Remarkable progress has been made in understanding turbulent astrophysical plasmas in past decades including, notably, the solar wind and the interstellar medium. In the case of the solar wind, much of this progress has relied on in situ measurements from space-borne instruments. However, ground-based radio observations also have played a significant role and have the potential to play an even bigger role. In particular, using distant background sources (quasars, pulsars, satellite beacons) to transilluminate the foreground corona and solar wind, a variety of radio propagation phenomena can be used to map plasma properties of the solar corona and heliosphere, as well as the warm interstellar medium. These include angular broadening, interplanetary and interstellar scintillations, and differential Faraday rotation. These observations are highly complementary to in situ observations of the solar wind, and could be a mainstay of investigations into turbulence of the ISM. We point out that the Next Generation Very Large Array (ngVLA) fulfills all the requirements necessary to exploit radio observations of astrophysical turbulence fully.

In this work we use solar observations with the ALMA radio telescope at the wavelength of 1.21 mm. The aim of the analysis is to improve understanding of the solar chromosphere, a dynamic layer in the solar atmosphere between the photosphere and corona. The study has an observational and a modeling part. In the observational part full-disc solar images are analyzed. Based on a modified FAL atmospheric model, radiation models for various observed solar structures are developed. Finally, the observational and modeling results are compared and discussed.

Various solar features can be seen on maps of the Sun in the mm and sub-mm wavelength range. The recently installed Atacama Large Millimeter/submillimeter Array (ALMA) is capable of observing the Sun in that wavelength range with an unprecedented spatial, temporal and spectral resolution. To interpret solar observations with ALMA the first important step is to compare ALMA maps with simultaneous images of the Sun recorded in other spectral ranges. First we identify different structures in the solar atmosphere seen in the optical, IR and EUV parts of the spectrum (quiet Sun (QS), active regions (AR), prominences on the disc, magnetic inversion lines (IL), coronal holes (CH) and coronal bright points (CBPs)) in a full disc solar ALMA image. The second aim is to measure the intensities (brightness temperatures) of those structures and compare them with the corresponding QS level. A full disc solar image at 1.21 mm obtained on December 18, 2015 during a CSV-EOC campaign with ALMA is calibrated and compared with full disc solar images from the same day in H\alpha, in He I 1083 nm core, and with SDO images (AIA at 170 nm, 30.4 nm, 21.1 nm, 19.3 nm, and 17.1 nm and HMI magnetogram). The brightness temperatures of various structures are determined by averaging over corresponding regions of interest in the ALMA image. Positions of the QS, ARs, prominences on the disc, ILs, CHs and CBPs are identified in the ALMA image. At 1.21 mm ARs appear as bright areas (but sunspots are dark), while prominences on the disc and CHs are not discernible from the QS background, although having slightly less intensity than surrounding QS regions. ILs appear as large, elongated dark structures and CBPs correspond to ALMA bright points. These results are in general agreement with sparse earlier measurements at similar wavelengths. The identification of CBPs represents the most important new result.

The Atacama Large Millimeter-submillimeter Array (ALMA) radio telescope has commenced science observations of the Sun starting in late 2016. Since the Sun is much larger than the field of view of individual ALMA dishes, the ALMA interferometer is unable to measure the background level of solar emission when observing the solar disk. The absolute temperature scale is a critical measurement for much of ALMA solar science, including the understanding of energy transfer through the solar atmosphere, the properties of prominences, and the study of shock heating in the chromosphere. In order to provide an absolute temperature scale, ALMA solar observing will take advantage of the remarkable fast-scanning capabilities of the ALMA 12m dishes to make single-dish maps of the full Sun. This article reports on the results of an extensive commissioning effort to optimize the mapping procedure, and it describes the nature of the resulting data. Amplitude calibration is discussed in detail: a path that utilizes the two loads in the ALMA calibration system as well as sky measurements is described and applied to commissioning data. Inspection of a large number of single-dish datasets shows significant variation in the resulting temperatures, and based on the temperature distributions we derive quiet-Sun values at disk center of 7300 K at lambda=3 mm and 5900 K at lambda=1.3 mm. These values have statistical uncertainties of order 100 K, but systematic uncertainties in the temperature scale that may be significantly larger. Example images are presented from two periods with very different levels of solar activity. At a resolution of order 25 arcsec, the 1.3 mm wavelength images show temperatures on the disk that vary over about a 2000 K range.

