Inelastic collisions occur among regolith particles, such as those in the ejecta curtain from a crater, and may cause clustering or agglomeration of particles and thus produce discrete patterns of ejecta deposits around a crater. Previous studies have shown that clusters, and even agglomerates, are formed via mutual, inelastic collisions of spherical particles due to adhering forces between particles in granular streams. To investigate the condition of agglomerate formation in granular streams, we conducted laboratory experiments of granular streams using both spherical and irregular, non-spherical particles. Measurements of particle adhesion in this study were performed using a centrifugal separation method, in contrast to the previous study in which atomic force microscopy (AFM) was used. This enabled simultaneous measurements of multiple particles of various shapes for a statistical analysis of the results. With similar relative velocities and adhesion values, irregular particles were found to form agglomerates much more easily than spherical particles. The axial ratio of the agglomerates of spherical particles and irregular particles was similar and was in accordance with those observed in previous laboratory studies, whereas the size of the agglomerates of irregular particles was larger than the size of spherical particles. The degree of agglomeration and the size of agglomerates can be used as an indicator of the shape or adhesive force of the particles in granular stream. Our findings on agglomeration in granular streams could provide new insights into the origin of rays on airless bodies and grooves on Phobos.

Porosity is a key characteristic of the regolith on the surface of small bodies. The porosity of the regolith on the surface of asteroids is changed by applied pressure, and the relationship between pressure and porosity depends on the particle properties of the regolith. We performed compression measurements on samples of different materials, particle size distributions, and shapes to examine the relationship between particle size and pressure required for compression. We used a centrifuge and a compression testing machine for the experiments. The applied pressure for the centrifuge and the compression testing machine experiments ranged from 10^2 to 5x10^3 Pa and from 10^4 to 5x10^6 Pa, respectively. The initial porosity before compression was generally higher for samples with smaller particles and narrower particle size distributions. A sample compressed more easily when it consisted of smaller particles, probably due to smaller frictional forces between particles. We estimated the porosity of granular asteroids based on the results of our experiments. The estimated porosity at the center of a homogeneous asteroid with a radius of 50 km is 0.43. This porosity is typical of the porosity of asteroids of similar size.