Aerosol particles experience significant photophoretic forces at low pressure. Previous work assumed the average particle temperature to be very close to the gas temperature. This might not always be the case. If the particle temperature or the thermal radiation field differs significantly from the gas temperature (optically thin gases), given approximations overestimate the photophoretic force by an order of magnitude on average with maximum errors up to more than three magnitudes. We therefore developed a new general approximation which on average only differs by 1 % from the true value.

Insolation of the Martian soil leads to a sub-surface overpressure due to thermal creep gas flow. This could support particle entrainment into the atmosphere. Short time shadowing e.g. by the traverse of a larger dust devil would enhance this effect. We find in microgravity experiments that mass ejection rates are increased by a factor of 10 for several seconds if a light source of 12.6 kW/$\rm m^2$ is turned off. Scaled to Mars this implies that self-shadowing of a partially opaque dust devil might lead to a strongly amplified flux of lifted material. We therefore suggest that self-shadowing might be a mechanism on Mars to increase the total dust loading of a dust devil and keep it self-sustained.

In optically thin parts of protoplanetary disks photophoresis is a significant force not just for dust grains, but also for macroscopic bodies. The absolute strength on the supposedly highly porous objects is not known in detail as yet. We set up a low pressure torsion balance and studied photophoretic forces. We investigated the dependence on plate dimensions and on ambient pressure and considered the influence of channels through the plates. As samples for full (no channel) plates we used tissue with 2mm thickness and circular shape with diameters of 10mm, 30mm and 50mm. The influence of channels was probed on rectangular-shaped circuit boards of 35mm x 35mm area and 1.5mm thickness. The number of channels was 169 and 352. At low pressure, the absolute photophoretic force is proportional to the cross section of the plates. At high pressure, gas flow through the channels enhances the photophoretic force. The pressure dependence of the radiative force can (formally) be calculated by photophoresis on particles with a characteristic length. We derived two characteristic length scales l depending on the plate radius r_1, the channel radius r_2, and the thickness of the plate which equals the length of the channel d as l=r^{0.35} x d^{0.65}. The highest force is found at a pressure p_max = 15 x l^{-1}Pa mm. In total, the photophoretic force on a plate with channels can be well described by a superposition of the two components: photophoresis due to the overall size and cross section of the plate and photophoresis due to the channels, both with their characteristic pressure dependencies. We applied these results to the transport of large solids in protoplanetary disks and found that the influence of porosity on the photophoretic force can reverse the inward drift of large solids, for instance meter-sized bodies, and push them outward within the optically thin parts of the disk.