Granular material that is bound by the low gravity of a small asteroid is mobilized by slow velocity impacts. These splashes generated by impacts might play an important role in sculpting the asteroid's surface. In laboratory experiments we characterize the ejecta generated by spherical 150 $\rm \mu m$ diameter basalt grains impacting a granular bed at 0.8 m/s. We find that such an impact typically leads to less than 10 particles being ejected from the granular bed, with typical ejecta trajectories rising to less than one particle diameter above the surface. That is, the observed impacts are highly dissipative and only a small fraction of the impact energy is imparted onto the ejecta. While the impactor itself still rebounds, it typically slows down significantly to an average of about 20 % of its impact velocity. Scaled to asteroids, impactor and ejecta generated from impacts of sand sized grains are not able to spread over the asteroid's surface but will stay close to the impact site. Therefore these highly inelastic impacts into soft granular beds efficiently trap grains, in contrast to more elastic impacts on bare, rocky surfaces confirming suggestions by Shinbrot (2017). This is also in agreement to observed features on asteroids as this topological elasticity bias suggests that redistribution of grains leads to a size segregation.

In an earlier work, we found that large metallic iron fractions in dust aggregates and strong magnetic fields boost preplanetary growth. This sets an initial bias for the formation of Mercury-like planets in the inner part of protoplanetary disks. We extended these experiments here by adding pure quartz aggregates to the iron-rich aggregates. Magnetic boost still leads to the formation of larger clusters of aggregates. These clusters now include silicate aggregates, which can also be connecting bridges between chains. However, at least a certain fraction of iron-rich aggregates are needed to trigger magnetic boost. Without a magnetic field, the sticking properties of the aggregates and their constituents determine the composition of clusters of a given size. This introduces a new fractionation and sorting mechanism by cluster formation at the bouncing barrier.

We developed an experiment to study different aspects of granular matter under microgravity. The 1.5U small experiment was carried out on the International Space Station. About 3500 almost identical spherical glass particles with 856 um diameter were placed in a container of 50*50 mm cross section. Adjusting the height between 5 and 50 mm, the filling factor can be varied. The sample was vibrated under different frequencies and amplitudes. The majority of the data are video images of the particles motion. Here, we first give an overview of the general setup and a first qualitative account of different phenomena observed in about 700 experimental runs. These phenomena include collisional cooling, collective motion via gas-cluster coupling, and the influence of electrostatic forces on particle-particle interactions.

We carried out wind tunnel experiments on parabolic flights with 100 $\mu$m Mojave Mars simulant sand. The experiments result in shear stress thresholds and erosion rates for varying g-levels at 600 Pa pressure. Our data confirm former results on JSC Mars 1A simulant where the threshold shear stress is lower under Martian gravity than extrapolated from earlier ground-based studies which fits observations of Martian sand activity. The data are consistent with a model by Shao and Lu (2000) and can also be applied to other small terrestrial (exo)-planets with low pressure atmospheres.

In parabolic flight experiments we studied the wind induced erosion of granular beds composed of spherical glass beads at low gravity and low ambient pressure. Varying g-levels were set by centrifugal forces. Expanding existing parameter sets to a pressure range between $p=300-1200\,$Pa and to g-levels of $g=1.1-2.2\,\rm m\,s^{-2}$ erosion thresholds are still consistent with the existing model for wind erosion on planetary surfaces by Shao & Lu (2000). These parameters were the lowest values that could technically be reached by the experiment. The experiments decrease the necessary range of extrapolation of erosion thresholds from verified to currently still unknown values at the conditions of planetesimals in protoplanetary discs. We apply our results to the stability of planetesimals. In inner regions of protoplanetary discs, pebble pile planetesimals below a certain size are not stable but will be disassembled by a head wind.

