The optical behaviour of the Be star in the high mass X-ray transient A0535+26/HDE245770 shows that at the periastron typically there is an enhancement in the luminosity of order 0.02 to few tenths mag, and the X-ray outburst happens about 8 days after the periastron. We construct a quantitative model of this event, basing on the a nonstationary accretion disk behavior, connected with a high ellipticity of the orbital motion. The ephemeris used in this paper -- JD$_{\rm opt-outb}$ = JD$_0$(2,444,944) $\pm$ n(111.0 $\pm$ 0.4) days are derived from the orbital period of the system P$_{\rm orb} = 111.0 \pm 0.4$ days, determined by Priedhorsky & Terrell (1983), and from the optical flare of December 5, 1981 (Giovannelli et al., 1985) (here after 811205-E; E stands for the Event occurred at that date) that triggered the subsequent X-ray outburst of December 13, 1981 (Nagase et al., 1982) (here after 811213-E). We explain the observed time delay between the peaks of the optical and X-ray outbursts in this system by the time of radial motion of the matter in the accretion disk, after an increase of the mass flux in the vicinity of a periastral point in the binary. This time is determined by the turbulent viscosity, with the parameter $\alpha=0.1-0.3$. The increase of the mass flux is a sort of flush that reaches the external part of the accretion disk around the neutron star, producing an enhancement in the optical luminosity. The consequent X-ray flare happens when the matter reaches the hot central parts of the accretion disk, and the neutron star surface.

We discuss the problem of the formation of a large-scale magnetic field in the accretion disks around black holes, taking into account the non-uniform vertical structure of the disk. The high electrical conductivity of the outer layers of the disk prevents the outward diffusion of the magnetic field. This implies a stationary state with a strong magnetic field in the inner parts of the accretion disk close to the black hole, and zero radial velocity at the surface of the disk. Structure of advective accretion disks is investigated, and conditions for formation of optically thin regions in central parts of the accretion disk are found. The problem of jet collimation by magneto-torsion oscillations is considered.

The problem of steady-state accretion to nonrotating black holes is examined. Advection is included and generalized formulas for the radiation pressure in both the optically thick and thin cases are used. Special attention is devoted to models with a high accretion rate. Global solutions for accretion disks are studied which describe a continuous transition between an optically thick outer region and an optically thin inner region. It is shown that there is a maximum disk temperature for the model with a viscosity parameter {\alpha} = 0.5. For the model with {\alpha} = 0.1, no optically thin regions are found to exist for any accretion rate.