Normalized to: Kosyra, R.
[1]
oai:arXiv.org:1501.02840 [pdf] - 1258717
Environment-based selection effects of Planck clusters
Submitted: 2015-01-12
We investigate whether the large scale structure environment of galaxy
clusters imprints a selection bias on Sunyaev Zel'dovich (SZ) catalogs. Such a
selection effect might be caused by line of sight (LoS) structures that add to
the SZ signal or contain point sources that disturb the signal extraction in
the SZ survey. We use the Planck PSZ1 union catalog (Planck Collab- oration et
al. 2013a) in the SDSS region as our sample of SZ selected clusters. We
calculate the angular two-point correlation function (2pcf) for physically
correlated, foreground and background structure in the RedMaPPer SDSS DR8
catalog with respect to each cluster. We compare our results with an optically
selected comparison cluster sample and with theoretical predictions. In
contrast to the hypothesis of no environment-based selection, we find a mean
2pcf for background structures of -0.049 on scales of $\lesssim 40'$,
significantly non-zero at $\sim 4 \sigma$, which means that Planck clusters are
more likely to be detected in regions of low background density. We hypothesize
this effect arises either from background estimation in the SZ survey or from
radio sources in the background. We estimate the defect in SZ signal caused by
this effect to be negligibly small, of the order of $\sim 10^{-4}$ of the
signal of a typical Planck detection. Analogously, there are no implications on
X-ray mass measurements. However, the environ- mental dependence has important
consequences for weak lensing follow up of Planck galaxy clusters: we predict
that projection effects account for half of the mass contained within a 15'
radius of Planck galaxy clusters. We did not detect a background underdensity
of CMASS LRGs, which also leaves a spatially varying redshift dependence of the
Planck SZ selection function as a possible cause for our findings.
[2]
oai:arXiv.org:1408.2519 [pdf] - 1216232
The 64 Mpixel wide field imager for the Wendelstein 2m Telescope: Design
and Calibration
Submitted: 2014-08-11
The Wendelstein Observatory of Ludwig Maximilians University of Munich has
recently been upgraded with a modern 2m robotic telescope. One Nasmyth port of
the telescope has been equipped with a wide-field corrector which preserves the
excellent image quality (< 0.8" median seeing) of the site (Hopp et al. 2008)
over a field of view of 0.7 degrees diameter. The available field is imaged by
an optical imager (WWFI, the Wendelstein Wide Field Imager) built around a
customized 2 $\times$ 2 mosaic of 4k $\times$ 4k 15 \mu m e2v CCDs from
Spectral Instruments. This paper provides an overview of the design and the
WWFI's performance. We summarize the system mechanics (including a structural
analysis), the electronics (and its electromagnetic interference (EMI)
protection) and the control software. We discuss in detail detector system
parameters, i.e. gain and readout noise, quantum efficiency as well as charge
transfer efficiency (CTE) and persistent charges. First on sky tests yield
overall good predictability of system throughput based on lab measurements.
[3]
oai:arXiv.org:1310.6744 [pdf] - 1180217
Weak lensing analysis of SZ-selected clusters of galaxies from the SPT
and Planck surveys
Gruen, D.;
Seitz, S.;
Brimioulle, F.;
Kosyra, R.;
Koppenhoefer, J.;
Lee, C. -H.;
Bender, R.;
Riffeser, A.;
Eichner, T.;
Weidinger, T.;
Bierschenk, M.
Submitted: 2013-10-24, last modified: 2014-05-30
We present the weak lensing analysis of the Wide-Field Imager SZ Cluster of
galaxy (WISCy) sample, a set of 12 clusters of galaxies selected for their
Sunyaev-Zel'dovich (SZ) effect. After developing new and improved methods for
background selection and determination of geometric lensing scaling factors
from absolute multi-band photometry in cluster fields, we compare the weak
lensing mass estimate with public X-ray and SZ data. We find consistency with
hydrostatic X-ray masses with no significant bias, no mass dependent bias and
less than 20% intrinsic scatter and constrain fgas,500c=0.128+0.029-0.023. We
independently calibrate the South Pole Telescope significance-mass relation and
find consistency with previous results. The comparison of weak lensing mass and
Planck Compton parameters, whether extracted self-consistently with a
mass-observable relation (MOR) or using X-ray prior information on cluster
size, shows significant discrepancies. The deviations from the MOR strongly
correlate with cluster mass and redshift. This could be explained either by a
significantly shallower than expected slope of Compton decrement versus mass
and a corresponding problem in the previous X-ray based mass calibration, or a
size or redshift dependent bias in SZ signal extraction.