The inner part of protoplanetary disks can be threaded by strong magnetic fields. In laboratory levitation experiments, we study how magnetic fields up to 7 mT influence the aggregation of dust by observing the self-consistent collisional evolution of particle ensembles. As dust samples we use mixtures of iron and quartz in different ratios. Without magnetic fields, particles in all samples grow into a bouncing barrier. These aggregates reversibly form larger clusters in the presence of magnetic fields. The size of these clusters depends on the strength of the magnetic field and the ratio between iron and quartz. The clustering increases the size of the largest entities by a factor of a few. If planetesimal formation is sensitive to the size of the largest aggregates, e.g., relying on streaming instabilities, then planetesimals will preferentially grow iron-rich in the inner region of protoplanetary disks. This might explain the iron gradient in the solar system and the formation of dense Mercury-like planets.

In laboratory experiments, spherical 1 mm-wide glass and basalt particles are heated, and the hot particles collide at about 1m/s with a flat glass target that is at room temperature. When the particles are heated below 900 K, the collisions are essentially elastic with coefficients of restitution of about 0.9, but above 900K collisions become increasingly inelastic and the coefficient of restitution decreases with increasing temperature. At 1100K the glass particles approach sticking but, simultaneously, at the same temperature the particles melt on timescales of minutes. The basalt particles approach sticking at 1200 K. Only above 1400K do basalt grains in contact with each other fuse together, forming compounds on timescales of hours, and at 1500K basalt grains completely fuse together. Therefore, cooling basalt grains only have a 100K window for compound formation, and velocities very likely have to be below 1m/s for sticking in the first place. We predict that this puts constraints on compound chondrule formation and particle densities in the solar nebula.

Dust and sand motion are a common sight on Mars. Understanding the interaction of atmosphere and Martian soil is fundamental to describe the planet's weather, climate and surface morphology. We set up a wind tunnel to study the lift of a mixture between very fine sand and dust in a Mars simulant soil. The experiments were carried out under Martian gravity in a parabolic flight. The reduced gravity was provided by a centrifuge under external microgravity. The onset of saltation was measured for a fluid threshold shear velocity of 0.82$\pm$0.04 m/s. This is considerably lower than found under Earth gravity. In addition to a reduction in weight, this low threshold can be attributed to gravity dependent cohesive forces within the sand bed, which drop by 2/3 under Martian gravity. The new threshold for saltation leads to a simulation of the annual dust cycle with a Mars GCM that is in agreement with observations.

In recent laboratory studies the robustness of a bouncing barrier in planetesimal formation was studied with an ensemble of preformed compact mm-sized aggregates. Here we show that a bouncing barrier indeed evolves self-consistently by hit-and-stick from an ensemble of smaller dust aggregates. In addition, we feed small aggregates to an ensemble of larger bouncing aggregates. The stickiness temporarily increases, but the final number of aggregates still bouncing remains the same. However, feeding on the small particle supply, the size of the bouncing aggregates increases. This suggests that in the presence of a dust reservoir aggregates grow into but also out of a bouncing barrier at larger size.

In laboratory experiments, we studied collisions of ensembles of compact (filling factor 0.33) millimeter dust aggregates composed of micrometer quartz grains. We used cylindrical aggregates, triangular aggregates, square aggregates, and rectangular aggregates. Ensembles of equal size aggregates as well as ensembles with embedded larger aggregates were studied. The typical collision velocities are 10-20 mm $\rm s^{-1}$. High spatial and temporal resolution imaging unambiguously shows that individual collisions lead to sticking with a high probability of 20 percent. This leads to connected clusters of aggregates. The contact areas between two aggregates increase with collision velocity. However, this cluster growth is only temporary, as subsequent collisions of aggregates and clusters eventually lead to the detachment of all aggregates from a cluster. The contacts are very fragile as aggregates cannot be compressed further or fragment under our experimental conditions to enhance the contact stability. Therefore, the evolution of the ensemble always leads back to a distribution of individual aggregates of initial size. This supports and extends earlier experiments showing that a bouncing barrier in planetesimal formation would be robust against shape and size variations.