Observations of the Sun at millimeter and submillimeter wavelengths offer a unique probe into the structure, dynamics, and heating of the chromosphere; the structure of sunspots; the formation and eruption of prominences and filaments; and energetic phenomena such as jets and flares. High-resolution observations of the Sun at millimeter and submillimeter wavelengths are challenging due to the intense, extended, low- contrast, and dynamic nature of emission from the quiet Sun, and the extremely intense and variable nature of emissions associated with energetic phenomena. The Atacama Large Millimeter/submillimeter Array (ALMA) was designed with solar observations in mind. The requirements for solar observations are significantly different from observations of sidereal sources and special measures are necessary to successfully carry out this type of observations. We describe the commissioning efforts that enable the use of two frequency bands, the 3 mm band (Band 3) and the 1.25 mm band (Band 6), for continuum interferometric-imaging observations of the Sun with ALMA. Examples of high-resolution synthesized images obtained using the newly commissioned modes during the solar commissioning campaign held in December 2015 are presented. Although only 30 of the eventual 66 ALMA antennas were used for the campaign, the solar images synthesized from the ALMA commissioning data reveal new features of the solar atmosphere that demonstrate the potential power of ALMA solar observations. The ongoing expansion of ALMA and solar-commissioning efforts will continue to enable new and unique solar observing capabilities.

Small scale flare-like brightenings around active regions are among the smallest and most fundamental of energetic transient events in the corona, providing a testbed for models of heating and active region dynamics. In a previous study, we modeled a large collection of these microflares observed with Hinode/XRT using EBTEL and found that they required multiple heating events, but could not distinguish between multiple heating events on a single strand, or multiple strands each experiencing a single heating event. We present here a similar study, but with EUV data of Active Region 11520 from the High Resolution Coronal Imager (Hi-C) sounding rocket. Hi- C provides an order of magnitude improvement to the spatial resolution of XRT, and a cooler temperature sensitivity, which combine to provide significant improvements to our ability to detect and model microflare activity around active regions. We have found that at the spatial resolution of Hi-C (approximately 0.3 arcseconds), the events occur much more frequently than expected (57 events detected, only 1 or 2 expected), and are most likely made from strands of order 100 km wide, each of which is impulsively heated with multiple heating events. These findings tend to support bursty reconnection as the cause of the energy release responsible for the brightenings.

Strong evidence exists that coronal loops as observed in EUV and soft X-rays may not be monolithic isotropic structures, but can often be more accurately modeled as bundles of independent strands. Modeling the observed active region transient brightenings (ARTBs) within this framework allows exploration of the energetic ramifications and characteristics of these stratified structures. Here we present a simple method of detecting and modeling ARTBs observed with the Hinode/X-Ray Telescope (XRT) as groups of 0-dimensional strands, which allows us to probe parameter space to understand better the spatial and temporal dependence of strand heating in impulsively heated loops. This partially automated method can be used to analyze a large number of observations to gain a statistical insight into the parameters of coronal structures including the number of heating events required in a given model to fit the observations. In this article we present the methodology, and demonstrate its use in detecting and modeling ARTBs in a sample data set from Hinode/XRT. These initial results show that in general, multiple heating events are necessary to reproduce observed ARTBs, but the spatial dependence of these heating events could not yet be established.

The X-Ray Telescope (XRT) onboard the Hinode satellite, launched 23 September 2006 by the Japanese Aerospace Exploration Agency (JAXA) is a joint mission between Japan, the United States, and the United Kingdom to study the solar corona. In particular XRT was designed to study solar plasmas with temperatures between 1 and 10 MK with $\approx1''$ pixels ($\approx2''$ resolution). Prior to analysis, the data product from this instrument must be properly calibrated and data values quantified in order to assess accurately the information contained within. We present here the standard methods of calibration for these data. The calibration is performed on an empirical basis which uses the least complicated correction that accurately describes the data while suppressing spurious features. By analyzing the uncertainties remaining in the data after calibration, we conclude that the procedure is successful, as the remaining uncertainty after calibration is dominated by photon noise. This calibration software is available in the Solar Soft software library.

We present multi-color transformations and photometric parallaxes for a sample of 40 low mass dwarfs selected from the Sloan Digital Sky Survey (SDSS) and the General Catalog of Trigonometric Stellar Parallaxes. Our sample was re-observed at the Manastash Ridge Observatory (MRO) using both Sloan and Johnson-Cousin filters and color transformations between the two photometric systems were derived. A subset of the sample had previously measured Johnson-Cousins photometry and parallaxes as well as 2MASS photometry. We observed these stars at MRO using Sloan filters and used these data to derive photometric parallax relations as well as SDSS/Johnson-Cousins/2MASS color transformations. We present the data and derived transformations for use in future low mass star studies.