Measurements of element abundances in galaxies from astrophysical spectroscopy depend sensitively on the atomic data used. With the goal of making the latest atomic data accessible to the community, we present a compilation of selected atomic data for resonant absorption lines at wavelengths longward of 911.753 {\AA} (the \ion{H}{1} Lyman limit), for key heavy elements (heavier than atomic number 5) of astrophysical interest. In particular, we focus on the transitions of those ions that have been observed in the Milky Way interstellar medium (ISM), the circumgalactic medium (CGM) of the Milky Way and/or other galaxies, and the intergalactic medium (IGM). We provide wavelengths, oscillator strengths, associated accuracy grades, and references to the oscillator strength determinations. We also attempt to compare and assess the recent oscillator strength determinations. For about 22\% of the lines that have updated oscillator strength values, the differences between the former values and the updated ones are $\gtrsim$~0.1 dex. Our compilation will be a useful resource for absorption line studies of the ISM, as well as studies of the CGM and IGM traced by sight lines to quasars and gamma-ray bursts. Studies (including those enabled by future generations of extremely large telescopes) of absorption by galaxies against the light of background galaxies will also benefit from our compilation.

Energy levels, Land\'{e} $g$-factors and radiative lifetimes are reported for the lowest 182 levels of the 3d$^4$, 3d$^3$4s and 3d$^3$4p configurations of Fe~V, Co~VI and Ni~VII. Additionally, radiative rates ($A$-values) have been calculated for the E1, E2 and M1 transitions among these levels. The calculations have been performed in a quasi-relativistic approach (QR) with a very large {\em configuration interaction} (CI) wavefunction expansion, which has been found to be necessary for these ions. Our calculated energies for all ions are in excellent agreement with the available measurements, for most levels. Discrepancies among various calculations for the radiative rates of E1 transitions in Fe~V are up to a factor of two for stronger transitions ($f \geq 0.1$), and larger (over an order of magnitude) for weaker ones. The reasons for these discrepancies have been discussed and mainly are due to the differing amount of CI and methodologies adopted. However, there are no appreciable discrepancies in similar data for M1 and E2 transitions, or the $g$-factors for the levels of Fe~V, the only ion for which comparisons are feasible.

We report calculations of energy levels and radiative rates ($A$-values) for transitions in Cr-like Co IV and Ni V. The quasi-relativistic Hartree-Fock (QRHF) code is adopted for calculating the data although GRASP (general-purpose relativistic atomic structure package) and flexible atomic code (FAC) have also been employed for comparison purposes. No radiative rates are available in the literature to compare with our results, but our calculated energies are in close agreement with those compiled by NIST for a majority of the levels. However, there are discrepancies for a few levels of up to 3\%. The $A$-values are listed for all significantly contributing E1, E2 and M1 transitions, and the corresponding lifetimes reported, although unfortunately no previous theoretical or experimental results exist to compare with our data.

We describe a new atomic and molecular database we developed for use in the spectral synthesis code Cloudy. The design of Stout is driven by the data needs of Cloudy, which simulates molecular, atomic, and ionized gas with kinetic temperatures 2.8 K < T < 1e10 K and densities spanning the low to high-density limits. The radiation field between photon energies $10^{-8}$ Ry and 100 MeV is considered, along with all atoms and ions of the lightest 30 elements, and ~100 molecules. For ease of maintenance, the data are stored in a format as close as possible to the original data sources. Few data sources include the full range of data we need. We describe how we fill in the gaps in the data or extrapolate rates beyond their tabulated range. We tabulate data sources both for the atomic spectroscopic parameters and for collision data for the next release of Cloudy. This is not intended as a review of the current status of atomic data, but rather a description of the features of the database which we will build upon.

Damped Lyman-alpha (DLA) and sub-DLA absorbers in quasar spectra provide the most sensitive tools for measuring element abundances of distant galaxies. Estimation of abundances from absorption lines depends sensitively on the accuracy of the atomic data used. We have started a project to produce new atomic spectroscopic parameters for optical/UV spectral lines using state-of-the-art computer codes employing very broad configuration interaction basis. Here we report our results for Zn II, an ion used widely in studies of the interstellar medium (ISM) as well as DLA/sub-DLAs. We report new calculations of many energy levels of Zn II, and the line strengths of the resulting radiative transitions. Our calculations use the configuration interaction approach within a numerical Hartree-Fock framework. We use both non-relativistic and quasi-relativistic one-electron radial orbitals. We have incorporated the results of these atomic calculations into the plasma simulation code Cloudy, and applied them to a lab plasma and examples of a DLA and a sub-DLA. Our values of the Zn II {\lambda}{\lambda} 2026, 2062 oscillator strengths are higher than previous values by 0.10 dex. Cloudy calculations for representative absorbers with the revised Zn atomic data imply ionization corrections lower than calculated before by 0.05 dex. The new results imply Zn metallicities should be lower by 0.1 dex for DLAs and by 0.13-0.15 dex for sub-DLAs than in past studies. Our results can be applied to other studies of Zn II in the Galactic and extragalactic ISM.

Absorption-line spectroscopy is a powerful tool used to estimate element abundances in the nearby as well as distant universe. The accuracy of the abundances thus derived is, naturally, limited by the accuracy of the atomic data assumed for the spectral lines. We have recently started a project to perform the new extensive atomic data calculations used for optical/UV spectral lines in the plasma modeling code Cloudy using state-of-the-art quantal calculations. Here we demonstrate our approach by focussing on S II, an ion used to estimate metallicities for Milky Way interstellar clouds as well as distant damped Lyman-alpha (DLA) and sub-DLA absorber galaxies detected in the spectra of quasars and gamma-ray bursts (GRBs). We report new extensive calculations of a large number of energy levels of S II, and the line strengths of the resulting radiative transitions. Our calculations are based on the configuration interaction approach within a numerical Hartree-Fock framework, and utilize both non-ralativistic and quasirelativistic one-electron radial orbitals. The results of these new atomic calculations are then incorporated into Cloudy and applied to a lab plasma, and a typical DLA, for illustrative purposes. The new results imply relatively modest changes (~0.04 dex) to the metallicities estimated from S II in past studies. These results will be readily applicable to other studies of S II in the Milky Way and other galaxies.

The Fe unresolved transition array (UTAs) produce prominent features in the 15-17?A wavelength range in the spectra of Active Galactic Nuclei (AGN). Here we present new calculations of the energies and oscillator strengths of inner- shell lines from Fe XIV, Fe XV, and Fe XVI. These are crucial ions since they are dominant at inflection points in the gas thermal stability curve, and UTA excitation followed by autoionization is an important ionization mechanism for these species. We incorporate these, and data reported in previous papers, into the plasma simulation code Cloudy. This updated physics is subsequently employed to reconsider the thermally stable phases in absorbing media in Active Galactic Nuclei. We show how the absorption profile of the Fe XIV UTA depends on density, due to the changing populations of levels within the ground configuration.

Effective collision strengths for forbidden transitions among the 5 energetically lowest finestructure levels of O II are calculated in the Breit-Pauli approximation using the R-matrix method. Results are presented for the electron temperature range 100 to 100 000 K. The accuracy of the calculations is evaluated via the use of different types of radial orbital sets and a different configuration expansion basis for the target wavefunctions. A detailed assessment of previous available data is given, and erroneous results are highlighted. Our results reconfirm the validity of the original Seaton and Osterbrock scaling for the optical O II ratio, a matter of some recent controversy. Finally we present plasma diagnostic diagrams using the best collision strengths and transition probabilities.