[4]
oai:arXiv.org:0709.3763 [pdf] - 1934175
The MAGIC Project: Contributions to ICRC 2007
Albert, J.;
Aliu, E.;
Anderhub, H.;
Antoranz, P.;
Armada, A.;
Baixeras, C.;
Barrio, J. A.;
Bartko, H.;
Bastieri, D.;
Becker, J. K.;
Bednarek, W.;
Berger, K.;
Bigongiari, C.;
Biland, A.;
Bock, R. K.;
Bordas, P.;
Bosch-Ramon, V.;
Bretz, T.;
Britvitch, I.;
Cabras, G.;
Camara, M.;
Carmona, E.;
Chilingarian, A.;
Coarasa, J. A.;
Commichau, S.;
Contreras, J. L.;
Cortina, J.;
Costado, M. T.;
Curtef, V.;
Danielyan, V.;
Dazzi, F.;
De Angelis, A.;
Delgado, C.;
Reyes, R. de los;
De Lotto, B.;
De Maria, M.;
De Sabata, F.;
Dorner, D.;
Doro, M.;
Errando, M.;
Fagiolini, M.;
Ferenc, D.;
Fernández, E.;
Firpo, R.;
Flix, J.;
Fonseca, M. V.;
Font, L.;
Fuchs, M.;
Galante, N.;
García-López, R. J.;
Garczarczyk, M.;
Gaug, M.;
Giller, M.;
Goebel, F.;
Hakobyan, D.;
Hayashida, M.;
Hengstebeck, T.;
Herrero, A.;
Höhne, D.;
Hose, J.;
Hsu, C. C.;
Jacon, P.;
Jogler, T.;
Kosyra, R.;
Kranich, D.;
Kritzer, R.;
Laille, A.;
Lindfors, E.;
Lombardi, S.;
Longo, F.;
López, J.;
López, M.;
Lorenz, E.;
Majumdar, P.;
Maneva, G.;
Mannheim, K.;
Mansutti, O.;
Mariotti, M.;
Martínez, M.;
Mazin, D.;
Merck, C.;
Meucci, M.;
Meyer, M.;
Miranda, J. M.;
Mirzoyan, R.;
Mizobuchi, S.;
Moralejo, A.;
Nieto, D.;
Nilsson, K.;
Ninkovic, J.;
na-Wilhelmi, E. O;
Otte, N.;
Oya, I.;
Paneque, D.;
Paoletti, R.;
Paredes, J. M.;
Pasanen, M.;
Pascoli, D.;
Pauss, F.;
Pegna, R.;
Persic, M.;
Peruzzo, L.;
Piccioli, A.;
Prandini, E.;
Puchades, N.;
Raymers, A.;
Rhode, W.;
Ribó, M.;
Rico, J.;
Rissi, M.;
Robert, A.;
Rügamer, S.;
Saggion, A.;
Saito, T. Y.;
Sánchez, A.;
Sartori, P.;
Scalzotto, V.;
Scapin, V.;
Schmitt, R.;
Schweizer, T.;
Shayduk, M.;
Shinozaki, K.;
Shore, S. N.;
Sidro, N.;
Sillanpää, A.;
Sobczynska, D.;
Spanier, F.;
Stamerra, A.;
Stark, L. S.;
Takalo, L.;
Temnikov, P.;
Tescaro, D.;
Teshima, M.;
Torres, D. F.;
Turini, N.;
Vankov, H.;
Venturini, A.;
Vitale, V.;
Wagner, R. M.;
Wibig, T.;
Wittek, W.;
Zandanel, F.;
Zanin, R.;
Zapatero, J.;
.
Submitted: 2007-09-24, last modified: 2007-12-10
The MAGIC Project: Contributions to ICRC 2007, Merida, Mexico. Contents pages
for the Contribution on behalf of the MAGIC Collaboration to the 30th ICRC that
took place in July 2007 in Merida, Mexico. The contents are in html form with
clickable links to the papers that exist on the Astrophysics archive. We hope
that this will make it easier to access the output of the conference in a
systematic way. Comments on how useful this is/ how it could be improved should
be sent to michela.demaria@iuav.it.
[5]
oai:arXiv.org:0709.1372 [pdf] - 4761
The reflecting surface of the MAGIC-II Telescope
Bastieri, D.;
Arnold, J.;
Baixeras, C.;
Citterio, O.;
Dazzi, F.;
De Lotto, B.;
Doro, M.;
Ghigo, M.;
Giro, E.;
Goebel, F.;
Kosyra, R.;
Lorenz, E.;
Mariotti, M.;
Mirzoyan, R.;
Paoletti, R.;
Pareschi, G.;
Pascoli, D.;
Pepato, A.;
Peruzzo, L.;
Saggion, A.;
Sartori, P.;
Sillanpää, A.
Submitted: 2007-09-10
The MAGIC Collaboration is building a second telescope, MAGIC II, improving
the design of the current MAGIC Telescope. MAGIC II is being built at 85 m of
distance from MAGIC I, and will also feature a huge reflecting surface of ~240
m$^2$ of area. One of the improvement is the design for the mirror of MAGIC II,
that are lighter and larger, being square of 1 m of side and weighting around
15 kg. For the development and production of the new mirrors, two different
techniques, both reliable and affordable in price, were selected: the diamond
milling of aluminium surfaces and the cold slumping of thin glass panes. As
tests for the second one are still ongoing, we present a description of the
diamond milling technique, and its application and performance to the produced
mirrors.