHz. We define three figures of merit motivated by the underlying science: a) an average RM weighted by polarized intensity, RMwtd, b) the separation $\Delta\phi$ of two Faraday components and c) the reduced chi-squared. Based on the current test data of signal to noise ratio of about 32, we find that: (1) When only one Faraday thin component is present, most methods perform as expected, with occasional failures where two components are incorrectly found; (2) For two Faraday thin components, QU-fitting routines perform the best, with errors close to the theoretical ones for RMwtd, but with significantly higher errors for $\Delta\phi$. All other methods including standard Faraday synthesis frequently identify only one component when $\Delta\phi$ is below or near the width of the Faraday point spread function; (3) No methods, as currently implemented, work well for Faraday thick components due to the narrow bandwidth; (4) There exist combinations of two Faraday components which produce a large range of acceptable fits and hence large uncertainties in the derived single RMs; in these cases, different RMs lead to the same Q, U behavior, so no method can recover a unique input model.
[2]  oai:arXiv.org:1402.0612  [pdf] - 826606
Properties of Intrinsic Polarization Angle Ambiguities in Faraday Tomography
Comments: 21 pages, 10 figures, accepted for publication in PASJ
Submitted: 2014-02-03, last modified: 2014-05-23
Faraday tomography is a powerful method to diagnose polarizations and Faraday rotations along the line of sight. The quality of Faraday tomography is, however, limited by several conditions. Recently, it is reported that Faraday tomography indicates false signals in some specific situations. In this paper, we systematically investigate the condition of the appearance of false signals in Faraday tomography. We study this by pseudo-observing two sources within a beam, and change in the intrinsic polarization angles, rotation measures, intensities, and frequency coverage. We find that false signals arise when rotation measure between the sources is less than 1.5 times the full width at half maximum of the rotation measure spread function. False signals also depend on the intensity ratio between the sources and are reduced for large ratio. On the other hand, the appearance of false signals does not depend on frequency coverage, meaning that the uncertainty should be correctly understood and taken into consideration even with future wide-band observations such as Square Kilometer Array (SKA).
[3]  oai:arXiv.org:1403.0325  [pdf] - 1203657
Exploring the Intergalactic Magnetic Field by Means of Faraday Tomography
Comments: 10 pages, 10 figures, accepted for publication in PASJ
Submitted: 2014-03-03
Unveiling the intergalactic magnetic field (IGMF) in filaments of galaxies is a very important and challenging subject in modern astronomy. In order to probe the IGMF from rotation measures (RMs) of extragalactic radio sources, we need to separate RMs due to other origins such as the source, intervening galaxies, and our Galaxy. In this paper, we discuss observational strategies for the separation by means of Faraday tomography (Faraday RM Synthesis). We consider an observation of a single radio source such as a radio galaxy or a quasar viewed through the Galaxy and the cosmic web. We then compare the observation with another observation of a neighbor source with a small angular separation. Our simulations with simple models of the sources suggest that it would be not easy to detect the RM due to the IGMF of order ~ 1 rad/m/m, an expected value for the IGMF through a single filament. Contrary to it, we find that the RM of at least ~10 rad/m/m could be detected with the SKA or its pathfinders/precursors, if we achieve selections of ideal sources. These results would be improved if we incorporate decomposition techniques such as RMCLEAN and QU-fitting. We discuss feasibility of the strategies for cases with complex Galactic emissions as well as with effects of observational noise and radio frequency interferences.
[4]  oai:arXiv.org:1308.5696  [pdf] - 1178790
Fisher Analysis on Wide-Band Polarimetry for Probing the Intergalactic Magnetic Field
Comments: 20 pages, 6 figures
Submitted: 2013-08-26
We investigate the capability of ongoing radio telescopes for probing Faraday rotation measure (RM) due to the intergalactic magnetic field (IGMF) in the large-scale structure of the universe which is expected to be of order $O(1) {\rm rad/m^2}$. We consider polarization observations of a compact radio source such as quasars behind a diffuse source such as the Galaxy, and calculate Stokes parameters $Q$ and $U$ assuming a simple model of the Faraday dispersion functions with Gaussian shape. Then, we perform the Fisher analysis to estimate the expected errors in the model parameters from QU-fitting of polarization intensity, accounting for sensitivities and frequency bands of Australian Square Kilometer Array Pathfinder, Low Frequency Array, and the Giant Meterwave Radio Telescope. Finally, we examine the condition on the source intensities which are required to detect the IGMF. Our analysis indicates that the QU-fitting is promising for forthcoming wideband polarimetry to explore RM due to the IGMF in filaments of galaxies.
[5]  oai:arXiv.org:1211.3097  [pdf] - 673181
Exploring the origin of the fine structures in the CMB temperature angular power spectrum
Comments: 13 pages, 11 figures
Submitted: 2012-11-13
The angular power spectrum of the cosmic microwave background (CMB) temperature anisotropies is a good probe to look into the primordial density fluctuations at large scales in the universe. Here we re-examine the angular power spectrum of the Wilkinson Microwave Anisotropy Probe data, paying particular attention to the fine structures (oscillations) at $\ell=100 \sim 150$ reported by several authors. Using Monte-Carlo simulations, we confirm that the gap from the simple power law spectrum is a rare event, about 2.5--3$\sigma$, if these fine structures are generated by experimental noise and the cosmic variance. Next, in order to investigate the origin of the structures, we examine frequency and direction dependencies of the fine structures by dividing the observed QUV frequency maps into four sky regions. We find that the structures around $\ell \sim 120$ do not have significant dependences either on frequencies or directions. For the structure around $\ell \sim 140$, however, we find that the characteristic signature found in the all sky power spectrum is attributed to the anomaly only in the South East region.
[6]  oai:arXiv.org:1105.2398  [pdf] - 1076571
Fine Features in the Primordial Power Spectrum
Comments: 15 pages, 11 figures, submitted to JCAP
Submitted: 2011-05-12
A possible origin of the anomalous dip and bump in the primordial power spectrum, which are reconstructed from WMAP data corresponding to the multipole $\ell=100\sim 140$ by using the inversion method, is investigated as a consequence of modification of scalar field dynamics in the inflation era. Utilizing an analytic formula to handle higher order corrections to the slow-roll approximation, we evaluate the relation between a detailed shape of inflaton potential and a fine structure in the primordial power spectrum. We conclude that it is unlikely to generate the observed dip and bump in the power spectrum by adding any features in the inflaton potential. Though we can make a fine enough shape in the power spectrum by controlling the feature of the potential, the amplitude of the dip and bump becomes too small in that case.