sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Krivopustov, M. I.

Normalized to: Krivopustov, M.

2 article(s) in total. 25 co-authors, from 1 to 2 common article(s). Median position in authors list is 8,0.

[1]  oai:arXiv.org:nucl-ex/0506024  [pdf] - 118473
Formation of Light Isotopes by Protons and Deuterons of 3.65 GeV/nucleon on Separated Tin Isotopes
Comments: 16 pages, LaTeX, 6 figures, 6 tables, submitted to Yadernaya Fizika (Physics of Atimoc Nuclei)
Submitted: 2005-06-22
We measure cross sections for residual nuclide formation in the mass range 6 < A < 97 caused by bombardment with protons and deuterons of 3.65 GeV/nucleon energy of enriched tin isotopes (112-Sn, 118-Sn, 120-Sn, 124-Sn). The experimental data are compared with calculations by the codes FLUKA, LAHET, CEM03, and LAQGSM03. Scaling behavior is observed for the whole mass region of residual nuclei, showing a possible multifragmentation mechanism for the formation of light products (6 < A < 31). Our analysis of the isoscaling dependence also shows a possible contribution of multifragmentation to the production of heavier nuclides, in the mass region 39 < A < 81.
[2]  oai:arXiv.org:nucl-ex/0403056  [pdf] - 118459
Study of Proton Induced Reactions in a Radioactive 129-I Target at Ep=660 MeV
Comments: 6 pages, LaTeX, 1 figure, 3 tables, presented at the International Workshop on Nuclear Data for the Transmutation of Nuclear Waste (TRAMU@GSI), GSI-Darmstadt, Germany, September 1-5, 2003
Submitted: 2004-03-30
Two NaI (85% 129-I and 15% 127-I) targets were exposed to a beam of 660-MeV protons. Cross sections for formation of 76 residual nuclei were obtained by the induced activity method. The results are compared with other experimental data on 127-I and theoretical calculations by eleven models contained in the codes LAHET3 (using the Bertini+Dresner, ISABEL+Dresner, INCL+Dresner, and INCL+ABLA options), CASCADE, CEM95, CEM2K, LAQGSM+GEM2, CEM2k+GEM2, LAQGSM+GEMINI, and CEM2k+GEMINI. Most of the models describe spallation products with masses close to the target reasonably well while the reliability of the codes differs greatly in the deep spallation and fission/fragmentation regions. The difficulties in describing products with A=40-80 by all of the codes tested here except for CEM2k+GEMINI and LAQGSM+GEMINI is related to the neglect of fission (and fragmentation) processes for targets as light as 129-I.