Normalized to: Kok, J.
[1]
oai:arXiv.org:1311.0661 [pdf] - 1263835
Flux saturation length of sediment transport
Submitted: 2013-11-04
Sediment transport along the surface drives geophysical phenomena as diverse
as wind erosion and dune formation. The main length-scale controlling the
dynamics of sediment erosion and deposition is the saturation length
$L_\mathrm{s}$, which characterizes the flux response to a change in transport
conditions. Here we derive, for the first time, an expression predicting
$L_\mathrm{s}$ as a function of the average sediment velocity under different
physical environments. Our expression accounts for both the characteristics of
sediment entrainment and the saturation of particle and fluid velocities, and
has only two physical parameters which can be estimated directly from
independent experiments. We show that our expression is consistent with
measurements of $L_\mathrm{s}$ in both aeolian and subaqueous transport regimes
over at least five orders of magnitude in the ratio of fluid and particle
density, including on Mars.
[2]
oai:arXiv.org:1201.4353 [pdf] - 565645
The physics of wind-blown sand and dust
Submitted: 2012-01-20, last modified: 2012-09-20
The transport of sand and dust by wind is a potent erosional force, creates
sand dunes and ripples, and loads the atmosphere with suspended dust aerosols.
This article presents an extensive review of the physics of wind-blown sand and
dust on Earth and Mars. Specifically, we review the physics of aeolian
saltation, the formation and development of sand dunes and ripples, the physics
of dust aerosol emission, the weather phenomena that trigger dust storms, and
the lifting of dust by dust devils and other small-scale vortices. We also
discuss the physics of wind-blown sand and dune formation on Venus and Titan.
[3]
oai:arXiv.org:1002.1346 [pdf] - 122620
Difference in the wind speeds required for initiation versus
continuation of sand transport on Mars: Implications for dunes and dust
storms
Submitted: 2010-02-05, last modified: 2010-02-19
Much of the surface of Mars is covered by dunes, ripples, and other features
formed by the blowing of sand by wind, known as saltation. In addition,
saltation loads the atmosphere with dust aerosols, which dominate the Martian
climate. We show here that saltation can be maintained on Mars by wind speeds
an order of magnitude less than required to initiate it. We further show that
the resulting hysteresis effect causes saltation to occur for much lower wind
speeds than previously thought. These findings have important implications for
the formation of dust storms, sand dunes, and ripples on Mars.
[4]
oai:arXiv.org:1001.4840 [pdf] - 33214
Analytical calculation of the minimum wind speed required to sustain
wind-blown sand on Earth and Mars
Submitted: 2010-01-26
The wind-driven hopping motion of sand grains, known as saltation, forms
dunes and ripples and ejects fine dust particles into the atmosphere on both
Earth and Mars. While the wind speed at which saltation is initiated, the fluid
threshold, has been studied extensively, the wind speed at which it is halted,
the impact threshold, has been poorly quantified for Mars conditions. We
present an analytical model of the impact threshold, which we show to be in
agreement with measurements and recent numerical simulations for Earth
conditions. For Mars conditions, we find that the impact threshold is
approximately an order of magnitude below the fluid threshold, in agreement
with previous studies. Saltation on Mars can thus be sustained at wind speeds
an order of magnitude less than required to initiate it, leading to the
occurrence of hysteresis. These results confirm earlier simulations with a
detailed numerical saltation model, and have important implications for the
formation of sand dunes, ripples, and dust storms on Mars.