We present the calculation of thermal noise in interferometric gravitational-wave detectors due to the thermal fluctuations of the beam splitter (BS). This work makes use of a recently developed method of the analysis of thermal noise in mirrors from first principles, based on the fluctuation dissipation theorem. The evaluation of BS thermal noise is carried out for the two different grav- itational wave observatories, GEO600 and the Advanced Laser Interferometer Gravitational Wave Observatory (aLIGO). The analysis evaluates thermal noise from both the substrate and the optical reflective and antireflective stacks located on the BS surface. We demonstrate that the fluctuations of both reflecting and anti-reflecting surfaces significantly contribute to the total thermal noise of the BS. The oscillating intensity pattern couples small-scale distortions of the surface to the overall phase readout, and therefore increases the overall thermal noise. In the case of aLIGO, the BS contribution is with $0.3\%$ negligibly small. At a frequency of 500Hz, the BS causes about $10\%$ of GEO600's sensitivity limit. BS noise impairs the feasible sensitivity of the GEO-HF design proposal by about $50\%$.

Waveguide mirrors possess nano-structured surfaces which can potentially provide a significant reduction in thermal noise over conventional dielectric mirrors. To avoid introducing additional phase noise from motion of the mirror transverse to the reflected light, however, they must possess a mechanism to suppress the phase effects associated with the incident light translating across the nano-structured surface. It has been shown that with carefully chosen parameters this additional phase noise can be suppressed. We present an experimental measurement of the coupling of transverse to longitudinal displacements in such a waveguide mirror designed for 1064 nm light. We place an upper limit on the level of measured transverse to longitudinal coupling of one part in seventeen thousand with 95% confidence, representing a significant improvement over a previously measured grating mirror.

Grating reflectors have been repeatedly discussed to improve the noise performance of metrological applications due to the reduction or absence of any coating material. So far, however, no quantitative estimate on the thermal noise of these reflective structures exists. In this work we present a theoretical calculation of a grating reflector's noise. We further apply it to a proposed 3rd generation gravitational wave detector. Depending on the grating geometry, the grating material and the temperature we obtain a thermal noise decrease by up to a factor of ten compared to conventional dielectric mirrors. Thus the use of grating reflectors can substantially improve the noise performance in metrological applications.

The advanced interferometer network will herald a new era in observational astronomy. There is a very strong science case to go beyond the advanced detector network and build detectors that operate in a frequency range from 1 Hz-10 kHz, with sensitivity a factor ten better in amplitude. Such detectors will be able to probe a range of topics in nuclear physics, astronomy, cosmology and fundamental physics, providing insights into many unsolved problems in these areas.